Mascot Electric MX-UF1 Wireless Microphone Transmitter User Manual

Mascot Electric Co., Ltd. Wireless Microphone Transmitter

USERS MANUAL

Download: Mascot Electric MX-UF1 Wireless Microphone Transmitter User Manual
Mirror Download [FCC.gov]Mascot Electric MX-UF1 Wireless Microphone Transmitter User Manual
Document ID79799
Application IDMjcahW7K6Ax0V+e6hagwZg==
Document DescriptionUSERS MANUAL
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize5.86kB (73296 bits)
Date Submitted2000-01-05 00:00:00
Date Available2000-02-15 00:00:00
Creation Date1999-12-02 20:45:29
Producing SoftwareAcrobat PDFWriter 4.0 for Windows
Document Lastmod1999-12-02 09:03:42
Document Title穨Untitled
Document Creator穨全能影像經理 - Inbox
Document Author: 穨ivy

EXHIBIT C
User Manual
MICROPHONE UHF BAND
WIRELESS MICROPHONE SYSTEM
99 T
HANDHELD MICROPHONE . .
1.Screen Head
2,L0w Battery Led Indicator
3,0N/OFF Switch
4.Mic Housing
5,Battery Housing
6.Battery Cover
[Antenna
TIE CLIP MICROPHONE
irANTENNA
2.0N/STB/OFF Switch
3.Mic Unit
4.119 Clip
5 Cable
6. Gain Adi.
7,9V Battery
8.Baltery Cover
NOTE
THE WIRELESS HANDHELD OR LAVALIER MICROPHONE, TWO OR ABOVE WIRELESS MICROPHONE WHICH
TRANSMIT AT THE SAME FREQUENCY CAN NOT BE USED AT THE SAME TIME & AREA.
TROUBLE SHOOTING:
Please take time to read this manual before asking after service, and check following points. If it also has unusual things
please contact with purchasing store. We are sincerely to serve for you.
i.Betore connecting and operating the unit. check the voltage setting conforms to the voltage available In your area.
2. It the LED indicator on Ilgm means that power supply is in need of replacement. Please replace one new 9V battery an
be surethe polarity(+)(—) of battery is oonnected properly.
3.3ignal dropouts and noise may he suddenly encountered by interruption trom outside. too long distance between
microphone and receiver or battery in low power, In such a case. adjust receiver antenna or change new battery
4.Do not dmp the microphone on a hard concrete floor. nor strike the microphone head tront with a list or fingers. nor blow
a breath strongly into the microphone head front.
5.Take out the battery in microphone if not used tor along time. This will prevent tram the damage that a detective
"leaking" battery may cause.
DESIGN AND SPECIFICATIONS SUBJECT TO BE CHANGED WITHOUT NOICE. 440 ”09 E
illiCROPHONE UHF HIGH BAND
WIRELESS MICROPHONE SYSTEM
FEATURE
High sensitivity urdioid capsule foryour proleesional use.
Special noise absorption parts inside the barrels, which eliminate switch shock noise and handling noise.
Frequency with quartz locked control.
Easyoperling battery compartment for quick battery replacement. Power by one 9V battery
Low battery LED indicator.
The Lavalier microphone is easy for use clip on the belt & very light. it can be used with headset mic w/3.5rnm screw
type plug easily.
P’SnPPNr‘
SPECIFICATION
- Carrier Frequency Range mas, eoo. QDOMHz. UHF band
~ Tone Signal : BZKHZ (tor tone squelch control)
' RF Power output : aomw (MAX)
~ Spurious Emission : Less than 43m! below carrier frequency.
' Frequency Stability : Within 0.005% with quartz controlled
‘ Antenna : aulit in.
" Pie-Emphasis : 50 u s.
' AF Reponse : 40Hz to 20KHz (+1443)
‘ Maximum Dswiatlcn : 15KHz within limiting compressor.
' Signal to Noise Ratio : autism-Weighted).
- Microphone Capsule : Unt-ulrectional dynamic microphone or
Uni—directional electret condenser microphone
' Operating voltage : Handheld Mte : DC1.5Vx2 (Ur/la type)
We Clip Mic: Standard w battery
* Current consumption : About osmA (Max.)
" Battery iile : Over e~a hours continuous operation by Alkaline Battery
‘ LED Indicator : Power 0n-0tr and low battery
* Dimensions : Handheld Mia: 55 (a (D) x 280(L) mm
11e clip Mic. 0(W)x1OS(L)x25(H) mm
OPERATION
1. Open the battery cover and insert banery into the battery house according (+) and (-) indication marked on the battery
house.
2. Fit battery cover back.
3. Screw the Antenna on the transmitter.
4. Push the power switch ON. the LED indicator will (lash to indicator the carrier frequency is sending out. The
microphone is ready for use.
salvitch the power "ON", the LED Indicator flashing means that power suppty is normal. If the LED indicate on light
means that the battery is in need of replacement. if no flashing, it must be no battery in there or battery is not properly
inserted
6. Push the power button to "OFF" when mic is not used, and remove the battery in miuophone if not used for along time.
This will prevent any damage a defective "taking" battery may cause.
7.Using Tie Clip microphone. please screw the 3.5mm plug of Iavaiier mic on the 3.5mm jack of the transmitter,
Mo-Utw-E

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Creator                         : .穨.全能影像經理 - Inbox
Create Date                     : 1999:12:02 20:45:29
Title                           : .穨.Untitled
Author                          : .穨.ivy
Producer                        : Acrobat PDFWriter 4.0 for Windows
Modify Date                     : 1999:12:02 09:03:42+08:00
Page Count                      : 3
EXIF Metadata provided by EXIF.tools
FCC ID Filing: JEBMX-UF1

Navigation menu