LITE ON TECHNOLOGY MW0100R Low Power Wi-Fi Module User Manual
LITE-ON Technology Corp. Low Power Wi-Fi Module
User manual
PRODUCT SPECIFICATION MW0100R Low Power Wi‐Fi Module Version 1.1 Author : Rocky CC Chen Project Leader: Editor : Approved by: Change History Revision 1.0 1.1 Date May 5th, 2015 May 25th, 2015 Author Rocky CC Chen Rocky CC Chen Change List Draft Update Tx, Rx and power consumption * This document contains confidential proprietary information and is property of LTC. The contents of this document should not be disclosed to unauthorized persons without the written consent of LTC. MW0100R Product Specification Page 1/9 LTC Network Access Confidential CONTENT 1. PRODUCT OVERVIEW ...................................................................................................................... 3 1.1 DESCRIPTION.............................................................................................................................. 3 1.2 FEATURES ................................................................................................................................... 3 1.3 GENERAL 1.4 BLOCK DIAGRAM ....................................................................................................................... 5 SPECIFICATIONS ...................................................................................................... 3 2. PIN ASSIGNMENT AND DESCRIPTION ............................................................................................. 5 3. RECOMMENDED FOOTPRINT ..................................................................... 錯誤! 尚未定義書籤。 MW0100R Product Specification Page 2/9 LTC Network Access Confidential 1. Product Overview 1.1 Description MW0100R is Low Power Wi‐Fi Module uses IEEE 802.11 b/g/n standard to network the low‐power mobile application on Apple HomeKit platform. It also integrates ARM‐Cortex M3 MCU, WLAN MAC, 1T1R capable WLAN baseband, internal memories and PCB Antenna. Developers can be benefit from the quick‐installed module without RF expertise to enter HomeKit application market. 1.2 Features Apple HomeKit Compatible IEEE 802.11 b/g/n (1x1) for up to 150Mbps SoC with MCU and WLAN IC Lower power consumption On‐board printed antenna RF feed point, optional external antenna u.fl connector, optional external antenna Operating temp: 0~70 oC Total 33‐pin Stamp Holes, SMT Type A form factor: 24x17mm 1.3 General Specifications WLAN SoC Realtek RTL8711AM CPU ARM Cortex M3 (166MHz) RAM/Flash 64KB+448KB/1MB (external) Frequency Range 2.412GHz ~ 2.4835GHz, ISM band Frequency Band Data Rate IEEE 802.11 b/g/n, Wi‐Fi compliant 11 for North America, 13 for CE, 14 for Japan 802.11 b:1, 2, 5.5, 11Mbps 802.11g: 6, 9, 12, 18, 24, 36, 48, 54Mbps 802.11 n(20MHz, normal GI, 800ns):6.5, 13, 19.5, 26, 39, 52, 58.5, 65MHz 802.11 n(20MHz, short GI, 400ns):7.2, 14.4, 21.7, 28.9, 43.3, 57.8, 65, 72.2 MHz Power Amplify Internal Transmit Power 802.11b /11Mbps: 17dBm ± 1dB 802.11g /54Mbps: 15dBm ± 1dB 802.11n /65Mbps: 14dBm ± 1dB Receiver Sensitivity 802.11n MW0100R Product Specification Page 3/9 LTC Network Access Confidential Power Consumption MCS=7 PER @ ‐85dBm ± 1dB 802.11g 54Mbps PER @ ‐75dBm ± 1dB 802.11b 11Mbps PER @ ‐70dBm ± 1dB Deep Sleep: 0.04mW Idle: 8.2mW Rn in Active Clock: 56mW 11n RX Mode: 237mW 11n TX Mode: 690mW Network features TCP, UDP, DHCP, ARP, HTTP, SSL, and DNS Encryption Supports IEEE 802.11 WEP, WPA, WPA2 Security Serial Data Interface I2C ,UART,SPI Antenna Printing ANT or EXT ANT Operating Temperature 0 oC ~70 oC