Metra Electronics Car Stereo System Gmos 04 Users Manual

GMOS-04 to the manual 8869c5f4-e02a-410d-b521-42ffff6f3a44

: Metra-Electronics Metra-Electronics-Metra-Electronics-Car-Stereo-System-Gmos-04-Users-Manual-555309 metra-electronics-metra-electronics-car-stereo-system-gmos-04-users-manual-555309 metra-electronics pdf

Open the PDF directly: View PDF .
Page Count: 4

GM ONSTAR CLASS II DATA BUS INTERFACE

©Copyright 2004-2007 Metra Electronics Corporatio

n

1-800-221-0932 www.metraonline.co

m

GMOS-04

INSTALLATION INSTRUCTIONS

* READ IMPORTANT WARNING ON PAGE 1

BEFORE ATTEMPTING ANY INSTALLATION

• SEE APPLICATIONS LIST INSIDE •

THE GMOS-04 IS DESIGNED TO BE USED WITH VEHI-

CLES THAT HAVE A FACTORY AMPLIFIED SYSTEM

INCLUDING THE BOSE AUDIO SYSTEMS. BESIDES

RETAINING THE ONSTAR SYSTEM, THE GMOS-04 WILL

ALSO RETAIN THE WARNING CHIMES THAT WILL BE

LOST WHEN THE FACTORY RADIO IS REMOVED. THE

GMOS-04 WILL ALSO PROVIDE A 12 VOLT SWITCHED

WIRE FOR PROPER RADIO OPERATION. THE GMOS-04

NOW PROVIDES MUTE, PARKING BRAKE, VSS OR

SPEED SENSE, AND A REVERSE OUTPUT TO MAKE

INSTALLING AN AFTERMARKET NAVIGATIONAL RADIO

SIMPLER AND LESS TIME CONSUMING.

REV. 03/19//07 INSTGMOS-04

• Cutting Tool • Tape • Crimping Tool

• Connectors (ie: butt-connectors, bell caps, etc.)

TOOLS REQUIRED FOR INSTALLATION

1

* IMPORTANT WARNING

THIS PRODUCT INCLUDES INSTRUCTIONS FOR INSTALLATION WHICH MUST

BE CAREFULLY FOLLOWED.THE INSTRUCTIONS ARE WORDED IN SUCH A

MANNER TO ASSUME THAT THE INSTALLER IS CAPABLE OF COMPLETING

THESE TYPE OF ELECTRONIC INSTALLATIONS. IF YOU ARE UNCLEAR AS TO

WHAT YOU ARE INSTRUCTED TO DO OR BELIEVE THAT YOU DO NOT UNDER-

STAND THE INSTRUCTIONS SO AS TO PROPERLY AND SAFELY COMPLETE

THE INSTALLATION YOU SHOULD CONSULT A TECHNICIAN WHO DOES HAVE

THIS KNOWLEDGE AND UNDERSTANDING. FAILURE TO FOLLOW THESE

INSTRUCTIONS CAREFULLY AND TO INSTALL THE INTERFACE AS

DESCRIBED COULD CAUSE HARM TO THE VEHICLE OR TO SAFETY

SYSTEMS ON THE VEHICLE.INTERFERENCE WITH CERTAIN SAFETY

SYSTEMS COULD CAUSE HARM TO PERSONS AS WELL. IF YOU HAVE ANY

QUESTIONS IN THIS REGARD PLEASE CALL THE HELP LINE OR THE

METRA AT 1-800-221-0932 FOR ASSISTANCE.

GMOS-04

BUICK

ALLURE 2005-07

CENTURY 2004-05

RAINIER 2004-07

RENDEZVOUS 2002-07

TERRAZA 2005-07

CADILLAC

ESCALADE 2003-06

ESCALADE EXT 2003-06

CHEVROLET

AVALANCHE 2003-06

CAVALIER 2000-05

IMPALA 2000-05

MALIBU 2002-03

MALIBU CLASSIC 2004

MONTE CARLO 2000-05

SILVERADO 2003-06

SILVERADO CLASSIC 2007

SSR 2003-06

SUBURBAN 2003-06

TAHOE 2003-06

TRAILBLAZER 2002-07

VENTURE 2000-05

GMC

ENVOY 2002-07

SAVANA 2003-07

SIERRA 2003-06

YUKON/XL/DENALI 2003-06

HUMMER

H2 2003-07

H3 2006-07

ISUZU

ASCENDER 2003-07

OLDSMOBILE

ALERO 2001-04

BRAVADA 2002-05

INTRIGUE 2002

SILOUETTE 2000-04

PONTIAC

AZTEC 2001-05

GRAND AM 2001-05

GRAND PRIX 2004-06

SUNFIRE 2000-05

SAAB

9-7x 2005-07

4. Connect the Green/Purple wire to the reverse wire of the aftermarket radio.

• When completed, plug the 14 pin harness into the GMOS-04.

INSTALLING THE GMOS-04

1. With all connections completed to the aftermarket radio, plug the 24 pin and

the 12 pin connectors into the vehicles corresponding wiring harnesses.

