MOBOTIX KPADB RFID access control system User Manual Keypad Quick Install

Download:
Mirror Download [FCC.gov]
Document ID	2027395
Application ID	TO3AMGDx+JSLMFgEsWXKlQ==
Document Description	User manual Keypad
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	41.08kB (513560 bits)
Date Submitted	2013-07-29 00:00:00
Date Available	2013-09-30 00:00:00
Creation Date	2013-07-22 11:03:55
Producing Software	Adobe PDF Library 10.0.1
Document Lastmod	2013-07-22 11:04:14
Document Title	Keypad: Quick Install
Document Creator	Adobe InDesign CS6 (Macintosh)
Document Author:	Thilo Schüller

EN
Quick Install
MX-Keypad1-EXT
KeypadRFID
The HiRes Video Company
Keypad with Contactless
RFID Technology
5)
proof (IP6
Weather
to +140°F
/–
°C
–30 to +6
RFID cards
for keyless entry included
(1 admin card, 5 user cards)
• Keypad module with 1 admin and 5 user RFID cards
• Mailbox control
• Integrated RFID technology for keyless entry
• Available colors: white, silver, dark gray, black, amber
• Up to 60 hrs backup power supply using DoorMaster
(accessory)
Module for MOBOTIX IP Video Door Station
Keyless access to buildings using RFID transponder
card or PIN code
Standard Connection: KeypadRFID with
IP Video Door Station, InfoModule and DoorMaster
Outdoor
IP Video Door Station
Indoor
Door
Door opener, door sensor, lock sensor
(YSTY 0.8 mm – max. length: 50 m/55 yd)
DoorMaster
KeypadRFID
InfoModule
MxBus (YSTY 0.8 mm – max. length: 50 m/55 yd)
Theft protection (YSTY 0.8 mm – max. length: 50 m/55 yd)
For additional information on the other connection variants and for installing,
see the T24 System Manual Part 1 on www.mobotix.com > Support > Manuals.
Back view with cover removed
Sealing plug
Seal
I/O terminal
MxBus terminal
Installing the KeypadRFID
Installing the module follows the procedure described in the T24 System Manual
Part 1, in Section 2.4.2, "Installing the KeypadRFID". For more information on other
connection variants (e.g. without DoorMaster), please see Section 2.1, "Overview:
Connection and Wiring Diagrams".
Click
When installing the module in the frame, make sure that you insert the right side
of the module first and then press on the left edge (and not on the center) to
click the module into place.
Operation
After installing, make sure that you follow the steps in the T24 System Manual Part 2 in Section 2, "Initial Operation
without PC". This chapter shows you how to configure the entire system (including the RFID admin and user cards)
in a few simple steps.
Replacing the KeypadRFID
If the KeypadRFID needs to be replaced against all expectations, you need a current backup of the system
configuration. This will ensure that you can seamlessly integrate the new KeypadRFID into the system later on.
Please follow the steps outlined in the T24 System Manual Part 2 in Section 5.2, "Backup & Restore".
www.mobotix.com
To dismount the KeypadRFID, follow the steps in the T24 System Manual Part 1 in Section 2.4.6, "Removing and
Exchanging Modules". Make sure that you deactivate the theft protection before dismounting the module and
that you activate the theft protection again after re-installing.
HiRes Video Innovations
The German company MOBOTIX AG is known as the leading pioneer in network camera technology and its
decentralized concept has made high-resolution video systems cost-efficient.
MOBOTIX AG • D-67722 Langmeil • Tel: +49 6302 9816-103 • Fax: +49 6302 9816-190 • info@mobotix.com
31.468_EN_V3_07/2013
MOBOTIX KeypadRFID
MX-Keypad1-EXT
(in triple frame silver)
EN
KeypadRFID
Quick Install
Operation: Keys and Signaling
MOBOTIX KeypadRFID
Order no.: MX-Keypad1-EXT
Left LED (green/
red, status LED)
Right LED (blue)
Open door, messages,
doorbell
MOBOTIX RFID cards
Admin card
Order no.: MX-AdminCard1
(1 included)
10-key keypad
User card
Order no.: MX-UserCard1
(5 included)
Leave a message (standard mailbox)1
Open door with blue user card
Press envelope key > welcome message plays > keep
envelope key pressed and leave message
Hold up user card > door is unlocked
Welcome
hold
keep
pressed
Message
Open door with PIN code
Enter PIN code > press key button > door is unlocked
Play back messages*1
Zutritts
PIN
PIN code
Hold up user card > keys 0 to 9 are blinking: 0 to 9 new
messages > play back with key 0 to 9
Open door on power failure (red LED is
blinking)2
Zutritts
PIN
Messages
Record new welcome message for mailbox*1
Press OK/MENU and hold the key > hold up user card >
press bell key > press bell key again > keep envelope
key pressed and leave message > let go of envelope
key > welcome message is activated
Press ESC/ALARM (until illumination is on) > opening door
with card or PIN is now possible for about 10 seconds
ESC
hold (2nd
keepbeep)
pressed
Only in combination with MOBOTIX DoorMaster.
OK
hold
keep
pressed
keep
pressed
Only in combination with MOBOTIX IP Video Door Station.
Technical Specifications
Status LED
Status LED
Interface
MxBus
Inputs
2 galvanically separated inputs
(AC/DC, self-powered, up to 50 V)
Outputs
1 isolated relay output (AC/DC, up
to 50 V/60 W/2 A)
Protection class
IP65 (DIN EN 60529)
Operating
temperature
–30 to +60°C/–22 to +140°F
(DIN EN 50125)
On
Normal status
Power Supply
MxBus
On
Device error
Power consumption
Typically 1 W
RFID cards: Type/
Encryption
MIFARE DESFire EV1
3K3DES/AES
Blinking Power failure
Notes
• Please follow the notes on installing and operating the device in the T24 System Manual (www.mobotix.com in
the Support > Manuals section). This manual also contains wiring diagrams for the different scenarios.
• The MOBOTIX KeypadRFID is only to be used in the original frames of the IP Video Door Station.
• Before Installing, make sure that the seal on the back of the KeypadRFID has been properly attached.
• When inserting the module into the frame, only press at the edges, never at the center of the module.
• Make sure the device is not operated outside of its operating temperature range of –30 to +60°C/–22 to +140°F.
• BellRFID and KeypadRFID can only be used on one MxBus with a later software version of the camera.
Dimensions
Cover
Seal
www.mobotix.com
99 mm/3.9 in
99 mm/3.9 in
Back
HiRes Video Innovations
The German company MOBOTIX AG is known as the leading pioneer in network camera technology and its
decentralized concept has made high-resolution video systems cost-efficient.
MOBOTIX AG • D-67722 Langmeil • Tel: +49 6302 9816-103 • Fax: +49 6302 9816-190 • info@mobotix.com
Copyright © MOBOTIX AG 2013 • Made in Germany • Technical information subject to change without notice.
* Only for cards with activated mailbox feature – see T24 System Manual Part 2, «Adding User Cards»
Function keys
2013 • Declaration of Conformity: www.mobotix.com > Support > MX Media Library > Certificates
The HiRes Video Company

