Leedarson Lighting RC4X1WN-A9 Remote control User Manual

LEEDARSON LIGHTING CO., LTD. Remote control Users Manual

Users Manual

Dim/CCT+Status Indicator:Program ButtonRemote is in Standby mode or Selected Group is OFF(slow)(fast)Selected Group is ONFinding Network Channel(when batteries are inserted)Commisioning a bulbRemoteControl & Connected BulbUser Guide1.Commissioning (Pairing) Light(s)Commissioning (Pairing) Light(s): Follow instruction below to commission new smart light(s). In case you buy new smart light(s)or the current smart light(s) are set to Factory Default. Light(s) (Factory Default) must start OnWith your RemoteRestarted by wall switchSuccessfully paired to RemoteLight(s) blinks twiceOnce commissioned to aremote, it’s no longer visible to other remotesIn case of a time-out,the light(s) will turnoff the radio and become a standard non-controllable light(s)FailPress and hold one of the groupbutton for 3s that you want thelight(s) to join.Remote control gets close to light about 10 cm distance for touch link. 3.Group Selection2.Unpairing light(s)Press the group selection button to select the group(s) you want to control.Press group all key “1-2” + red program button for 3 seconds that you want the light(s) to unpair. Remote control gets close to light about 10 cm distance for touch link. Bulb(s) could be restored to factory default status either by remote or by wall switch. Factory default by remote is same as un -pairingBulb(s), while by wall switch is as following.ResetingBulb(s)Starting fromwall switch OFFLight(s) finishes Onon 1 secondoff 2 secondson 1 secondoff 2 secondson 1 secondoff 2 secondsn 1 secondff 2 secondsn 1 secondff 2 secondsooooonUser flips the wall switch off and on 5x over between 1-2 secondsFactory DefaultUser connects light(s)to new network(remote)Or after 5 minLight(s) added to device list as newBlinks twiceNetwork close Restored to factory default by switchRestarted by wall switch4.ON/OFFON/OFF: Every single press turns all the lights in selected group(s) ON or OFF gradually.5.Dimming6.Reset remote control to factory defaultDimming: Dim the light(s) in selected group(s).UP/DOWN button:Every press: dims the lumen step by step until max./min.Keep pressing: dims until max./min. in one time.Remark: There are totally 13 brighness diming levelCCT button:Every press: adjusts the CCT step by step until max./min(for RGBW ver. remote)Keep pressing: adjusts the CCT until max./min. in one time(for RGBW ver. remote)Press “ON/OFF” key + red program button for 3 seconds. The remote control will be reset to factory default. Group 1 Group 2All GroupsCCTW / DIMOn/offRGBWDim+On/offshift function betweendim and CCTDim/CCT-RGB-Quick DimDim-CCT- CCT+Group 2Group 1Group All Group 1RGB+Group 2Group All Dim upDim downQuick toggling between highestand lowest dimming level & toggling CCT (for RGBW version)10s2s 2s1s 1s 1s 1s 1s 10s2s 2s 2s 2sONOFF
FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Navigation menu