Lifeline Systems 319BD Personal Help Button User Manual

Lifeline Systems Inc Personal Help Button

User Manual

Download: Lifeline Systems 319BD Personal Help Button User Manual
Mirror Download [FCC.gov]Lifeline Systems 319BD Personal Help Button User Manual
Document ID691219
Application IDanqAHQsaz+CI/hahHjLQqQ==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize128.82kB (1610291 bits)
Date Submitted2006-08-08 00:00:00
Date Available2006-08-08 00:00:00
Creation Date2006-04-30 21:52:40
Producing SoftwareQuarkXPress(tm) 6.5
Document Lastmod0000-00-00 00:00:00
Document TitleUser Manual
Document CreatorQuarkXPress(tm) 6.5

Instructions for Using
The Lifeline® Personal Help Button SX319
About Your Personal Help Button
Your Lifeline Personal Help Button is powered by a long-life lithium battery. It is dust
proof and waterproof* so that it can be worn in the shower or bath.
Slimline Personal Help Buttons are designed to be worn as a pendant on an adjustable
neckcord or can be converted to wristwear using the enclosed wriststrap.
To shorten the neck cord
With a “tab” between your
first finger and thumb of
each hand, gently slide both
tabs apart in line with your
shoulders.
To install the wriststrap
Remove the watch pins at
each end of the button by
inserting a small paper clip
or similar tool into the hole
on both outside edges.
Position the wriststrap over
the back of the button and
insert the watch pins over the
wriststrap into the pin holes.
To lengthen the neck cord
Pull “single” strand of
neckcord while sliding
tab to back. Repeat on
other side.
To adjust the wriststrap
Lift the fastener to loosen
the wriststrap.
Adjust wriststrap to desired
length and close fastener.
The wriststrap will slide easily
on and off the wrist with no
further adjustment needed.
*To a maximum depth of 4 feet of water. The Personal Help Button cannot transmit a signal while
submerged in water.
Save These Instructions for Future Reference
Important Safety Instructions
1 Please read all instructions.
2 Test the operation of your PHB each month and after
every cleaning.
3 Do not remove the label. Your Personal Help Button is
waterproof provided the label is firmly in place. If the
label is removed, peeling off or damaged in any way,
the button must be replaced. Your button will not send
a signal while submerged in water. Your Personal Help
Button is not intended for machine washing or drying.
4 Do not use any attachment or accesory that is not indeded for use with your PHB.
5 Your PHB is factory serviceable only. There are no user
replaceable parts inside the PHB.
Replacing Your PHB
Your Personal Help Button has an internal,
non-replaceable battery and will send a low battery signal
when it needs to be replaced.
Cleaning Your Personal Help Button
Your Personal Help Button is designed to be worn in the
shower or bath. You can submerge your button in warm
water for easy cleaning. Before you start, turn off the
power switch on the communicator to ensure that a false
“help” call will not accidentally be sent to the response
center. Wash the button with a mild, liquid dishwashing
detergent, then rinse and dry with a soft towel.
©2006 Lifeline Systems, Inc.
Printed in USA
FCC Warning and
User Notification Requirement
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Any changes or modifications no expressly approved by
Lifeline System for compliance could void your authority to
operate the equipment.
INDUSTRY CANADA
This apparatus complies with the class“B” limits for radio interference as specified in the Canadian Department of
Communications Radio Interference regulations.
Field Strength ....................Less than 5900 MV/m at 3m
Operating Frequency ..........319.5 MHz
Channeling ..........................1
Mode of Transmission ........Pulse Modulation
Data Source ........................Internal Only
Type of Modulation ............Pulse Position
Occupied Bandwidth ..........319 MHz-320 MHz
Emission Designator ..........60K0L1D
Power Output ....................10 microwatts
Use and Purpose ..............See Instructions
Rating ..............................3 VDC, .006A
One or more of the following US Patents may apply to
this product: D277,465, 4,524,243, 4,656,319, 4,760,593,
4,622,544, 4,908,602, 4,884,059, D313,363, D313,362,
4,064,368, 3,989,900, 5,091,930
One or more of the following Canadian Patents may apply to this
product: 1,274,930, 1,256,613
P/N 0940493 Rev. 01

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Page Count                      : 2
X Press Private                 : %%DocumentProcessColors: Black.%%EndComments
Producer                        : QuarkXPress(tm) 6.5
Create Date                     : 2006:04:30 21:52:40
Creator                         : QuarkXPress(tm) 6.5
EXIF Metadata provided by EXIF.tools
FCC ID Filing: BDZ319BD

Navigation menu