Lelux Electronics 502R WIRELESS REMOTE CONTROL User Manual 500R homesafe blister
Lelux Electronics Ltd WIRELESS REMOTE CONTROL 500R homesafe blister
Users Manual
Model 502R
Wireless Remote
Notes for remote operation
•
The Home mode function for 820s only.
•
If radio linked remote control operation range become
shorten,
replace the batteries according to "BATTERIES
REPLACEMENT".
•
The battery life should be about six months under normal
use, so replace battery at least every 6 months.
•
Effective range about 15~30 meters.
ay cause undesired
operation of the device.
FCC COMPLIANCE STATEMENT
1. This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment
1.Battery install and replacement (Battery CR2032)
a. Remove the battery compartment cover by sliding it in
the direction of the arrow.
b. Replace with new batteries of the
same type.
Make sure the polarity (+ or -) of
the batteries match the polarity
marks inside the unit. As shown
below (Fig. 1)
c. Replace battery cover.
(Fig.1)
size: 80x120mm
p/n:610-50200-00xR
white paper print black words
610-50200-00xR
Model T015S
Model T018S
Model T016S
1
4
7
*/ UP
2
5
8
0
3
6
9
PROG
PAUSE
ARM/
DISARM
PANIC
/DOWN
Model T068S
AC.POWER
GSM
PSTN
REC.
1 2 3
4 5 6
7 8 9
HOME
REC./
PLAY
DEL./
PAUSE
ARM/
DISARM
0
PROG
PANIC
Model 820S Model 625R
Model T056S
BATT.
LOW
1
4
7
/ UP
2
5
8
0
3
6
9
PROG
DEL./
PAUSE
/DOWN
PANIC
ARM/
DISARM
AC
BAT.LOW AC
Model 527SL
Model T055S
BATT.
LOW
1
4
7
/ UP
2
5
8
0
3
6
9
PROG
DEL./
PAUSE
/DOWN
PANIC
ARM/
DISARM
AC
The wireless remote control compatible T015S, T016S,
T055S, T056S, T018S, T068S, 639S, 820S, 526F, 526L,
625R, 527SL, 527SF main unit, must learn code to main unit
then use. learn code operation see main unit manual.
Model :526L Model :639s
ARM
POWER/
B A T T . LOW
LEARNING CODE TO MAIN UNIT
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
2. This device complies with Part 15 of the FCC Rules and
with RSS-210 of Industry Canada. Operation is subject
to the following two conditions:
a. This device may not cause harmful interference, and
b. This device must accept any interference received,
including interference that may cause undesired
operation.
3. Changes or modifications to this unit not exspressly
approved by the party responsible for compliance will
void the user’s authority to operate the equipment.
Any change to the equipment will void FCC grant.