Metra Electronics Car Stereo System Gmos 04 Users Manual

GMOS-04 to the manual 8869c5f4-e02a-410d-b521-42ffff6f3a44

2015-02-09

: Metra-Electronics Metra-Electronics-Metra-Electronics-Car-Stereo-System-Gmos-04-Users-Manual-555309 metra-electronics-metra-electronics-car-stereo-system-gmos-04-users-manual-555309 metra-electronics pdf

Open the PDF directly: View PDF PDF.
Page Count: 4

DownloadMetra-Electronics Metra-Electronics-Metra-Electronics-Car-Stereo-System-Gmos-04-Users-Manual-  Metra-electronics-metra-electronics-car-stereo-system-gmos-04-users-manual
Open PDF In BrowserView PDF
GM ONSTAR CLASS II DATA BUS INTERFACE

GMOS-04
INSTALLATION INSTRUCTIONS

* READ IMPORTANT WARNING ON PAGE 1
BEFORE ATTEMPTING ANY INSTALLATION
THE GMOS-04 IS DESIGNED TO BE USED WITH VEHICLES THAT HAVE A FACTORY AMPLIFIED SYSTEM
INCLUDING THE BOSE AUDIO SYSTEMS. BESIDES
RETAINING THE ONSTAR SYSTEM, THE GMOS-04 WILL
ALSO RETAIN THE WARNING CHIMES THAT WILL BE
LOST WHEN THE FACTORY RADIO IS REMOVED. THE
GMOS-04 WILL ALSO PROVIDE A 12 VOLT SWITCHED
WIRE FOR PROPER RADIO OPERATION. THE GMOS-04
NOW PROVIDES MUTE, PARKING BRAKE, VSS OR
SPEED SENSE, AND A REVERSE OUTPUT TO MAKE
INSTALLING AN AFTERMARKET NAVIGATIONAL RADIO
SIMPLER AND LESS TIME CONSUMING.

• SEE APPLICATIONS LIST INSIDE •
TOOLS REQUIRED FOR INSTALLATION
• Cutting Tool • Tape • Crimping Tool
• Connectors (ie: butt-connectors, bell caps, etc.)

REV. 03/19//07

1-800-221-0932

INSTGMOS-04

www.metraonline.com

©Copyright 2004-2007 Metra Electronics Corporation

GMOS-04

* IMPORTANT WARNING
THIS PRODUCT INCLUDES INSTRUCTIONS FOR INSTALLATION WHICH MUST
BE CAREFULLY FOLLOWED. THE INSTRUCTIONS ARE WORDED IN SUCH A
MANNER TO ASSUME THAT THE INSTALLER IS CAPABLE OF COMPLETING
THESE TYPE OF ELECTRONIC INSTALLATIONS. IF YOU ARE UNCLEAR AS TO
WHAT YOU ARE INSTRUCTED TO DO OR BELIEVE THAT YOU DO NOT UNDERSTAND THE INSTRUCTIONS SO AS TO PROPERLY AND SAFELY COMPLETE
THE INSTALLATION YOU SHOULD CONSULT A TECHNICIAN WHO DOES HAVE
THIS KNOWLEDGE AND UNDERSTANDING. FAILURE TO FOLLOW THESE
INSTRUCTIONS CAREFULLY AND TO INSTALL THE INTERFACE AS
DESCRIBED COULD CAUSE HARM TO THE VEHICLE OR TO SAFETY
SYSTEMS ON THE VEHICLE. INTERFERENCE WITH CERTAIN SAFETY
SYSTEMS COULD CAUSE HARM TO PERSONS AS WELL. IF YOU HAVE ANY
QUESTIONS IN THIS REGARD PLEASE CALL THE HELP LINE OR THE
METRA AT 1-800-221-0932 FOR ASSISTANCE.

1

GMOS-04

IMPORTANT

APPLICATIONS

4. Connect the Green/Purple wire to the reverse wire of the aftermarket radio.

• THE BROWN LOOP ON THE 16 PIN HARNESS MUST BE CUT THEN TAPED UP.
PLEASE REFER TO THE ONSTAR LEVEL AJUSTMENT SECTION FOR FURTHER
DETAILS ABOUT THE BROWN WIRE.

• When completed, plug the 14 pin harness into the GMOS-04.

1. With all connections completed to the aftermarket radio, plug the 24 pin and
the 12 pin connectors into the vehicles corresponding wiring harnesses.

H2 2003-07

CONNECTIONS TO BE MADE ON THE
24 PIN GRAY HARNESS:

