Lennox Hearth Adk22Cmbs Users Manual
ADK45CPB to the manual bd91f999-8b88-46cd-b5b9-3a73174d37cc
2015-02-04
: Lennox-Hearth Lennox-Hearth-Adk22Cmbs-Users-Manual-371137 lennox-hearth-adk22cmbs-users-manual-371137 lennox-hearth pdf
Open the PDF directly: View PDF 
.
Page Count: 2
| Download | |
| Open PDF In Browser | View PDF |
LENNOX HEARTH PRODUCTS KITS AND ACCESSORIES ARCH DOOR KITS WITH BRASS OR BRUSHED STAINLESS STEEL TRIM P/N 750,021M REV. E 03/2008 INSTALLATION INSTRUCTIONS FOR ARCH DOOR KITS WITH BRASS OR BRUSHED STAINLESS STEEL TRIM FOR USE WITH MERIT™, MERIT PLUS™, OR ElITE® Series gas fireplaces KIT CONTENTS: TOOLS REQUIRED: 1 ea. Arched Door 1 ea. Instruction Sheet None GENERAL INFORMATION These arch door kits may be used with gas fireplace models listed in Tables 1 & 2. CAUTION INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD! Step 6. Open the glass door latche(s) located underneath the firebox. Step 7. Remove the door from the fireplace by swinging the bottom of the door outward and lifting it up and away. Step 8. Center the arch door over the glass frame as shown in Figure 1. Press the arch door onto the glass frame and bend the four corner tabs into the frame’s U-channel as shown in Figure 2. CAT. NO. MODEL 81L34 ADK35CPB EDV3530, ED3530 81L35 ADK40CPB EDV4035, ED4035-2, LMDV-4035, SSDV-4035, MPD4035, EDVST, EDST-2, EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL, EDCL-2, EBST-2, EBVPF, EBPF-2, EBVCR, EBCR-2, EBVCL, EBCL-2 81L36 ADK45CPB EDV4540, ED4540-2, MPD4540 81L37 ADK24CPB EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL, EDCL-2, EBVPF, EBPF-2, EBVCR, EBCR-2, EBVCL, EBCL-2 98L05 ADK33CPB MDR3328, MDT3328, MPDT3328, MPDR3328, LMDVR-3328 26M43 ADK35CMPB MPD3530, MPD35ST, MPD35PF, MPB35ST, LMDV-3530, ssDV-3530 H7026 ADK22CMPB MPD35PF INSTALLATION INSTRUCTIONS Part A: Elite Series Fireplaces Step 1. Slightly lift and pull the existing top radiant panel/hood assembly away from the fireplace, or pull hood and slightly lift and pull the existing louver assembly away from the fireplace. Step 2. Lift and pull the existing top and bottom bustle away from the fireplace. Step 3. Open the bottom compartment door (either a radiant panel or louver assembly) by pushing in simultaneously the left and right top corners of the door (the door is hinged at the bottom). Step 4. Remove the bottom compartment door by sliding the hinge pin, located at the door’s left side, to the right until it disengages from the left corner post hole. Pull the door diagonally to the left, away from the fireplace. Step 5. Remove the modesty panel as follows: lift the modesty panel by the tab on the panel’s right end, pull the right end of the panel away from cabinet and then pull the panel diagonally out of the corner post slots on the left side of the unit. Remove the modesty panel carefully, so that none of the wires become loose or disconnected. Table 1 - Arch Door Kit with Brass Trim CAT. NO. MODEL 98L68 ADK35CBS EDV3530, ED3530 98L69 ADK40CBS EDV4035, ED4035-2, LMDV-4035, SSDV-4035, MPD4035, EDVST, EDST-2, EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL, EDCL-2, EBST-2, EBVPF, EBPF-2, EBVCR, EBCR-2, EBVCL, EBCL-2 98L70 ADK45CBS EDV4540, ED4540-2, MPD4540 98L71 ADK24CBS EDVPF, EDPF-2, EDVCR, EDCR-2, EDVCL, EDCL-2, EBVPF, EBPF-2, EBVCR, EBCR-2, EBVCL, EBCL-2 98L62 ADK33CBS MDR3328, MDT3328, MPDT3328, MPDR3328, LMDVT-3328, LMDVR-3328 26M44 ADK35CMBS MPD3530, MPD35ST, MPD35PF, MPB35ST, LMDV-3530, ssDV-3530 H7027 ADK22CMBS MPD35PF Arched Door Glass Frame Figure 1 Corner Tabs- At The Four Corners WHERE USED WHERE USED Table 2 - Arch Door Kit with Brushed Stainless Steel Trim NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Bend The Arch Tab 90 Degrees Into The Glass Frame U-channel Inside Top Corner View of Glass and Arch Step 13. Reinstall the top radiant panel/hood assembly, or hood and louver assembly. Make certain that the hood is installed as shown in Figure 3 (clean face models) or Figure 4 (louvered models). The fireplace must not be operated without the hood installed as shown in these figures. Note - Do not reinstall the