2. Reconnect the negative battery terminal.

3. Cycle the key by turning the ignition on then back off,then back on again

to test the radio.

TESTING THE GMOS-04

1. Turn the ignition on then the radio to verify the radio works. Check balance

and fader controls for proper operation. If controls are backwards, check to

see if the RCA’s are in the correct location.

2. Push the Onstar button to verify Onstar is working. the radio will shut off and

Onstar will be heard through the left front speaker.Turn off Onstar and the

radio will turn back on.

ONSTAR LEVEL ADJUSTMENT

To adjust the Onstar volume level find the BROWN wire that you cut on the 16 pin

harness, you will use the BROWN wire that is by itself, with no other wire with it.

Push the blue Onstar button, while the voice is speaking tap the BROWN wire to

ground.There are 4 volume settings for Onstar; once the 4th setting is reached

and the BROWN wire is tapped to ground it will automatically go back to the first

volume setting. Once the volume is set it will stay at that volume until the BROWN

wire is tapped to ground again.This can be set during installation and then left

alone. If user adjustment is desired, a momentary contact switch (sold separately)

can be added. Connect one terminal from the switch to ground and the other ter-

minal to the brown wire.The volume will change one level every time the switch

is pressed.

GMOS-04

IMPORTANT

• THE BROWN LOOP ON THE 16 PIN HARNESS MUST BE CUT THEN TAPED UP.

PLEASE REFER TO THE ONSTAR LEVEL AJUSTMENT SECTION FOR FURTHER

DETAILS ABOUT THE BROWN WIRE.

CONNECTIONS TO BE MADE ON THE

24 PIN GRAY HARNESS:

1. Connect the yellow wire to the radio’s 12V battery or memory wire.

2. Connect the red wire to the radio’s ignition or accessory wire.

3. Connect the black wire to the radio’s ground wire.

4. Connect the orange wire to the radio’s illumination wire. If the wire is not

present, tape up wire.

5. Connect the orange/white wire to the radio’s dimmer wire.If the wire is not

present, tape up wire.

• When completed, plug the 16 pin harness into the GMOS-04.

4

APPLICATIONS

INTERF

ACE COMPONENTS

CONNECTIONS TO BE MADE ON THE

14 PIN HARNESS

1. Connect the blue/white wire to the radio’s AMP turn-on wire.

2. Connect the red wire to the radio’s Igniton or accessory wire.

3. Connect the RCA cables to the radio’s RCA outputs. If no RCA outputs are

available, use the Metra line output converter part #ALO-648 (SOLD SEPARATELY).

4. The white RCA goes to the left front RCA output of the radio.

5. The gray RCA goes to the front right RCA output of the radio.

6. The green RCA goes to the left rear RCA output of the radio.

7. The purple RCA goes to the right rear RCA output of the radio.

The following wires on the 14 pin harness are for the aftermarket radios that

have navigation built in:

1. Connect the Brown wire to the mute wire of the aftermarket radio..

2. Connect the Green wire to the parking brake wire of the aftermarket radio..

3. Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket

radio.

3

• GMOS-04 Data Interface

• 14 pin harness with RCA’S

• 16 pin harness to 24 pin GM harness and 12 pin Onstar harness

WIRING UP THE GMOS-04

* Important: Before beginning any of the following, disconnect the negative

battery terminal to prevent accidental short circuit.

**Note: The ignition power source of most GM vehicles keep the radio on until

one of the doors is opened.This is called the R.A.P. (retained accessory power).

The GMOS-04 is designed to retain this feature.

2

GMOS-04

TOUBLESHOOTING:

Chime Too Loud/Soft:

There are some instances where the chime is too loud or too soft.

To resolve this follow these steps:

1. Make sure the ignition is turned to the “off” position.

2. Disconnect the 14 pin and 16 pin wire harnesses from the GMOS-04

3. Open up the GMOS-04 by squeezing the sides of the top cover

4. Locate the potentiometer facing up on the circuit board, this is the

Chime potentiometer

5. Taking a small flat headed screwdriver, turn the potentiometer clockwise

to decrease the chime level; turning the potentiometer counterclockwise

will increase the chime level

6. After adjustment replace top cover of GMOS-04 and reconnect

wire harnesses

Distorted Audio Output:

When using the GMOS-04 with a radio that has a high pre-out voltage,

usually greater than 2 volts, the audio signal may become distorted.

To resolve this follow these steps:

1. Make sure the ignition is turned to the “off” position

2. Disconnect the 14 pin and 16 pin wire harnesses from the GMOS-04

3. Open up the GMOS-04 by squeezing the sides of the top cover

4. Locate the potentiometer next to the 10 pin board mounted connector

located at the end of the GMOS-04

5. Taking a small flat headed screwdriver, turn the potentiometer counter-

clockwise to lower the input level going to the factory amplifier

6. After adjustment replace top cover of GMOS-04 and reconnect wire

harnesses.

5