MOBOTIX KPADB RFID access control system User Manual Reg Notice Keypad

MOBOTIX AG RFID access control system Reg Notice Keypad

Contents

Reg_Notice_Keypad

The HiRes Video Company
US
www.mobotix.com
HiRes Video Innovations
The German company MOBOTIX AG is known as the leading pioneer in network camera technology and its
decentralized concept has made high-resolution video systems cost-ecient.
MOBOTIX CORP • Manhattan (NY) • Phone: 888-MOBOTIX (662 6849) • us-sales@mobotix.com • Made in Germany
KeypadRFID: Regulatory Notice
Federal Communications Commission (FCC) and Industry Canada (IC)
Notice for MX-Keypad1-EXT (M/N: Keypad-B)
(FCC ID: YYRKPADB, IC ID: 9357A-KPADB)
NOTICE:
This device complies with Part 15 of the FCC Rules [and with ICES-003 of Industry Canada]. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that may cause undesired operation.
NOTICE:
Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radio exempts de
licence. L‘exploitation est autorisée aux deux conditions suivantes:
(3) l‘appareil ne doit pas produire de brouillage, et
(4) l‘utilisateur de l‘appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d‘en compromettre le fonctionnement.
NOTICE:
Changes or modifications made to this equipment not expressly approved by MOBOTIX AG may void the FCC
authorization to operate this equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Radiofrequency Radiation Exposure Information:
The radiated output power of the device is far below the FCC radio frequency exposure limits. Nevertheless,
the device shall be used in such a manner that the potential for human contact during normal operation is
minimized.
Ministry of Internal Aairs and Communications Notice for
MX-Keypad1-EXT
NOTICE:
• This device has been granted a designation number by Ministry of Internal Aairs and Communications
• This device should not be modified (otherwise the granted designation number will be invalid)
Keypad with Contactless
RFID Technology
MOBOTIX KeypadRFID
MX-Keypad1-EXT
(in triple frame silver)
RFID cards
for keyless entry
IP Video Door Station
MX-Keypad1-EXT
31.287_US_V3_07/2013
Weatherproof (IP65)
–30 to +60°C/–22 to +140°F
The HiRes Video Company
US
www.mobotix.com
HiRes Video Innovations
The German company MOBOTIX AG is known as the leading pioneer in network camera technology and its
decentralized concept has made high-resolution video systems cost-ecient.
MOBOTIX CORP • Manhattan (NY) • Phone: 888-MOBOTIX (662 6849) • us-sales@mobotix.com • Made in Germany
KeypadRFID: Conformity
2013 • Declaration of Conformity: www.mobotix.com> Support> Media Library> Certificates
Copyright © MOBOTIX AG 2013 • Made in Germany • Technical information subject to change without notice.
Hersteller
Manufacturer:
Fabricant:
MOBOTIX AG
Produkt:
Product:
Produit:
MxBus-Modul
MxBus module
Module MxBus
Typ:
Type:
Type:
MX-Keypad1-EXT
Bei bestimmungsgemäßer Verwendung erfüllt das bezeichnete Produkt die Bestimmungen gemäß
Artikel 3 der R&TTE-Richtlinie 1999/5/EG.
The product identified above complies with the essential requirements of article 3 of the guideline R&TTE 1999/5/EG.
Le produit désigné ci-dessus est conforme aux exigences fondamentales de l’article 3 de la directive R&TTE 1999/5/EG.
Angewendete harmonisierte Normen:
Harmonised standards applied:
Normes harmonisées:
Safety EN 60950-1:2006/A11:2009/
A1:2010/A12:2011
Health EN 62311:2008
EMC EN 301 489-1 (V1.9.2)
EN 301 489-3 (V1.4.1)
ERM-SRD EN 300 330-1 (V1.7.1)
EN 300 330-2 (V1.5.1)
Weitere angewendete Normen:
Other harmonised standards applied:
Autres normes harmonisées:
FCC Part 15B, Part 15C
RSS 210
Item 3 of Article 44-1 of the Radio Ordinance
Adresse:
Address:
Adresse:
MOBOTIX AG
Kaiserstrasse
67722 Langmeil
Germany
+ TK-Nr.
Phone number
N° de communication:
Fon:
Fax:
E-Mail:
+49 6302 981 6-103
+49 6302 981 6-190
us-sales@mobotix.com
Langmeil, July 23, 2013
Ort, Datum
Place & date of issue
Lieu et date
Dr. Ralf Hinkel
CEO, MOBOTIX AG
Name und Unterschrift
Name and signature
Nom et signature
Notes
• Please follow the notes on installing and operating the device in the
MOBOTIX T24 System Manual
(www.mobotix.com in the Support> Manuals section).
• The MOBOTIX KeypadRFID is only to be used in the original frames of the IP Video Door Station.
• Before Installing, make sure that the seal on the back of the KeypadRFID has been properly attached.
• When inserting the module into the frame, only press at the edge, never at the center of the module.
•
Make sure the device is not operated outside of its operating temperature range of –30 to +60°C/–22 to +140°F.
99mm/3.9in
99mm/3.9in
Declaration of Conformity
Dimensions Back

Navigation menu