top and bottom bustle with this arch door kit installation. Keep them for any possible future re-decorating. Figure 2 Glass Frame U-Channel Part B - Merit, Merit Plus & SSDV Series Fireplaces Step 9. Position the glass door and arch assembly in front of the firebox opening with the bottom of the door held away from the fireplace. Hook the top flange of the door frame over the top of the firebox frame. Let the bottom of the door frame swing gently in towards the fireplace ensuring that the gasket seats evenly as the door frame draws shut. Fasten the two latches located underneath the firebox floor to the door’s vee-flange. Close both the latches securely. Step 1. Slightly lift and pull the existing top radiant panel/hood assembly away from the fireplace, or pull hood and slightly lift and pull the existing louver assembly away from the fireplace. Step 2. Open the bottom compartment door (either a radiant panel or louver assembly) by pushing in simultaneously the left and right top corners of the door. (The door is hinged at the bottom.) Step 10. Reinstall the modesty panel. Step 3. Open the two glass door latches located underneath the firebox. Step 11. Reinstall the bottom compartment door. Step 4. Remove the door from the fireplace by swinging the bottom of the door outward and lifting it up and away. Step 12. Close the bottom radiant panel or louver assembly. Step 5. Center the arch door over the glass frame as shown in Figure 1. Press the arch door onto the glass frame and bend the four corner tabs into the frame’s U-channel as shown in Figure 2. Top of Appliance Top Radiant Panel Step 6. Position the glass door and arch assembly in front of the firebox opening with the bottom of the door held away from the fireplace. Hook the top flange of the door frame over the top of the firebox frame. Let the bottom of the door frame swing gently in towards the fireplace ensuring that the gasket seats evenly as the door frame draws shut. Fasten the two latches located underneath the firebox floor to the door’s vee-flange. Close both the latches securely. Top of Door Frame Hood must be installed as shown. Figure 3 - Clean Face Step 7. Reinstall the top radiant panel/hood assembly or hood and louver assembly. Make certain that the hood is installed as shown in Figure 3 (clean face models) or Figure 4 (louvered models). The fireplace must not be operated without the hood installed as shown in these figures. Top of Appliance Louver Assembly Top of Door Frame Hood must be installed as shown. Step 8. Close the bottom radiant panel or louver assembly. Figure 4 - Louvered Face NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and the discontinuance of colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2001 LENNOX HEARTH PRODUCTS P/N 750,021M REV. E 03/2008 1110 West Taft Avenue • Orange, CA 92865
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : 3.1.1-111 About : 1277cb59-b662-11d9-949e-c44895a78fc8 Create Date : 2008:03:13 08:52:02-07:00 Metadata Date : 2008:03:13 08:52:04-07:00 Modify Date : 2008:03:13 08:52:04-07:00 Creator Tool : Adobe InDesign CS2 (4.0) Thumbnail Format : JPEG Thumbnail Width : 512 Thumbnail Height : 512 Thumbnail Image : (Binary data 39543 bytes, use -b option to extract) Instance ID : uuid:6d1667d1-f115-11dc-b26b-0014510d3318 Document ID : adobe:docid:indd:b279bdc9-eced-11dc-9134-ed317e0395ee Rendition Class : proof:pdf Derived From Instance ID : b279bdc8-eced-11dc-9134-ed317e0395ee Derived From Document ID : adobe:docid:indd:d1a25cc5-eaed-11dc-87eb-82929b1633d9 Manifest Link Form : ReferenceStream, ReferenceStream Manifest Placed X Resolution : 72.00, 72.00 Manifest Placed Y Resolution : 72.00, 72.00 Manifest Placed Resolution Unit : Inches, Inches Manifest Reference Instance ID : uuid:BA85C953877EDC119D4CED748C0A96CE, uuid:BA85C953877EDC119D4CED748C0A96CE Manifest Reference Document ID : uuid:B985C953877EDC119D4CED748C0A96CE, uuid:B985C953877EDC119D4CED748C0A96CE Format : application/pdf Producer : Adobe PDF Library 7.0 Trapped : False Page Count : 2 Creator : Adobe InDesign CS2 (4.0)EXIF Metadata provided by EXIF.tools