Lexmark 6500E Mfp Option Owner S Manual User's Guide
2014-07-06
: Lexmark Lexmark-Lexmark-6500E-Mfp-Option-Owner-S-Manual lexmark-lexmark-6500e-mfp-option-owner-s-manual lexmark pdf
Open the PDF directly: View PDF
Page Count: 337 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Contents
- Safety information
- Learning about the printer
- Understanding the home screen
- Customizing the home screen
- Additional printer setup
- Installing a scanner communications card in the printer
- Installing internal options in the scanner
- Installing hardware options
- Attaching cables
- Verifying printer setup
- Setting up the scanner software
- Setting up wireless printing
- Preparing to set up the scanner on an Ethernet network
- Installing the scanner on an Ethernet network
- Changing port settings after installing a new network Internal Solutions Port
- Setting up serial printing
- Minimizing your printer's environmental impact
- Loading paper and specialty media
- Paper and specialty media guidelines
- Printing
- Copying
- Making copies
- Copying film photos
- Copying on specialty media
- Customizing copy settings
- Copying to a different size
- Making copies using paper from a selected tray
- Copying different paper sizes
- Copying on both sides of the paper (duplexing)
- Reducing or enlarging copies
- Adjusting copy quality
- Collating copies
- Placing separator sheets between copies
- Copying multiple pages onto a single sheet
- Creating a custom copy job (job build)
- Pausing a print job
- Placing information on copies
- Canceling a copy job
- Understanding the copy screens and options
- E-mailing
- Faxing
- Getting the scanner ready to fax
- Initial fax setup
- Choosing a fax connection
- Connecting to an analog telephone line
- Connecting to a DSL service
- Connecting to a PBX or ISDN system
- Connecting to a distinctive ring service
- Connecting to an adapter for your country or region
- Setting the outgoing fax or station name and number
- Setting the date and time
- Configuring the scanner to observe daylight saving time
- Creating shortcuts
- Sending a fax
- Using shortcuts and the address book
- Customizing fax settings
- Canceling an outgoing fax
- Understanding fax options
- Holding and forwarding faxes
- Getting the scanner ready to fax
- Scanning to an FTP address
- Scanning to a computer or flash drive
- Understanding printer menus
- Maintaining the scanner
- Administrative support
- Clearing jams
- Troubleshooting
- The indicator light is blinking
- Understanding printer messages
- Change [paper source] to [custom type name]
- Change [paper source] to [custom string]
- Change [paper source] to [paper size]
- Change [paper source] to [paper type] [paper size]
- Check duplex connection
- Check tray [x] connection
- Close door or insert cartridge
- Close finisher side door
- Disk corrupted
- Disk full, scan job canceled
- Disk near full. Securely clearing disk space.
- Error reading USB drive. Remove USB.
- Error reading USB hub. Remove hub.
- If restarting job, replace originals that have not begun to exit the scanner
- Insert staple cartridge
- Insert Tray [x]
- Install bin [x]
- Install duplex
- Install envelope feeder
- Install Tray [x]
- Install MICR Cartridge
- Load [src] with [custom type name]
- Load [src] with [custom string]
- Load [src] with [size]
- Load [src] with [type] [size]
- Load Manual Feeder with [custom type name]
- Load Manual Feeder with [custom string]
- Load Manual Feeder with [paper size]
- Load Manual Feeder with [paper type] [paper size]
- Load staples
- Paper changes needed
- Printer and scanner not connected, check connection and restart both devices
- Reattach bin [x]
- Reattach bin [x] – [y]
- Reattach envelope feeder
- Remove packaging material, [area name]
- Remove paper from standard output bin
- Remove paper from bin [x]
- Remove paper from all bins
- Remove paper from [linked bin set name]
- Replace all originals if restarting job.
- Replace jammed originals if restarting job.
- Replace last scanned page and jammed originals if restarting job.
- Replace pick roller
- Replace wiper
- Replace separator pad
- Restore Held Jobs?
