Luxul Wireless XAP1240 High Power Wireless 300N Outdoor AP User Manual LUX QIG XAP 1240 indd

Luxul Wireless High Power Wireless 300N Outdoor AP LUX QIG XAP 1240 indd

Users Manual

108.00mm140.00mm
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.  However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:-  Reorient or relocate the receiving antenna.-  Increase the separation between the equipment and receiver.-  Connect the equipment into an outlet on a circuit different from that    to which the receiver is connected.-  Consult the dealer or an experienced radio/TV technician for help.FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.Radiation Exposure StatementThis equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
REGULATORY COMPLIANCE AND SAFETY NOTIFICATIONThis documentation contains regulatory compliance and safety information for both wireless and non-wireless hardware. Not all the information contained in this document applies to every product.FCC ComplianceThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-tions: (1) this device may not cause harmful interference, and (2) this device must accept any interfer-ence received, including interference that may cause undesired operation.Regulatory ComplianceThe device complies with internationally recognized standards covering human exposure to electro-magnetic fields from radio devices. This equipment also complies with FCC radiation exposure set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20 cm (8 in) during normal operation.Unauthorized antennas, modifications, or attachments could cause damage and may violate regulatory approvals. Any changes or modifications not expressly approved by the party responsible for compli-ance could void the authority to operate the equipment.Luxul equipment marketed in the U.S. is restricted to usage of channels 1-11 only for 2.4GHz and channels 100-140/149-165 for 5GHz.FCC Statement—Wireless FCC 2.4GHz & 5GHz 802.11b/g/n/acThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-tions: (1) This device may not cause harmful interference, and (2) this device must accept any interfer-ence received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for either a Class A or Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.Refer to included Quick Installation Guide for device-specific FCC Class information.FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with part 15 of the FCC Rules.  This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure StatementThis equipment complies with FCC radiation exposure limits set forth for an uncontrolled  environment. This equipment should be installed and operated with minimum distance 20cm (8in) between the radiator & your body.Warnings and Safety Information Verify that the electrical circuits have appropriate grounding and overload protection. Attach only approved power cords to the device. Verify there is adequate ventilation around the device, and that ambient temperatures meet equipment operation specifications. DO NOT install in or near hot or humid places, such as a kitchen or bathroom. Take care to minimize exposure to excessive heat or moisture. Small parts and plastic bags used for packaging may be harmful to small children. KEEP ALL ACCESSORIES OUT OF THE REACH OF CHILDREN! This product may become hot when in use for extended time periods. This is normal and is not a malfunction. DO NOT install where it will be exposed to paper, cloth or other flammable materials. © 2015  Luxul. All Rights Reserved.  LUX-REG-FCCSAFETY 0541505
Health and Safety RecommendationsWarnings for the use of Wireless Devices: Please observe all warning notices with regard to the usage of wireless devicesPotentially Hazardous Atmospheres: You are reminded of the need to observe restrictions on the use of radio devices in fuel depots, chemical plants, and other similar areas where the air contains chemicals or particles (such as grain, dust, or metal powders).Safety in Hospitals: Wireless devices transmit radio frequency energy and may affect medical elec-trical equipment. When installed adjacent to other equipment, it is advised to verify that the adjacent equipment is not adversely affected.RF Exposure GuidelinesSafety Information: The device complies with internationally recognized standards covering human exposure to electromagnetic fields from radio devices.Warning: Exposure to Radio Frequency (RF) Radiation: The radiated output of this device is below the FCC radio frequency exposure limits. Nevertheless, the device should be used in such a manner that the potential for human contact during normal operation is minimized.  The end user must avoid any extended human RF exposure directly in front of the device, up to a distance of 20cm (8in), when unit is on. When servicing the equipment and selecting a location for the antennas, it is important to note that a minimum distance of 20cm (8in) is required between personnel and the device or antenna to comply with the radio frequency exposure limit. The antenna used for this transmitter must be installed to provide a separation distance of at least 20cm (8in) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.The following safety precautions should be observed:  Do not touch or move the antenna while the unit is transmitting or receiving.  Do not hold any component containing the radio such that the antenna is very close or touching any exposed parts of the body, especially the face or eyes, while transmitting.  Do not operate the radio or attempt to transmit data unless the antenna is connected; this behavior may cause damage to the radio.Industry Canada (RSS-Gen Issue 4)This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)this device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareilsradio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1)l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compli-ance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance. Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS 102 et la conformité à l’exposition de RSS-102 rf, utilisateurs peut obtenir l’information canadienne sur l’exposi-tion et la conformité de rf.This transmitter must not be co-located or operating in conjunction with any other antenna or trans-mitter. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu’aucune autre antenne ou émetteur. Cet équipement devrait être installé et actionné avec une distance minimum de 20 centimètres entre le radiateur et votre corps.CAN ICES-3(B)/NMB-3(B)

Navigation menu