Dimensions 24mm x17mm Power Requirements 3.3V Certification & Environmental Requirements HomeKit FCC/IC/CE Wi‐Fi RoHS MW0100R Product Specification Page 4/9 LTC Network Access Confidential 1.4 Block Diagram 2. Pin Assignment and Description Pin Number NC NC PIO_4 NC NC Pin Description Ground Ground SPI_MISO when pin25 is H. GPIO8 when pin25 is L. SPI_CLK when pin25 is H. GPIO5 when pin25 is L. NC NC GPIO4 NC NC 10 PIO_10 GPIO10 ‐‐ ‐‐ I/O ‐‐ ‐‐ I/O 11 12 13 14 PIO_11 GPIO11 I/O GND VDD PIO_9 Ground Power Source for Module GPIO9 I/O Pin Name GND GND PIO_8_MISO PIO_5_CLK MW0100R Product Specification Page 5/9 LTC Network Access Confidential I/O I/O I/O 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 PIO_8_MISO NC NC PIO_3 PIO_0/UART_TX PIO_1/UART_RX PIO_6_CS NC NC PIO_7_MOSI SPI_PIO#_SEL WAKEUP NC AIO_2 AIO_1 AIO_0 GND RF GND SPI_MISO when pin25 is H. GPIO8 when pin25 is L. I/O NC NC GPIO3 GPIO0 or UART_Tx GPIO1 or UART_Rx SPI_CS when pin25 is H. GPIO6 when pin25 is L. NC NC SPI_MOSI when pin25 is H. GPIO7 when pin25 is L. H to select GPIO5~8 for SPI(Debug use) L to select programmable GPIO L to wake module from hibernate or dormant NC AIO_2(Voltage not exceed to 1.35V) AIO_1(Voltage not exceed to 1.35V) AIO_0(Voltage not exceed to 1.35V) Ground RF feed point. Connect to Antenna Ground ‐‐ ‐‐ I/O I/O I/O I/O Liteon Type A module MW0100R Product Specification Page 6/9 LTC Network Access Confidential ‐‐ ‐‐ I/O I/O I/O ‐‐ I/O I/O I/O 3. Recommended FootPrint FCC FEDERAL COMMUNICATIONS COMMISION (FCC) STATEMENT 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. MW0100R Product Specification Page 7/9 LTC Network Access Confidential -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference and 2) This device must accept any interference received, including interference that may cause undesired operation of the device. FCC RF Radiation Exposure Statement: 1. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. End Product Labeling: The final end product must be labeled in a visible area with the following: “Contains FCC ID:PPQ-MW0100R” Canada, Industrie Canada (IC) This Class B digital apparatus complies with Canadian ICES-003 Cet appareil numérique de classe B est conforme à la norme NMB-003. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the Le présent appareil est conforme aux CNR d'Industrie Canada applicables auxappareils radio exempts de licence.L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage adioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. End Product Labeling: The final end product must be labeled in a visible area with the following: “Contains IC ID:4491A-MW0100R” Note: MW0100R Product Specification Page 8/9 LTC Network Access Confidential This radio transmitter has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Antenna Type: PCB PIFA Antenna Peak Gain: 2.55dBi Page 9/9 MW0100R Product Specification LTC Network Access Confidential
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Author : Karen_Huang Create Date : 2015:12:18 10:16:29+08:00 Modify Date : 2015:12:18 13:17:35+08:00 XMP Toolkit : Adobe XMP Core 5.6-c015 81.157285, 2014/12/12-00:43:15 Creator Tool : PScript5.dll Version 5.2.2 Metadata Date : 2015:12:18 13:17:35+08:00 Format : application/pdf Title : Microsoft Word - LiteOn_MW0100R_PRD_Low Power_WiFi_1V1.doc Creator : Karen_Huang Producer : Acrobat Distiller 15.0 (Windows) Document ID : uuid:3d0df979-cce7-4ba1-b822-af0ad61b3707 Instance ID : uuid:d90c9d83-40ae-4d5e-9388-79079f539bfb Page Count : 9EXIF Metadata provided by EXIF.tools