- Scan document too long
- Scanner automatic feeder cover open
- Scanner locked, release lock under scanner
- Some held jobs were not restored
- Unsupported disk
- Tray [x] paper size unsupported
- 30.xx Invalid refill, change cartridge
- 31.xx Replace defective cartridge
- 32.xx Cartridge part number unsupported by device
- 34 Incorrect paper size, open [paper source]
- 35 Insufficient memory to support Resource Save feature
- 37 Insufficient memory, some held jobs will not be restored
- 37 Insufficient memory to collate job
- 37 Insufficient memory, some Held Jobs were deleted
- 38 Memory full
- 39 Complex page, some data may not have printed
- 42.xy Cartridge region mismatch
- 51 Defective flash detected
- 52 Not enough free space in flash memory for resources
- 54 Network [x] software error
- 54 Serial option [x] error
- 54 Standard network software error
- 55 Unsupported option in slot [x]
- 56 Parallel port [x] disabled
- 56 Serial port [x] disabled
- 56 Standard USB port disabled
- 56 USB port [x] disabled
- 57 Configuration change, some held jobs were not restored
- 58 Too many bins attached
- 58 Too many disks installed
- 58 Too many flash options installed
- 58 Too many trays attached
- 59 Incompatible Duplex
- 59 Incompatible envelope feeder
- 59 Incompatible output bin [x]
- 59 Incompatible tray [x]
- 61 Remove defective disk
- 62 Disk full
- 80 Routine maintenance
- 88.xx Cartridge nearly low
- 88 Cartridge low
- 88.xx Replace cartridge
- 2yy.xx Close flatbed cover and load originals if restarting job
- 280.06 Paper missing
- 295.20 Multifeed Sensor On
- 840.01 Scanner disabled by admin
- 840.02 Scanner disabled. Contact system administrator if problem persists.
- 1565 Emulation error, load emulation option
- Solving basic printer problems
- Solving printing problems
- Multiple-language PDF files do not print
- Scanner control panel display is blank or displays only diamonds
- Error message about reading USB drive appears
- Jobs do not print
- Make sure the printer is ready to print
- Check to see if the standard exit bin is full
- Check to see if the paper tray is empty
- Make sure the correct printer software is installed
- Make sure the internal print server is installed properly and working
- Make sure you are using a recommended USB, serial, or Ethernet cable
- Make sure printer cables are securely connected
- Confidential and other held jobs do not print
- Print job takes longer than expected
- Job prints from the wrong tray or on the wrong paper
- Incorrect characters print
- Tray linking does not work
- Large jobs do not collate
- Unexpected page breaks
- Solving copy problems
- Solving scanner problems
- Solving fax problems
- Caller ID is not shown
- Cannot send or receive a fax
- Check the display for error messages
- Check the power
- Check the printer connections
- Check the telephone wall jack
- Review this digital phone service checklist
- Check for a dial tone
- Temporarily disconnect other equipment
- Check for jams
- Temporarily disable Call Waiting
- Voice Mail service may be interfering with the fax transmission
- The printer memory may be full
- Can send but not receive faxes
- Can receive but not send faxes
- Received fax has poor print quality
- Solving home screen applications problems
- Solving option problems
- Solving paper feed problems
- Solving print quality problems
- Printer is printing blank pages
- Characters have jagged or uneven edges
- Clipped images
- Shadow images appear on prints
- Gray background on prints
- Incorrect margins
- Paper curl
- Print irregularities
- Print is too dark
- Print is too light
- Repeating defects
- Skewed print
- Solid color or black pages appear on prints
- Black or white streaks appear on transparencies or paper
- Streaked horizontal lines appear on prints
- Streaked vertical lines appear on prints
- Toner fog or background shading appears on a page
- Toner rubs off
- Toner specks
- Transparency print quality is poor
- Uneven print density
- Embedded Web Server does not open
- Contacting customer support
- Notices
- Product information
- Edition notice
- GOVERNMENT END USERS
- Trademarks
- Federal Communications Commission (FCC) compliance information statement
- Modular component notice
- Licensing notices
- Noise emission levels
- Waste from Electrical and Electronic Equipment (WEEE) directive
- Static sensitivity notice
- Temperature information
- Laser notice
- Laser advisory label
- Power consumption
- European Community (EC) directives conformity
- Radio interference notice
- Notice to users of the US telephone network: FCC requirements
- Notice to users of the Canadian telephone network
- Notice to users of the New Zealand telephone network
- Notice to Users in the European Union
- Regulatory notices for wireless products
- Exposure to radio frequency radiation
- Industry Canada (Canada)
- Notice to users in the European Union
- STATEMENT OF LIMITED WARRANTY FOR LEXMARK LASER PRINTERS, LEXMARK LED PRINTERS, AND LEXMARK MULTIFUN ...
- Patent acknowledgment
- Index