LibreStream Technologies WL18 WiFi and Bluetooth Module User Manual Regulatory and Safety Guide

LibreStream Technologies Inc. WiFi and Bluetooth Module Regulatory and Safety Guide

Contents

Regulatory and Safety Guide

CUBE
REGULATORY AND
SAFETY GUIDE
GENERAL SAFETY INFORMATION
• Do not attempt to service or dismantle this
equipment. All repairs must be done by an
authorized Librestream service depot. Contact
support@librestream.com for an authorized
Librestream service depot.
• Carefully read the User Manual before operating the
Onsight Cube
• Use only a Librestream supplied power adapter with
the equipment. Use of other adapters will void the
warranty and may cause fire or explosion hazards.
• Operate the external power adapter in a well
ventilated area. Do not cover the power adapter
with papers or any other items as the adapter may
become hot.
• If you determine that the device is hot, emits an
odor, or changes color or shape, disconnect power
immediately. The device must not be used again.
BATTERY SAFETY INFORMATION
• The Onsight Cube uses an internal, non-user
replaceable Lithium Ion battery. Please do not
attempt to disassemble the Onsight Cube to replace
or service the battery. Please contact support@
librestream.com for help with service issues.
• The battery charging temperature specification of
the Onsight Cube is 0°C to 45°C; do not attempt
to charge the battery when operating outside these
temperature limits. For your safety the Onsight
Cube will disable the battery charging when the
safe charging temperature is exceeded.
• The storage temperature specification of the
Onsight Cube is -20°C to 60°C; do not store
the Onsight Cube in a location where these
storage temperature limits may be exceeded.
Storage beyond the specified limits can result in
degradation of the battery, fire or explosion.
• Do not store or leave the Onsight Cube near a heat
source (e.g. radiator, stove, heater, automobile
dashboard, etc.). The battery may explode or ignite.
• Misuse of the battery may cause them to become
hot, explode, or ignite and may cause serious
injury.
BATTERY DISPOSAL AND RECYCLING
The Onsight Cube contains an internal Lithium-Ion
battery. Recycle or dispose of the batteries according
to national, state, and local regulations.
• Do not dispose the Onsight Cube with household or
office waste.
• Do not dispose the Onsight Cube in a fire as the
battery may explode.
• Contact your local waste disposal agency for the
address of the nearest battery disposal location.
• The European Union Waste Electrical and
Electronic Equipment (WEEE) Directive forbids
the disposal of waste electrical and electronic
equipment as unsorted municipal waste, requiring
that it be collected and recycled or disposed of
separately. Hazardous substances are present in
electrical and electronic equipment and present
potential risk to human health and environment
if disposed of in municipal landfills which are not
designed to prevent migration of substances into
the soil and groundwater.
• Please contact support@librestream.com for help
with battery disposal/recycling issues.
AC ADAPTER INFORMATION
This device is supplied with an AC Adapter for
charging the battery and powering the Onsight Cube.
The following labels identify the safety approvals for
the AC Adapter.
LASER SAFETY INFORMATION
This device is contains a Class I laser for pointing and
measurement.
This CAUTION symbol appears within
the manuals and on the product label.
The CAUTION logo is used to draw
attention to important safety critical
matters. When this symbol appears on
the product label, consult accompanying
documents for more information
CAUTION! Risk of explosion if the
battery is replaced by an incorrect type
or is installed incorrectly. Do not attempt
to service or replace the internal battery.
Please contact Librestream support@
librestream.com for support and service.
PRODUCT SAFETY NOTICE
The Onsight Cube mobile streaming
camera was evaluated to IEC 60950-
1, EN60950-1, UL 60950-1 and
CSA C22.2 60950-1 standards and
was found to be in compliance with
the standard requirements.
FCC RF EXPOSURE NOTICE
For body worn operation, this product has been tested
and meets RF exposure guidelines when used with
an accessory that contains no metal. Use of other
accessories may not ensure compliance with RF
exposure guidelines. No metallic accessories should
be used with this device and multiple devices should
not be co-located at a distance of less than 20 cm.
Warning: Changes or modifications not expressly
approved by the manufacturer could void the user’s
authority to operate this equipment.
CONTINUED ON REVERSE
THIS MANUAL APPLIES TO THE ONSIGHT CUBE
ISED RF NOTICE
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
Conformément à la réglementation d’Industrie Canada,
le présent émetteur radio peut fonctionner avec une
antenne d’un type et d’un gain maximal (ou inférieur)
approuvé pour l’émetteur par Industrie Canada.
Dans le but de réduire les risques de brouillage
radioélectrique à l’intention des autres utilisateurs, il
faut choisir le type d’antenne et son gain de sorte que
