MOBASE ELECTRONICS SYEC3TX1804 Remote Keyless Entry Transmitter User Manual

SEOYON ELECTRONICS CO., LTD. Remote Keyless Entry Transmitter

User Manual

Title : NO. DateSHT/SHTS : 2/110. GENERAL0.1. MakeSEOYON ELECTRONICS Co.,Ltd.0.2.Model No.- Transmitter : 3BT -4BT -- Receiver : Body Control Module0.3. Name and address of manufacturerSEOYON ELECTRONICS Co.,Ltd.100, Saneop-ro 156beon-gil, Gwonseon-gu, Suwon-si, Gyeonggi-do, Republic of Korea0.4. Address of assembly plantSEOYON ELECTRONICS Co.,Ltd.100, Saneop-ro 156beon-gil, Gwonseon-gu, Suwon-si, Gyeonggi-do, Republic of KoreaRemote Keyless Entry TransmitterSYEC3TX1804Remote Keyless Entry TransmitterSYEC4TX1804Information Document
Title : NO. DateSHT/SHTS : 3/112. PRODUCT SPECIFICATION2.1 Scope of RKE, Body Control Module2.1.1 Folding TX KEY : It has the RKE functions.Data is transmitted with radio frequency2.1.2 BCM(RX) : ECU is control the whole BCM funtion with RKE2.2 SPECIFICATIONS2.2.1 Transmitter2.2.2 RECEIVER Battery life 2 Year(10Times/Day)(Lithium 3V 1EA) Electric field strength 10mW (433.92MHz) Code Rolling Code(Hopping Algorithm)Operating voltage range DC 2.5 ~ 3.2VITEMSPECIFICATIONRated supply voltage DC 3V Operating temperature range - 10 ~ + 60℃ with Battery Frequency 433.92MHz Storage temperature range - 30 ~ + 85℃ without Battery Modulation FSKBelow than 5.5mA Operating Temperature - 30 ~ + 80℃Max Humidity 95% Standby Current (in alarm setting condition)SpecificationItem DC 9 ~ 16V Operating Voltage DC 12V Rated Supply Voltage Information Document
Title : NO. DateSHT/SHTS : 4/112.3 Operating summary-RKE①TRANSMITTER's button is pushed.②TRANSMITTER sends the code by radio frequency.③RECEIVER gets the code and decodes it.④RECEIVER judges the code whether it is right code or not.⑤RECEIVER checks door lock or unlock, trunk state.⑥RECEIVER drives the actuator.2.3.1 LOCK & UNLOCK ①If LOCK or UNLOCK button is pushed for less than 1 sec, then TRANSMITTER sends the LOCK or UNLOCK DATA.②If TRUNK button is pushed for more than 1 sec, then TRANSMITTER sends the TRUNK DATA.③If PANIC button is pushed for more than 1 sec, thed TRANSMITTER sends the PANIC DATA.2.4 Caution①Danger of explosion if battery is incorrectly replaced.②Replace only with the same or equivalent type recommended by the manufacturer.③Dispose of used batteries according to the manufacturer's instructions.Information Document
Title : NO. DateSHT/SHTS : 5/113. USER MANUAL3.1 ITEM : Body Control Module- This system is BCM and inculdes RKE. - RKE in BCM system is intended for auto door lock or unlock or TRUNK in vehicle. - This BCM system is to be installde on motor vehicles as *OE item.*OE : Original Equipment.*BCM : Body Control Module*RKE : Remote Keyless Entry.3.2 SYSTEM CONSTRUCTION3.2.1 SYSTEM IN VEHICLE3.2.2 SYSTEM FOR TEST①if press button on the transmitter, RF signal is transmitted and turns on the LED* It shows the status of operation through the LED used.Information DocumentInformation DocumentInformation DocumentInformation DocumentRadio Frequency(433.92MHz)ANTENNABATTERYBCMRadio Frequency(433.92MHz)
Class B FCC Information to User This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is con-nected. • Consult the dealer or an experienced radio/TV technician for help. Caution Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC Compliance Information : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation

Navigation menu