Lexmark W 812 Users Manual User Reference
2015-01-23
: Lexmark Lexmark-W-812-Users-Manual-269181 lexmark-w-812-users-manual-269181 lexmark pdf
Open the PDF directly: View PDF
Page Count: 197 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Go back
- Table of contents
- Printer overview
- Sending a job to print
- Canceling a print job
- Conserving supplies
- Holding a job in the printer
- Paper and specialty media specifications
- Linking trays
- Loading the trays
- Loading the multipurpose feeder
- Tips for successful printing
- Using the optional duplex unit
- Checking an unresponsive printer
- Solving print quality problems
- Solving paper feed problems
- Solving printing problems
- Solving other option problems
- Calling for service
- Understanding jam messages
- Clearing jams
- Ordering supplies
- Determining the status of supplies
- Recycling used supplies
- Replacing the print cartridge
- Replacing the fuser
- Understanding the printer operator panel
- Configuring printer alerts
- Removing memory and option cards
- Disabling the operator panel menus
- Disabling Power Saver
- Size Sensing
- Printing a menu settings page
- Restoring factory default settings
- Changing menu settings
- Understanding fonts
- Printing sample fonts
- Understanding printer messages
- Activating Demo Mode
- Activating Menu Changes
- Activating PPDS
- Busy
- Canceling Job
- Change <x>
- Check <device> Connection
- Clearing Job Accounting Stat
- Close Duplex Doors
- Close Top Cover
- Deactivating Demo Mode
- Deactivating PPDS
- Defragmenting
- Delete All Jobs
- Deleting Jobs
- Disabling Menus
- Disk Corrupted. Reformat?
- Disk Recovery x/5 yyy%
- Enabling Menus
- Enter PIN: =___
- Flushing Buffer
- Formatting Disk
- Formatting Disk yyy%
- Formatting Flash
- Held Jobs may be lost
- Held Jobs may not be restored
- Insert Print Cartridge
- Insert Tray <x>
- Invalid Network <x> Code
- Invalid Standard Network Code
- Load Manual
- Load Tray <x>
- Maintenance
- Menus Disabled
- Network Card Busy
- Network <x>
- No Jobs Found. Retry?
- Not Ready
- Parallel <x>
- Performing Self Test
- Power Saver
- Print Jobs on Disk
- Printing Alignment Page
- Printing Directory List
- Printing Font List
- Printing Job Accounting Stat
- Printing Menu Settings
- Printing Quality Test Pages
- Prog System Code
- Program Flash
- Programming Disk
- Programming Error P<x>
- Queuing and Deleting Jobs
- Queuing Jobs
- Ready
- Ready Hex
- Remove Paper <specified bin>
- Res Reduced
- Resetting Maint Cnt Value
- Resetting the Printer
- Restore Held Jobs. Go/Stop?
- Restoring Factory Defaults
- Restoring Held Job xxx/yyy
- Serial <x>
- Std Bin Full
- Toner Low
- Tray <x> Empty
- Tray <x> Low
- Tray <x> Missing
- USB <x>
- Waiting
- 1565 Emul Error Load Emul Option
- 2<xx> Paper Jam
- 31 Defective Print Cartridge
- 34 Wrong Paper Size in Tray <x>
- 35 Res Save Off Deficient Memory
- 37 Insufficient Collation Area
- 37 Insufficient Defrag Memory
- 37 Insufficient Memory
- 38 Memory Full
- 39 Complex Page
- 4<x> Unsupported Firmware Card
- 50 PPDS Font Error
- 51 Defective Flash
- 52 Flash Full
- 53 Unformatted Flash
- 54 Serial Option <x> Error
- 54 Standard Serial Error
- 54 Network <x> Software Error
- 54 Std Network Software Error
- 54 Std Par ENA Connection Lost
- 54 Par <x> ENA Connection Lost
- 56 Serial Port <x> Disabled
- 56 Standard Serial Disabled
- 56 Parallel Port <x> Disabled
- 56 Std Parallel Port Disabled
- 56 USB Port <x> Disabled
- 56 Standard USB Port Disabled
- 57 Configuration Change
- 58 Too Many Disks Installed
- 58 Too Many Flash Options
- 58 Too Many Trays Attached
- 61 Defective Disk
- 62 Disk Full
- 63 Unformatted Disk
- 64 Unsupported Disk Format
- 80 Scheduled Maintenance
- 88 Toner Low
- 900–999 Service <message>
- Finishing Menu
- Job Menu
- Quality Menu
- Paper Menu
- PCL Emul Menu
- PPDS Menu
- Serial Menu
- Network Menu
- Parallel Menu
- Setup Menu
- PostScript Menu
- USB Menu
- Utilities Menu
- Notices