Marson Technology Co MT6337BT BT Barcode Scanner User Manual Users manual3
Marson Technology Co Ltd BT Barcode Scanner Users manual3
Contents
- 1. Users manual1
- 2. Users manual2
- 3. Users manual3
Users manual3
%OXH7RRWKVHWWLQJSLQFRGHDQGGLVFRQQHFWLRQ
%8
/(7
22
7+0
2
'(
/
Ȟȟ
Ȟȟ
Ȟȟ
Ȟȟ
Ȟȟ
Ȟȟ
Ȟȟ
" #" # !
" #" # !
# #" # !
˙
ʥ
"
(+%*'%#,%$
)&
!
'(16,7< 1$552:
PPPLO
:,'(
PPPLO
&+$5*$3
PPPLO
1:
5$7,2
0(',80
'(16,7<
$SSHQGL[
%$5&2'(7(67&+$57
$SSHQGL[
%$5&2'(7(67&+$57
T
his equipment has been tested and found to comply with the
li
mits for a class B digital device, pursuant to part 15 of the FCC
ru
les. These limits are designed to provide to provide reasonable
p
rotection against harmful interference in a residential installation
.
T
his equipment generates, uses and can radiate radio frequency
e
nergy and, if not installed and used in accordance with the
in
stallation. , May cause harmful interference to radio
c
ommunication. However, there is no guarantee that interference
W
ill not occur in a particular installation. if this equipment does
c
ause harmful interference to radio or television reception, which
c
an be determined by turning the equipment off and on, the user
is
e
ncouraged to try to correct the interference by one or more of th
e
fo
llowing measures:
-R
eorient or relocate the receiving antenna
-I
ncrease the separation between the equipment and receiver
-C
onnect the equipment into an outlet on a circuit different from
th
at to which the receiver is connected
-C
onsult the dealer or an experienced radio / TV technician for he
lp
Y
ou are cautioned that changes or modifications not expressly
a
pproved by the party responsible for compliance could void your
a
uthority to operate the equipment. This device complies with par
t
1
5 of the FCC rules. Operation is subject to the following two
c
onditions
(1
) This device may not cause harmful interference and
(2
) This device must accept any interference received, including
in
terference that may cause undesired operation
m
obile devices without co-location condition (the transmitting
a
ntenna is installed or located more than 20cm away from the
b
ody of user and near by person)
F
CC RF radiation exposure statement:
1
. This transmitter must not be co-located or operating in
c
onjunction with any other antenna or transmitter.
2
. This equipment complies with FCC RF radiation exposure limit
s
s
et forth for an uncontrolled environment. This equipment should
b
e installed and operated with a minimum distance of 20
c
entimeters between the radiator and your body.
Industry Canada - Class B
This digital apparatus does not exceed the Class B limits for
radio noise emissions
from digital apparatus as set out in the interference-causing
equipment standard
entitled “Digital Apparatus,” ICES-003 of Industry Canada.
Cet appareil numérique respecte les limites de bruits
radioélectriques applicables
aux appareils numériques de Classe B prescrites dans la norme
sur le matérial
brouilleur: “Appareils Numériques,” NMB-003 édictée par
l’Industrie.
(1) this device may not cause interference,and (2) this device
must accept any
interference, including interference that may cause undesired
operation of the device."
FCC RF radiation exposure statement:
1.this transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter .
2.this equipment complies with FCC RF radiation exposure limits set
forth for an uncontrolled environment . this device was tested for typical
lap held operations with the device contacted directly to the human body
to the back side of the Bluetooth barcode scanner. to maintain
compliance with fcc rf exposure compliance requirements. Avoid direct
contact to the transmitting antenna during transmitting.
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the installation. , May cause harmful
interference to radio communication. However, there is no guarantee that interference
Will not occur in a particular installation. if this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
-Reorient or relocate the receiving antenna
-Increase the separation between the equipment and receiver
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
-Consult the dealer or an experienced radio / TV technician for help
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
FCC RF radiation exposure statement:
1. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 centimeters between the radiator and your body.