la puissance isotrope rayonnée équivalente (p.i.r.e.) ne
dépasse pas l’intensité nécessaire à l’établissement
d’une communication satisfaisante.
LICENSE EXEMPT RADIO APPARATUS /
APPAREILS RADIO EXEMPTS DE LICENCE
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
The device for operation in the band 5150-5250 MHz
is for indoor use ONLY, this restriction is to reduce the
potential for harmful interference to co-channel mobile
satellite systems.
Les dispositifs fonctionnant dans la bande 5150-5250
MHz sont réservés uniquement pour une utilisation
à l’intérieur afin de réduire les risques de brouillage
préjudiciable aux systèmes de satellites mobiles
utilisant les mêmes canaux.
High-power radars are allocated as primary users
(i.e. priority users) of the bands 5250-5350 MHz
and 5650-5850 MHz and these radars could cause
interference and/or damage to LE-LAN devices.
Les utilisateurs de radars de haute puissance sont
désignés utilisateurs principaux (c.-à-d., qu’ils ont
la priorité) pour les bandes 5250-5350 MHz et
5650-5850 MHz et ces radars pourraient causer
du brouillage et/ou des dommages aux dispositifs
LAN-EL.
The maximum antenna gain permitted for devices in
the bands 5250-5350 MHz and 5470-5725 MHz
shall comply with the e.i.r.p. limit.
Le gain maximal d’antenne permis pour les dispositifs
utilisant les bandes 5250-5350 MHz et 5470-5725
MHz conforme à la limite de p.i.r.e.
FCC CLASS B NOTICE
This product has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These rules are designed
to provide reasonable protection against harmful
interference in a residential installation. This product
generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance
with the instructions, may cause harmful interference
with radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If the equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
on and off, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Caution: Changes or modifications that are not
expressly approved by the manufacturer could void the
user’s authority to operate this equipment.
CE DECLARATION OF CONFORMITY
CE Declaration of Conformity (DOC) is shown on
following page. The signed copy of the Declaration of
Conformity is available; please contact Librestream
customer support if you require a signed copy.
WEE INFORMATION
Information on collection and recycling arrangements
for Librestream customers can be found at
www.librestream.com/recycling
LIBRESTREAM CONTACT INFORMATION
DOCUMENT INFORMATION
Librestream Onsight Cube Regulatory and Safety Guide
Doc #: 400339-00 Rev 01
September 2018
Information in this document is subject to change
without notice. Reproduction in any manner whatsoever
without the written permission of Librestream is strictly
forbidden.
Copyright © 2018
Librestream Technologies Incorporated.
All rights reserved.
Name of Librestream Product:
Copyright Notice:
Copyright 2004 - 2018 Librestream Technologies
Incorporated. All Rights Reserved.
Patents Notice:
United States Patent # 7,221,386, together with
additional patents pending in Canada, the United
States and other countries, all of which are in the name
of Librestream Technologies Inc.
Trademark Notice:
Librestream, the Librestream logo, Onsight, Onsight
Expert, Onsight Mobile, Onsight Enterprise, and Onsight
Management Suite are either registered trademarks or
trademarks of Librestream Technologies Incorporated
in Canada, the United States and/or other countries.
All other trademarks are the property of their respective
owners.
Manufacturer’s Name: Librestream Technologies
Inc.
Manufacturer’s Address: 895 Waverley St. Suite
110
Winnipeg, MB. R3T 5P4
Canada.
T: 204-487-0612
F: 204-487-0914
I the undersigned, hereby declares under sole
responsibility of the manufacturer, that the product(s)
as originally delivered:
Equipment Type: Information Technology
Equipment
Product Name: Cube
Model Number(s): 800
complies with the essential requirements of the
following applicable European Directive and carries
the CE marking accordingly:
RED Directive 2014/53/EU
EMC Directive 2014/30/EU
LVD Directive 2014/35/EU
The above device has been tested and found to
comply with the following harmonized standard(s):
EMC & RADIO: EN 55032:2012+AC:2013 CLASS B
ETSI EN 301 489-1 V2.1.1
ETSI EN 301 489-17 V3.1.1
ETSI EN 300 328 V2.1.1
ETSI EN 301 893 V2.1.1
SAFETY: EN 60950-1:2006/A2:2013-08,
IEC 60950-1 + AMD1:2009 +
AMD2:2013
APPLICANT:
Signature: Original Signed document is available
upon request
Full Name: Gilles Aminot, P.Eng
Title: Hardware Engineering Manager
Place of Issue: Winnipeg MB. Canada
Date of Issue: September 3rd, 2018
Full Address: Suite 110, 895 Waverley St
Winnipeg, Manitoba
Canada, R3T-5P4
Phone #: 204-487-0612
Fax #: 204-487-0914
EU DECLARATION OF CONFORMITY
CUBE
WEBSITE: www.librestream.com
HEAD OFFICE: Librestream Technologies Inc.
Suite 110, 895 Waverley St.
Winnipeg, Manitoba
Canada, R3T 5P4
GENERAL INQUIRIES:
Email information@librestream.com
Phone (204) 487-0612
Fax (204) 487-0914
SUPPORT:
Email support@librestream.com
Phone 1 (800) 849-5507
Fax +1 (204) 487-0914

Navigation menu