Miller Edge MGL916 Monitored Gate Link User Manual Layout 1

Miller Edge, Inc. Monitored Gate Link Layout 1

User Manual

2-1. Open and unpack the antenna, batteries, transmitter and receiver units.2-2. Loosen screws from the top cover and remove the lid. 2-3. Route the wires from the monitored edge through the strain relief cable fitting for approximately four inches. Strip the insulation from the two wires back ¼” and secure the wires in the terminal block marked SE 1. (not polarized.)2-4. Place the two AA lithium batteries in their holders in the proper direction, paying attention to the (+) and (-) ends.2-5. Tuck the wires connected to the SE terminal block neatly and pull the excess wire back through the strain relief. Securely tighten the cable fitting.P.O. Box 159 • West Grove, PA 19390 • 800-220-3343 • 610-869-4422 • Fax: 610-869-4423 • www.milleredge.com6809 South Harl Ave., Suite A • Tempe, AZ 85283 • 800-887-3343 • 480-755-3565 • Fax: 480-755-3558MGL-K20_Inst_20151015Model # MGL-K20INSTALLATION  INSTRUCTIONSIMPORTANT: READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATIONKit Contents:1. MGL-TX20 Transmitter unit2. MGL-RX20 Receiver unit3. Receiver antenna 4. (2) AA lithium batteries 5. (4) #6 pan head transmitter mounting screws1-Parts ListPART NUMBER2-Install Transmitter and TestThe Monitored Gate Link (MGL) transmitter/receiver system is intended to provide a wireless connection between a monitoredsafety edge and a motorized operator that controls the associated gate. MGL meets the UL 325-2016 requirements formonitored devices and has been certified as a UL 325 recognized component. It is designed for use on operators that comply withUL 325-2016 using a T2 terminated edge sensor.Required:1. 1/8” flat blade screwdriver2. 1/4” flat blade screwdriver3. T2 (10K/BLUE BAND) terminated sensing edgeRecommended:• VOM for test purposes• Mounting screws as required for receiver(2-6) EDGE WIRING TO SEI TERMINAL BLOCKTOP LIDSCREWS TEST BUTTONTRANSMITTER PCBSTRAIN RELIEFFITTINGMonitored Gate LinkImage Pending

Navigation menu