Lionda Technology Co M44001 900 MHz 40 Channel Analog Cordless Phone User Manual FCC Information

Download:
Mirror Download [FCC.gov]
Document ID	133394
Application ID	fggK9wG15R9ui+5lH0HHww==
Document Description	User Manual FCC Information
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	36.43kB (455386 bits)
Date Submitted	2001-01-19 00:00:00
Date Available	2001-01-19 00:00:00
Creation Date	2001-01-16 14:16:21
Producing Software	Acrobat 4.0 Scan Plug-in for Windows
Document Lastmod	2001-01-16 14:16:53
Document Title	User Manual FCC Information
Document Creator	Acrobat 4.0 Scan Plug-in for Windows

Problem Solving
Answering System does not work, check the following:
1. BASEuNllispluggedintoapoweLsotm
2. Reset the system by pressing the RESET button atthe side otthe BASE UNIT.
Answering System does not answer calls, check the following:
1. ANSWER ONIOFF LED indicator is lit.
Answers calls only after 10 rings, check the following:
1. ANSWER ON/OFF LED indicator is lit.
2. Message memory is not full.
BATT LOWLED indicator on the BASE UNIT lit up, check the following:
1. 4 AAA size Batteries are properly installed.
2. 4 AAA size Batteries need to be replaced.
Does not respond to remote commands, ensure the following:
1. Correct Remote Access Code is entered.
2. ATONE telephone is being used.
Messages are incomplete, ensure the following: @.
1. Message Memory is not full.
2. Geller may be hesitating and pausingfor more than 7 seconds.
Answers calls but does not record messages, check the following:
1. ANNCIICM switch is set to [GM
2. Memory Is not full.
3. atension telephone was not picked up.
NOTE: if none of the telephones in the house are working, disconnect one set at a
time to verify that none of the telephones are ca using the problem. if you still have
a problem after doing lhis,gand your telephone still does not work. please contact
your local phone company. '
lMPORTANT
When you hear interlerence, press the
m button to change the operating
channel.
“’] I sow~mamp$5 31 nz/ts/oqnszm I l—
Technical Information
Technical Information
This cordless telephone uses radio frequencies to allow mobility, There are certain
difl‘icutties in using radio frequencies with a cordless telephone. W-hilethese are
normal, the following could affect the operation of your system.
Noise
Electrical pulse noise Is present in most homes atone time or another. This noise
is most intense during electrical storms. Certain kinds of electrical equipment
such as light dimmers, fluorescent bulbs, motors, and fans also generate noise
pulses. Because radio frequencies are susceptible to these noise pulses, you
may occasionally hear them in your HANDSET‘ Generally they are a minor
annoyance and should not be interpreted as a defect in your system.
Range
Because radio frequency is used, the location of the BASE UNIT can affect the
operating range. Try several locations in your home or office and pick the one that
gives you the clearest signal to the HANDSET.
Interference
@ Electronic circuits activate a relay to connect the cordless telephone to your @_
telephone line These electronic circuits operate In the radio frequency spectmm.
While several protection circuits are used to prevent unwanted signals, there may
be-pen'odswhen these unwanted signals enter the BASE UNIT You may hear
clicks or hear the relay activate while you are not using the HANDSET If the
interference occurs frequently, it can be minimized or eliminated by lowering the
height 01 your BASE UNIT ANTENNA or by relocating the BASE UNIT. You can
check for interference before selecting the final BASE UNIT location by plugging in
the phone.
NOTICE:
This cordless telephone uses radio communication between the HANDSET and
the BASE UNIT and may not ensure privacy of communication. Other devices,
including other cordless telephones, may interfere with the operation of this cordless
telephone or cause noise during operation. Units not containing coded access
may be accessed by other radio communicatlon systems. Cordless telephones
must not cause interference to any licensed radio service.
—| I Min-noes at Wis/nounszm | I'—
FCC Requirements
Federal Communications Commission Requirements
ThIs equipment complies with Part 68 of FCC Rules. A label on the BASE UNIT of
this equipment contains, among other information, the FCC Registration Number
and the Ringer Equivalence Number (REN) for this equipment. You must, upon
request, provide this information to your telephone company,
The REN is also useful in determining the quantity of devices that you may
connect to your telephone line and still allow these devices to ring when your
telephone number is called. in most areas, but not all, the sum ofthe RENs for all
devices connected to one line should not exceed five (5 0) To be certain of the
number of devices that you may connect to your line, you should contact your
local telephone company.
AFCC oompliantTELEPHONE LINE CORD and MODULAR PLUG is provided with this
equipment. This equipment is designed to be connected to the telephone network or
premesiswiring using a oompatibie'modular jack which is Part 68 compliant Refer
to the Getting Started section of the Owner‘s Manual for details. '
If your equipment should cairse harm to the telephone network. the telephone
@ company may temporarily disconnect your service, If possible, they will notify you ©—
in advance that temporary discontinuance of service may be required However,
when advanced written notice is not possible, the telephone company may
temporarily discontinue service without notice if such action is necessary under
the circumstances The telephone company may make changes in its
communication facilities, equipment, operations, or procedures where such action
is reasonably required in the operation of its business and is not
inconsistent with the rules and regulations of the Federal Communications
Commission. Do not attempt to repalr or modify this equipment.
WARNING: Changes or modifications not expressly approved by the party responsible
for its compliance could void the user's authority to operate the equipment.
Some cordless telephones operate at frequencies that may cause interference to
nearby TVs and VCRs. To minimize or prevent such interference, the BASE UNIT
of the cordless telephone should not be placed on or near a TV or VCR if
interference is experienced, moving the cordless telephone fartheraway from the
