Miele and Cie KG EK037 WLAN Module User Manual Miele EHS Device Specification

Download:
Mirror Download [FCC.gov]
Document ID	3143131
Application ID	BNQbRuG2mtNkMWRn/Q/0jQ==
Document Description	user manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	28.45kB (355624 bits)
Date Submitted	2016-09-22 00:00:00
Date Available	2016-09-22 00:00:00
Creation Date	2016-09-20 16:56:40
Producing Software	Microsoft® Word 2010
Document Lastmod	2016-09-20 16:56:40
Document Title	Miele EHS-Device Specification
Document Creator	Microsoft® Word 2010
Document Author:	flaube

Miele@home
Manual for
EK037
USA/CDN Market
Version 1.3
Manual for EK037 USA/CDN
EK037 WiFi Module
Version: 1.3
Date: 20/09/2016
Revision History
Date
Version
Description
Author
Department
03.09.2015
1.0 Draft
Initial manual for FCC/IC
F. Laube
GTE/SKT
10.06.2016
1.1
Little Changes
F. Laube
GTE/DPS
15.09.2016
1.2
Final Changes
Chr. Bömke
GTE/DPS
20.09.2016
1.3
Integration Changes
L. Merkel
GTE/DPS
Reviewed By
Date
Version
Name
Department
09.09.2014
1.0 Draft
G. Borgelt
GTE/TL
15.09.2016
1.2
G. Borgelt
GTE/TL
L. Merkel
GTE/DPS
G. Borgelt
GTE/TL
20.09.2016
1.3
Approvals
Date
Version
Manual_EK037_USA_CDN_1.3.docx
Name
 2015 Miele&Cie. KG
Department
Page 2 of 7
Manual for EK037 USA/CDN
EK037 WiFi Module
Version: 1.3
Date: 20/09/2016
Contents
1. General
2. Technical data EK037
3. Norms / Standards
3.1
3.2
3.3
3.4
FCC / IC
Safety
RF-Standard
Photos and Labels
4. Regulatory Notice and Integration
4.1 United States (FCC Notice)
4.2 Canada (IC Notice)
4.3 Integration
Manual_EK037_USA_CDN_1.3.docx
 2015 Miele&Cie. KG
Page 3 of 7
Manual for EK037 USA/CDN
EK037 WiFi Module
1.
Version: 1.3
Date: 20/09/2016
General
The EK037 is a wireless network interface module for Miele domestic appliances like hoods, hobs,
cooling devices or washing machines. The module supports the IEEE 802.11 b/g/n Wifi standard. The
EK037 module is designed to solder on PCB during manufacturing. The Module will only be used in
Miele domestic appliances.
3,3V
Voltage
Regulator inside
the SoC)
SingleChip
WIFI
Transceiver
Crystal
Crystal
40MHz
PCB-Antenna
with antennaNetwork
32.768 kHz
Home appliance
Interface
3,3V
EK037
Operational Description
The EK037 is based on CC3200 WiFi SOC Controller and has a board design in stamp form factor.
The Chip controls the IEEE 802.11 RF and handles the WiFi and IP stack. The Chip also handles the
connection to the domestic appliance via a serial link and Miele protocol.
Integration instruction
The EK037 must be integrated under consideration of the technical data. It is not allowed to make any
changes on the module or to use another antenna. The module should be placed in an area with good
RF performance.
2.
Technical data EK037
VCC in V
Current in mA
ambient temperature in°C
Humidity max
Dimensions in mm
Wireless
MCU/RF IC
Input
Antenna type
Antenna gain
Crystal Input Clock
RF Frequency
Channels
Channel Frequencies
Transmission Power
in mW
Manual_EK037_USA_CDN_1.3.docx
3,0 min.
3,3 typical
3,6 max.
200 typical
330 max.
0 – 75
0 – 85 SoC
90%
non condensation
30/27
CC3200r1
double buffered interface (CC3200r1)
PCB inverted F
2 dB
32.768 kHz
40 MHz
2.45 GHz
1 to 11
2,412 GHz – 2,462 GHz
<100
 2015 Miele&Cie. KG
Page 4 of 7
Manual for EK037 USA/CDN
EK037 WiFi Module
Version: 1.3
Date: 20/09/2016
Footprint
3.
Norms / Standards
3.1
FCC / IC
FCC Regulation Part 15.109, Part 15.209 and Part 15.247
IC regulations RSS-Gen Issue 4 and RSS-247
3.2
Safety
UL 60730-1A, CAN/CSA E60730-1:02+A1:2007
CSA Certificate 70009686
3.3
RF-Standard
The modules use the RF standard IEEE 802.11 b/g/n20
Manual_EK037_USA_CDN_1.3.docx
 2015 Miele&Cie. KG
Page 5 of 7
Manual for EK037 USA/CDN
EK037 WiFi Module
3.4
Version: 1.3
Date: 20/09/2016
Photos and Labels
EK037 Top View
4.
Regulatory Notice and Integration
4.1
United States (FCC Notice)
FCC ID: 2ACUWEK037
In accordance with FCC Part 15, the 2ACUWEK037 is listed as a Modular Transmitter Device.
FCC CAUTION:
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with Part 15 of FCC Rules. Operation is Subject to following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received including interference that cause undesired
operation.
FCC STATEMENT:
This equipment has been tested and found to comply within the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
Manual_EK037_USA_CDN_1.3.docx
 2015 Miele&Cie. KG
Page 6 of 7
Manual for EK037 USA/CDN
EK037 WiFi Module
Version: 1.3
Date: 20/09/2016
• Connect the equipment into an outlet on a different circuit from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help.
USERS MANUAL OF THE END PRODUCT:
The end user has to be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this equipment. If the size of
the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required to be
available in the user’s manual: This device complies with Part 15 of FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following “Contains FCC ID:
2ACUWEK037 ". If the size of the end product is larger than 8x10cm, then the following FCC part
15.19 statement has to also be available on the label: This device complies with Part 15 of FCC
rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including interference that may
cause undesired operation.
4.2
Canada (IC Notice)
IC: 5669C-EK037
The term “IC” before the radio certification number only signifies that Industry Canada technical
specifications were met. Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
LABEL OF THE END PRODUCT
The final end product must be labeled in a visible area with the following
“Contains IC : 5669C-EK037".
This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
4.3
Integration
This EK037 Module will only be integrated on our responsibility into Miele appliances/endproducts.
The final products, including the integrated radio module, have to show compliance to the FCC /IC
requirements.
Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment
authorizations (e.g. Verification, Doc) of the final endproducts will be addressed by Miele & Cie. KG.
Manual_EK037_USA_CDN_1.3.docx
 2015 Miele&Cie. KG
Page 7 of 7

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 7
Language                        : de-DE
Tagged PDF                      : Yes
Title                           : Miele EHS-Device Specification
Author                          : flaube
Creator                         : Microsoft® Word 2010
Create Date                     : 2016:09:20 16:56:40+02:00
Modify Date                     : 2016:09:20 16:56:40+02:00
Producer                        : Microsoft® Word 2010

EXIF Metadata provided by EXIF.tools