UserManual.pdf
Security-Vision-Systems MxDisplay with RFID and WiFi for MOBOTIX Door Stations and Video Systems MOBOTIX MxDisplay MX-Display1-EXT (available in black or white) Federal Communications Commission (FCC) and Industry Canada (IC) Notice for MX-Display1-EXT (M/N: MX-Display) (FCC ID: YYRDISPA, IC ID: 9357A-DISPA) NOTICE: This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTICE: Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radio exempts de licence. L‘exploitation est autorisée aux deux conditions suivantes: (1) l‘appareil ne doit pas produire de brouillage, et (2) l‘appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d‘en compromettre le fonctionnement. NOTICE: Changes or modifications made to this equipment not expressly approved by MOBOTIX AG may void the FCC authorization to operate this equipment. NOTICE: This Class B digital apparatus complies with Canadian ICES-003. NOTICE: Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • • • • Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Ministry of Internal Affairs and Communications Notice for MX-Display1-EXT NOTICE: www.mobotix.com • This device has been granted a designation number by Ministry of Internal Affairs and Communications. • This device should not be modified (otherwise the granted designation number will be invalid). Innovations - Made in Germany The German company MOBOTIX AG is known as the leading pioneer in network camera technology and its decentralized concept has made high-resolution video systems cost-efficient. MOBOTIX CORP • Manhattan (NY) • Phone: 888-MOBOTIX (662 6849) • us-sales@mobotix.com • Made in Germany 32.107_US_V1_09/2014 US MX-Display1-EXT MxDisplay: Regulatory Notice US MxDisplay: Conformity Declaration of Conformity Hersteller: Manufacturer: MOBOTIX AG Produkt: Netzwerk-Display Produit : Affichage de réseau Fabricant : Product: Network display Typ: MX-Display1-EXT Type: Type : Bei bestimmungsgemäßer Verwendung erfüllt das bezeichnete Produkt die Bestimmungen gemäß Artikel 3 der R&TTE-Richtlinie 1999/5/EG. The product identified above complies with the essential requirements of article 3 of the guideline R&TTE 1999/5/EG. Le produit désigné ci-dessus est conforme aux exigences fondamentales de l’article 3 de la directive R&TTE 1999/5/EG. Angewendete harmonisierte Normen: Harmonised standards applied: Safety EN 60950-1:2006/A11:2009/ A1:2010/A12:2011 EMC EN 301 489-1 (V1.9.2) Normes harmonisées : EN 301 489-3 (V1.4.1) ERM-SRD EN 300 330-1 (V1.7.1) EN 300 330-2 (V1.5.1) Weitere angewendete Normen: CFR 47, FCC Part 15B, Part 15C Autres normes harmonisées : RSS 210 Issue 8 Other harmonised standards applied: 2014 • Declaration of Conformity: www.mobotix.com > Support > Media Library > Certificates Security-Vision-Systems Japan IFERW MOBOTIX AG Kaiserstrasse 67722 Langmeil Germany Adresse: Address: Adresse: + TK-Nr. / Phone number / N° de communication : Fon: Fax: E-Mail: +49 6302 981 6-103 +49 6302 981 6-190 us-sales@mobotix.com Langmeil, September 22, 2014 Dr. Oliver Gabel CTO, MOBOTIX AG Ort, Datum Name und Unterschrift Lieu et date Nom et signature Name and signature Notes • This product must not be used in locations exposed to the dangers of explosion. • Please follow the notes on installing and operating the device in the MOBOTIX MxDisplay Quick Install and the MxDisplay Quick Guide documents (www.mobotix.com in the Support > Manuals section). • The MxDisplay is only to be used together with the MOBOTIX original frames and the in-wall and on-wall housings. • Electrical installation: Electrical systems and equipment may only be installed, modified and maintained by a qualified electrician or under the direction and supervision of a qualified electrician in accordance with the applicable electrical guidelines. Make sure to properly set up all electrical connections. • Network security: MOBOTIX products include all of the necessary configuration options for operation in Ethernet networks in compliance with data protection laws. The operator is responsible for the data protection concept across the entire system. The basic settings required to prevent misuse can be configured in the software and are password-protected. This prevents unauthorized parties from accessing these settings. • Make sure the device is not operated outside of its operating temperature range of 0 to +40 °C/+32 to +104 °F. Dimensions Back www.mobotix.com 99 mm/3.9 in 99 mm/3.9 in Innovations - Made in Germany The German company MOBOTIX AG is known as the leading pioneer in network camera technology and its decentralized concept has made high-resolution video systems cost-efficient. MOBOTIX CORP • Manhattan (NY) • Phone: 888-MOBOTIX (662 6849) • us-sales@mobotix.com • Made in Germany Copyright © MOBOTIX AG 2014 • Made in Germany • Technical information subject to change without notice. Place & date of issue
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.7 Linearized : Yes Author : Thilo Schüller Create Date : 2014:09:29 10:19:25+02:00 Modify Date : 2014:11:11 15:07:21+01:00 XMP Toolkit : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04 Format : application/pdf Rights : Copyright © MOBOTIX AG, 2013 Creator : Thilo Schüller, MOBOTIX AG Title : BellRFID: Regulatory Notice/Declaration of Conformity Metadata Date : 2014:11:11 15:07:21+01:00 Creator Tool : Adobe InDesign CC 2014 (Macintosh) Instance ID : uuid:852c0b93-03b9-4dea-804f-218e679f855b Original Document ID : xmp.did:0780117407206811AB08A3F0AEF9B5E5 Document ID : xmp.id:4470c5fd-5962-4f17-b282-ad1a74d60c11 Rendition Class : proof:pdf Derived From Instance ID : xmp.iid:8e75d14b-d6c5-4cbb-abd5-2d6cc928af82 Derived From Document ID : xmp.did:FC7F11740720681197A58AEB88B97BDA Derived From Original Document ID: xmp.did:0780117407206811AB08A3F0AEF9B5E5 Derived From Rendition Class : default History Action : converted History Parameters : from application/x-indesign to application/pdf History Software Agent : Adobe InDesign CC 2014 (Macintosh) History Changed : / History When : 2014:09:29 10:19:25+02:00 Caption Writer : Thilo Schüller; MOBOTIX AG Marked : True Producer : Adobe PDF Library 11.0 Trapped : False Page Layout : TwoPageRight Page Count : 2EXIF Metadata provided by EXIF.tools