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27
Format                          : application/pdf
Rights                          : Copyright © MOBOTIX AG, 2011
Creator                         : Thilo Schüller, MOBOTIX AG
Title                           : Keypad: Quick Install
Metadata Date                   : 2013:07:22 11:04:14+02:00
Modify Date                     : 2013:07:22 11:04:14+02:00
Create Date                     : 2013:07:22 11:03:55+02:00
Creator Tool                    : Adobe InDesign CS6 (Macintosh)
Instance ID                     : uuid:07e4b2b4-3be1-fe4b-baa8-67d0be52483d
Original Document ID            : xmp.did:0780117407206811AB08A3F0AEF9B5E5
Document ID                     : xmp.id:F70315DD1A2068118C1499C6B7F9869A
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:F60315DD1A2068118C1499C6B7F9869A
Derived From Document ID        : xmp.did:C3B5C07923206811ACAFE57B89ED08EE
Derived From Original Document ID: xmp.did:0780117407206811AB08A3F0AEF9B5E5
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CS6 (Macintosh)
History Changed                 : /
History When                    : 2013:07:22 11:03:55+02:00
Caption Writer                  : Thilo Schüller; MOBOTIX AG
Marked                          : True
Producer                        : Adobe PDF Library 10.0.1
Trapped                         : False
Page Layout                     : SinglePage
Page Count                      : 2
Author                          : Thilo Schüller

EXIF Metadata provided by EXIF.tools