ESCALADE 2003-06

H3 2006-07

1. Connect the yellow wire to the radio’s 12V battery or memory wire.

ESCALADE EXT 2003-06

ISUZU

CHEVROLET

ASCENDER 2003-07

2. Connect the red wire to the radio’s ignition or accessory wire.

3. Cycle the key by turning the ignition on then back off, then back on again
to test the radio.

AVALANCHE 2003-06

OLDSMOBILE

CAVALIER 2000-05

ALERO 2001-04

IMPALA 2000-05

BRAVADA 2002-05

MALIBU 2002-03

INTRIGUE 2002

MALIBU CLASSIC 2004

SILOUETTE 2000-04

MONTE CARLO 2000-05

PONTIAC

SILVERADO 2003-06

AZTEC 2001-05

SILVERADO CLASSIC 2007

GRAND AM 2001-05

SSR 2003-06

GRAND PRIX 2004-06

SUBURBAN 2003-06

SUNFIRE 2000-05

TAHOE 2003-06

SAAB

TRAILBLAZER 2002-07

9-7x 2005-07

BUICK

GMC

ALLURE 2005-07

ENVOY 2002-07

CENTURY 2004-05

SAVANA 2003-07

RAINIER 2004-07

SIERRA 2003-06

RENDEZVOUS 2002-07

YUKON/XL/DENALI 2003-06

TERRAZA 2005-07

HUMMER

CADILLAC

VENTURE 2000-05

3. Connect the black wire to the radio’s ground wire.
4. Connect the orange wire to the radio’s illumination wire. If the wire is not
present, tape up wire.
5. Connect the orange/white wire to the radio’s dimmer wire. If the wire is not
present, tape up wire.
• When completed, plug the 16 pin harness into the GMOS-04.

CONNECTIONS TO BE MADE ON THE
14 PIN HARNESS
1. Connect the blue/white wire to the radio’s AMP turn-on wire.
2. Connect the red wire to the radio’s Igniton or accessory wire.
3. Connect the RCA cables to the radio’s RCA outputs. If no RCA outputs are
available, use the Metra line output converter part #ALO-648 (SOLD SEPARATELY).

INTERFACE COMPONENTS
• GMOS-04 Data Interface
• 14 pin harness with RCA’S
• 16 pin harness to 24 pin GM harness and 12 pin Onstar harness

WIRING UP THE GMOS-04
* Important: Before beginning any of the following, disconnect the negative
battery terminal to prevent accidental short circuit.
**Note: The ignition power source of most GM vehicles keep the radio on until
one of the doors is opened. This is called the R.A.P. (retained accessory power).
The GMOS-04 is designed to retain this feature.

2

4. The white RCA goes to the left front RCA output of the radio.
5. The gray RCA goes to the front right RCA output of the radio.
6. The green RCA goes to the left rear RCA output of the radio.
7. The purple RCA goes to the right rear RCA output of the radio.

INSTALLING THE GMOS-04
2. Reconnect the negative battery terminal.

TESTING THE GMOS-04
1. Turn the ignition on then the radio to verify the radio works. Check balance
and fader controls for proper operation. If controls are backwards, check to
see if the RCA’s are in the correct location.
2. Push the Onstar button to verify Onstar is working. the radio will shut off and
Onstar will be heard through the left front speaker. Turn off Onstar and the
radio will turn back on.

ONSTAR LEVEL ADJUSTMENT
To adjust the Onstar volume level find the BROWN wire that you cut on the 16 pin
harness, you will use the BROWN wire that is by itself, with no other wire with it.
Push the blue Onstar button, while the voice is speaking tap the BROWN wire to
ground. There are 4 volume settings for Onstar; once the 4th setting is reached
and the BROWN wire is tapped to ground it will automatically go back to the first
volume setting. Once the volume is set it will stay at that volume until the BROWN
wire is tapped to ground again. This can be set during installation and then left
alone. If user adjustment is desired, a momentary contact switch (sold separately)
can be added. Connect one terminal from the switch to ground and the other terminal to the brown wire. The volume will change one level every time the switch
is pressed.

The following wires on the 14 pin harness are for the aftermarket radios that
have navigation built in:
1. Connect the Brown wire to the mute wire of the aftermarket radio..
2. Connect the Green wire to the parking brake wire of the aftermarket radio..
3. Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
radio.

3

4

GMOS-04

TOUBLESHOOTING:
Chime Too Loud/Soft:
There are some instances where the chime is too loud or too soft.
To resolve this follow these steps:
1. Make sure the ignition is turned to the “off” position.
2. Disconnect the 14 pin and 16 pin wire harnesses from the GMOS-04
3. Open up the GMOS-04 by squeezing the sides of the top cover
4. Locate the potentiometer facing up on the circuit board, this is the
Chime potentiometer
5. Taking a small flat headed screwdriver, turn the potentiometer clockwise
to decrease the chime level; turning the potentiometer counterclockwise
will increase the chime level
6. After adjustment replace top cover of GMOS-04 and reconnect
wire harnesses

Distorted Audio Output:
When using the GMOS-04 with a radio that has a high pre-out voltage,
usually greater than 2 volts, the audio signal may become distorted.
To resolve this follow these steps:
1. Make sure the ignition is turned to the “off” position
2. Disconnect the 14 pin and 16 pin wire harnesses from the GMOS-04
3. Open up the GMOS-04 by squeezing the sides of the top cover
4. Locate the potentiometer next to the 10 pin board mounted connector
located at the end of the GMOS-04
5. Taking a small flat headed screwdriver, turn the potentiometer counterclockwise to lower the input level going to the factory amplifier
6. After adjustment replace top cover of GMOS-04 and reconnect wire
harnesses.

5



Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Create Date                     : 2007:06:03 21:37:34Z
Modify Date                     : 2007:08:28 16:39:01-04:00
Page Count                      : 4
Creation Date                   : 2007:06:03 21:37:34Z
Mod Date                        : 2007:08:28 16:39:01-04:00
Producer                        : Acrobat Distiller 5.0.5 (Windows)
Author                          : techscan
Metadata Date                   : 2007:08:28 16:39:01-04:00
Creator                         : techscan
Title                           : 
Page Mode                       : UseOutlines
Page Layout                     : SinglePage
EXIF Metadata provided by EXIF.tools

Navigation menu