Luxul Wireless XAP1240 High Power Wireless 300N Outdoor AP User Manual LUX QIG XAP 1240 indd

Download:
Mirror Download [FCC.gov]
Document ID	2720148
Application ID	1BmAv4DhOmw1TWMc7Xc9Xw==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	372.49kB (4656064 bits)
Date Submitted	2015-08-20 00:00:00
Date Available	2015-08-21 00:00:00
Creation Date	2015-07-06 17:21:20
Producing Software	Adobe PDF Library 15.0
Document Lastmod	2015-08-14 20:09:50
Document Title	LUX-QIG-XAP-1240.indd
Document Creator	Adobe InDesign CC 2015 (Macintosh)

140.00mm
108.00mm
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
REGULATORY COMPLIANCE AND SAFETY NOTIFICATION
This documentation contains regulatory compliance and safety information for both wireless and
non-wireless hardware. Not all the information contained in this document applies to every product.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Regulatory Compliance
The device complies with internationally recognized standards covering human exposure to electromagnetic fields from radio devices. This equipment also complies with FCC radiation exposure set forth
for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna shall not be less than 20 cm (8 in) during normal operation.
Unauthorized antennas, modifications, or attachments could cause damage and may violate regulatory
approvals. Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate the equipment.
Luxul equipment marketed in the U.S. is restricted to usage of channels 1-11 only for 2.4GHz and
channels 100-140/149-165 for 5GHz.
FCC Statement—Wireless FCC 2.4GHz & 5GHz 802.11b/g/n/ac
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for either a Class A or Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Refer to included Quick Installation Guide for device-specific FCC Class information.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
„„
This device complies with part 15 of the FCC Rules.
„„
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm (8in)
between the radiator & your body.
Warnings and Safety Information
„„
Verify that the electrical circuits have appropriate grounding and overload protection.
„„
Attach only approved power cords to the device.
„„
Verify there is adequate ventilation around the device, and that ambient temperatures meet
equipment operation specifications.
„„
DO NOT install in or near hot or humid places, such as a kitchen or bathroom. Take care to minimize
exposure to excessive heat or moisture.
„„
Small parts and plastic bags used for packaging may be harmful to small children. KEEP ALL
ACCESSORIES OUT OF THE REACH OF CHILDREN!
„„
This product may become hot when in use for extended time periods. This is normal and is not a
malfunction. DO NOT install where it will be exposed to paper, cloth or other flammable materials.
© 2015 Luxul. All Rights Reserved. LUX-REG-FCCSAFETY 0541505
Health and Safety Recommendations
Warnings for the use of Wireless Devices: Please observe all warning notices with regard to the usage
of wireless devices
Potentially Hazardous Atmospheres: You are reminded of the need to observe restrictions on the
use of radio devices in fuel depots, chemical plants, and other similar areas where the air contains
chemicals or particles (such as grain, dust, or metal powders).
Safety in Hospitals: Wireless devices transmit radio frequency energy and may affect medical electrical equipment. When installed adjacent to other equipment, it is advised to verify that the adjacent
equipment is not adversely affected.
RF Exposure Guidelines
Safety Information: The device complies with internationally recognized standards covering human
exposure to electromagnetic fields from radio devices.
Warning: Exposure to Radio Frequency (RF) Radiation:
The radiated output of this device is below the FCC radio frequency exposure limits. Nevertheless, the
device should be used in such a manner that the potential for human contact during normal operation
is minimized.
„„
The end user must avoid any extended human RF exposure directly in front of the device, up to a
distance of 20cm (8in), when unit is on.
„„
When servicing the equipment and selecting a location for the antennas, it is important to note
that a minimum distance of 20cm (8in) is required between personnel and the device or antenna to
comply with the radio frequency exposure limit.
„„
The antenna used for this transmitter must be installed to provide a separation distance of at least
20cm (8in) from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
The following safety precautions should be observed:
„„
Do not touch or move the antenna while the unit is transmitting or receiving.
„„
Do not hold any component containing the radio such that the antenna is very close or touching any
exposed parts of the body, especially the face or eyes, while transmitting.
„„
Do not operate the radio or attempt to transmit data unless the antenna is connected; this behavior
may cause damage to the radio.
Industry Canada (RSS-Gen Issue 4)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2)this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareilsradio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes : (1)l’appareil ne doit pas produire
de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS 102 et la
conformité à l’exposition de RSS-102 rf, utilisateurs peut obtenir l’information canadienne sur l’exposition et la conformité de rf.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu’aucune autre antenne
ou émetteur. Cet équipement devrait être installé et actionné avec une distance minimum de 20
centimètres entre le radiateur et votre corps.
CAN ICES-3(B)/NMB-3(B)