TV orVCR will often reduce or eliminate the interference
~ —\ ' man-lines as Wis/omuzszm 1 ,_
Federal Communications Commission Requirements (continued)
This equipment should not be used on coin telephone lines. Connection to party
line service is subject to state tariffs. if trouble is experienced, disconnect this
equipment from the telephone line to determine if it is causing the mattuncllon. It
the equipment is determined to be malfunctioning. its use should be disconnected
until the problem has been corrected.
NOTE: This equipment has been tested and found to comply with the limits for a
class B digital device. pursuant to Part 15 of the FCC Rules These limits are
designed to provide reasonable protection against harmful interference in a
residential installation This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. Ifthis equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment offend on, the user
is encouraged to try to correct the interference by one or more at the following '
measures:
@ 1 . Reorient or relocate the receiving ANTEN NA. “é"
2. increase the distance between the equipment and the receiver.
3. Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
4. Consult the dealer oran experienced radio/TV technician for help.
lMPORTANT
In order to get maximum life from the HANDSET
BATTERY PACK, be sure to charge the HANDSET
for 12 hours before initial use.
121mm, 11:51AM | if
Warranty
Warranty Information
BelISouth Products
One-Year Limited Warranty
This limited warranty sets forth all BellSouth Products responsibilities regarding
your product There are no other expressed or implied warlanties tram BellSouth
Products.
Warranty Service Provided '
If you purchased the telephone new from a retail vendor, Bellsouth Products
warrants the telephone against defects In material and workmanship fora period of
one (1) yearfrom the original date of purchase. This warranty is in iieu of all other
expressed warranties. This warranty begins when you purchase the telephone and
continues for one (1 ) year unless you sell or rent the telephone, in which case the
warranty stops ~
BellSoulh Products disclaims any implied warranty, including the warranty of-
merohantability and the warranty of fitness for a particular purpose, as of the date
of 90 days from your original purchase of the telephone. Eellsouth Products
@ assumes no responsibility for any special, incidental, or consequential damages. _@
This warranty gives you specific legal rights and you may have other rights which
vary from state to state, Some states do not allow the exclusion or limitations of
special, incidental or consequential damages, or limitations on how long a v
warranty lasts, so the above exclusion and limitation may not apply to you,
Warranty Service Not Provided
This' warranty does not cover damage resulting from accident, misuse abuse
improper installation or operation. lack of reasonable care unauthorized
nwdification. the affixing of any attachment not provided by BeIlSouth Products
with the telephone and/or loss of parts. This warranty is voided in the event any
unauthorized person opens, alters or repairs the telephone. All BellSouth
equipment being returned for repair must be suitably packaged. Telephone
companies use different types of equipmentand offer various types of sen/ices to
customers. Bellsouth Products does not warrant that this telephone is
compatible with the type of equipment of any particulartelephone oompany or the
services provided by its
ulna/m, 11mm | [—
'—‘| | Mwumpés 37
1?
vflv
Warranty
What to Do for Warranty Service
During the first thirty (30) days, a defective prod not Is eligible for over-the-counter
exchange at the retailer from whom it was purchased. After thirty (30) days, the
defective product should be retumed to the authorized service center Please allow
2-3 weeks for the return of your telephone product The shipping address of the
authorized service center is:
US. Electronics CONSUMER CENTER
(310 Southern Bonded Warehouse
1491 Mt Zion Rd. ~
Morrow, GA 30260
NOTE: A product received which was not made for BeIISouth Products orwhich is
not defective as determined by our test prooedures will not be repaired and will be
returned C,O.D., freight.
To Obtain Warranty Service
' Provide proof of the date of purchase within me package.
~ Prepay all shipping costs to the authorized service center -
5 Include a return shipping address within the package.
Please retain your sales receipt, the carton, the packing materials, and the printed
@- material. The original carton is the best shipping container forme telephone should Q—
you have to return it.
For your reference:
Serial number
Date of Purchase
Name of Dealer
> Customer Service Telephone Number:
1-800-210-8950
OUTSIDE THE USA. CALL 1-212-242-6978
—‘ ‘ mmwwss as i 121mm, 11:51AM ‘ ,_
——1 I 9M9~nwufi$ 39 i 12/13/m,l1:51m I r—
This page serves es a template for attachment of screws lathe
wall when mounting this telephone on the wall.
1. Cut outthis page
Q" 2. Use thistemplate to determine the distance between screws @
when mounting this phone on the wall. The two cross hairs
identify where to attach the screws.
—| | sow-«mamas 4a 12/18/w,11:52m ‘ l r—
IMPORTANT
in order to get maximum iife from the HANDSET
BATTERY PACK, he sure to charge the HANDSET
for 12 hours before initial use.
IMPORTANT
Placing your BASE UNIT near appliances
such as televisions, refrigerators, radios, or
microwave ovens may cause interference. *
IMPORTANT
When you hear interference. press the
button to change the operating channel.
IMPORTANT
The AC ADAPTOR must always be plugged
into an electrical outlet.
IMPORTANT
To obtain the best receptionv he sure to
raise or reposition! the BASE UNIT ANTENNA.
IMPORTANT
If you live Ill an area which gets frequent thunder-
storms. we strongly recommend plugging your
AC ADAPTOR into a surge protector.
—|| swam-wuss 41 lawmuzszm
Make certain you receive the best
performance from your telephone.
Read this manual first.
\ @ BELLSOUTH
MHQKWA Mad! In China

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Modify Date                     : 2001:01:16 14:16:53+08:00
Create Date                     : 2001:01:16 14:16:21+08:00
Creator                         : Acrobat 4.0 Scan Plug-in for Windows
Producer                        : Acrobat 4.0 Scan Plug-in for Windows
Page Count                      : 10

EXIF Metadata provided by EXIF.tools