LogiTag Systems 1149466 4 channel RFID reader with CAN bus User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2079763
Application ID	EqSpguVc2S47tjQ4sQw5dQ==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	49.6kB (620024 bits)
Date Submitted	2013-09-23 00:00:00
Date Available	2013-09-25 00:00:00
Creation Date	2017-10-25 18:27:32
Producing Software	GPL Ghostscript 9.18
Document Lastmod	2017-10-25 18:27:32
Document Title	Users Manual
Document Creator	Microsoft® Word 2010
Document Author:	alonn

4 Channel RFID reader
LF 125KHz
with CAN bus
LT-LFS03
USER MANUAL
Tel: 972-9-835-4848
Fax: 972-9-865-6262
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504
Israel LogiTag Systems LTD. www.logi-tag.com
Page
1/10
Product
name
4 Channel RFID reader LF 125KHz with CAN
bus LT-LFS03 User manual
p/n
Document
p/n
date
LT-D-131
27/08/2013
Product rev.
C01
Document
rev.
Author name
01
Documents changes and version
Date
Name
Change description
27/08/2013
Tomer I
Document release
Tel: 972-9-835-4848
Fax: 972-9-865-6262
Tomer I.
version
10
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504
Israel LogiTag Systems LTD. www.logi-tag.com
Page
2/10
1. Safety Instructions / Warning - Read before start-up !
 The device may only be used for the purpose intended by the
manufacturer.
 The operation manual should be kept readily available at all times for
each user.
 Unauthorized changes and the use of spare parts and additional
devices which have not been sold or recommended by the
manufacturer may cause fire, electric shocks or injuries. Such
unauthorized measures shall exclude the manufacturer from any
liability.
 The liability-prescriptions of the manufacturer in the issue valid at the
time of purchase are valid for the device. The manufacturer shall not
be held legally responsible for inaccuracies, errors, or omissions in
the manual or automatically set parameters for a device or for an
incorrect application of a device.
 Repairs may only be undertaken by the manufacturer.
 Installation, operation, and maintenance procedures should only be
carried out by qualified personnel.
 Use of the device and its installation must be in accordance with
national legal requirements and local electrical codes.
 When working on devices the valid safety regulations must be
observed.
 Do not connect both voltage harness and USB cable, this will defect
the circuit!
Tel: 972-9-835-4848
Fax: 972-9-865-6262
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504
Israel LogiTag Systems LTD. www.logi-tag.com
Page
3/10
2. System description
This reader supports up to 4 RFID 125 KHz antennas.
Support transponder HITAG 1/2/S protocols.
The reader can work in two forms:
 Communication and power supply via USB.
 Communication interface RS232/CAN BUS and external power
supply 10-24VDC using voltage harness
 The reader supports up to four antennas.
J1: RS232, CAN bus,
voltage supply
Antenna
connector
Tel: 972-9-835-4848
Fax: 972-9-865-6262
J6:
USB
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504
Israel LogiTag Systems LTD. www.logi-tag.com
Page
4/10
2.1 Communication interfaces:
 USB using mini USB cable at connector J6.
 RS232
 baud rate = 9600 bps
 data bits = 8
 parity = none
 stop bit = 1
 flow control = none
 Cable pin-out
 Pin 2-Rx
 Pin 4-Tx
 Pin 3–GND
 CANBUS-RS232
 Synchronization Segment
= 1 TQ
 Propagation Segment
= 3 TQ
 Phase Segment 1
= 4 TQ
 Phase Segment 2
= 2 TQ
 Synchronization Jump Width = 2 TQ
 Time Quantum = 250 ns
 Baud Rate = 400 Kbps
 Cable pin-out
 Pin 5-CAN_L
 Pin 7-CAN_H
 Pin 8-CAN_Shiled
Tel: 972-9-835-4848
Fax: 972-9-865-6262
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504
Israel LogiTag Systems LTD. www.logi-tag.com
Page
5/10
2.2 Power Supply Connection:
 Allowed supply voltage: 10 - 24V or 5V via USB (connector J6).
 Use of higher supply voltage can damage the system!!
 Connector pin-out for voltage harness (regular supply)
 Pin 1-Vin
 Pin 3-GND_in
2.3 System operation:






Tel: 972-9-835-4848
Fax: 972-9-865-6262
If using regular power supply connect the voltage harness to
J1 to host device.
If using USB interface, connect mini USB B cable to J6 and
connect to host device.
Warning: do not connect both voltage harness and USB
cable, this will defect the circuit!
Connect to antenna connector antenna (support up to 4
antennas).
Run software at host.
Place transponders over antenna location, check if host
identify transponders.
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504
Israel LogiTag Systems LTD. www.logi-tag.com
Page
6/10
2.4 RFID Protocols:
 HITAG 1/2/S
Tel: 972-9-835-4848
Fax: 972-9-865-6262
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504
Israel LogiTag Systems LTD. www.logi-tag.com
Page
7/10
3. Radio approvals:
3.1 USA FCC:
Product name: 4 Channel RFID Reader 125KHz
FCC ID: Z97-1149466
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help.
Warning:
Changes or modifications to this equipment not expressly approved
by the party responsible for compliance (LogiTag Systems Ltd.) could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Tel: 972-9-835-4848
Fax: 972-9-865-6262
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504
Israel LogiTag Systems LTD. www.logi-tag.com
Page
8/10
FCC labeling requirements:
If the FCC ID is not visible when the module is installed inside
another device, then the outside of the device into which the
module is installed a label referring to the enclosed module
shall be with the wording “Contains FCC ID:Z97-1149466” .
FCC label:
4 Channel RFID LF
Reader
FCC ID: Z97-1149466
Manufacturer:
LogiTag Systems Ltd.
Tel: 972-9-835-4848
Fax: 972-9-865-6262
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504
Israel LogiTag Systems LTD. www.logi-tag.com
Page
9/10
4. Board specifications:
 Reader transceiver frequency 125KHz
 Working voltage: 10-24V
 Current consumption 70mA@24V
 Operating temperature -20C to + 65C
 Storage temperature 40C to +85C
 Dimensions 5.5*7.2*1.8 cm
Tel: 972-9-835-4848
Fax: 972-9-865-6262
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504
Israel LogiTag Systems LTD. www.logi-tag.com
Page
10/10

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract
Author                          : alonn
Create Date                     : 2013:09:16 13:49:00+03:00
Modify Date                     : 2013:09:17 11:49:47+02:00
Language                        : he-IL
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Format                          : application/pdf
Creator                         : alonn
Creator Tool                    : Microsoft® Word 2010
Metadata Date                   : 2013:09:17 11:49:47+02:00
Producer                        : Microsoft® Word 2010
Document ID                     : uuid:dc9b2ef7-1c21-4d45-be79-291fbb450197
Instance ID                     : uuid:a6e41793-7348-4cbc-a210-d2206f46e4d8
Page Count                      : 10

EXIF Metadata provided by EXIF.tools