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Create Date                     : 2015:07:06 17:21:20-06:00
Metadata Date                   : 2015:08:14 20:09:50+08:00
Modify Date                     : 2015:08:14 20:09:50+08:00
Creator Tool                    : Adobe InDesign CC 2015 (Macintosh)
Thumbnail Width                 : 256
Thumbnail Height                : 88
Thumbnail Format                : JPEG
Thumbnail Image                 : (Binary data 7805 bytes, use -b option to extract)
Instance ID                     : uuid:e5e9f6eb-6f68-430f-9cf8-e173aed242ad
Original Document ID            : xmp.did:f0edc94a-00b7-40ae-81f2-7908dc521841
Document ID                     : xmp.id:0b1b9e09-4611-41ad-9f8b-d4232cc1fc35
Rendition Class                 : proof:pdf
Version ID                      : 1
Derived From Instance ID        : xmp.iid:0fde8f41-3e0e-4285-81ec-2d5a115764bf
Derived From Document ID        : xmp.did:444e6d5a-b529-47a0-ab99-bb08bc93287b
Derived From Original Document ID: xmp.did:f0edc94a-00b7-40ae-81f2-7908dc521841
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CC 2015 (Macintosh)
History Changed                 : /
History When                    : 2015:07:06 17:21:20-06:00
Format                          : application/pdf
Title                           : LUX-QIG-XAP-1240.indd
Producer                        : Adobe PDF Library 15.0
Trapped                         : False
GTS PDFX Version                : PDF/X-1:2001
GTS PDFX Conformance            : PDF/X-1a:2001
N Pages                         : 1
Has Visible Transparency        : False
Has Visible Overprint           : True
Max Page Size W                 : 600.662963
Max Page Size H                 : 190.500000
Max Page Size Unit              : Millimeters
Font Name                       : KozGoPro-Regular
Font Family                     : 小塚ゴシック Pro
Font Face                       : R
Font Type                       : Open Type
Font Version                    : Version 4.001;PS 4;Core 1.0.38;makeotf.lib1.7.12746
Font Composite                  : False
Font File Name                  : KozGoPro-Regular.otf
Plate Names                     : Cyan, Magenta, Yellow, Black, CMYK-377-100 percent, PANTONE 377
Swatch Groups Group Name        : 默认色板组
Swatch Groups Group Type        : 0
Swatch Groups Colorants Swatch Name: PANTONE 377
Swatch Groups Colorants Type    : SPOT
Swatch Groups Colorants Tint    : 100.000000
Swatch Groups Colorants Mode    : CMYK
Swatch Groups Colorants Cyan    : 61.968398
Swatch Groups Colorants Magenta : 21.585400
Swatch Groups Colorants Yellow  : 100.000000
Swatch Groups Colorants Black   : 4.266400
Slug Family                     : Luxul Symbols
Slug Version                    : 1.000
Slug Outline File Size          : 0
Slug Kerning Checksum           : 0
Slug Foundry                    : --
Slug Font Kind                  : OpenType - PS
Slug Checksum                   : 3669936636
Slug Post Script Name           : LuxulSymbols-Regular
Slug Font Sense 12 Checksum     : 3669936636
Page Count                      : 4
Creator                         : Adobe Illustrator(R) 17.0
For                             : ��ѩƽ,
Bounding Box                    : 0 0 1368 540
Container Version               : 11
Creator Version                 : 18
Image Height                    : 540
Image Width                     : 1368
Image Size                      : 1368x540
Megapixels                      : 0.739

EXIF Metadata provided by EXIF.tools