Mindray BIO Medical electronics TDBTSE Bluetooth Low Energy Module User Manual Panlink II

Shenzhen Mindray BIO-Medical electronics Co.,LTD. Bluetooth Low Energy Module Panlink II

Contents

  • 1. UserManual
  • 2. User Manual

UserManual

1.1 General DecriptionPanlink II module consists of a BT module, crystal and antenna connector. This module can change UART signal to wireless signal using Bluetooth low energy technology. This module uses external antenna via a Antenna connector. Panlink II communication type is piconet, which means Panlink II transfers data to another Panklink(one is master, the other one is salve). When transfering data from master to slave, data was given to master by UART. Then master Panlink II controls signal, frames, radiation power and transmits them via the antenna to slave Panlink II. Slave Panlink II get RF signal via the antenna and resolve it to data. When transfering data from slave to master, data was given to master by UART. Then slave Panlink II controls signal, frames, radiation power and transmits them via the antenna to master Panlink II. Master Panlink II get RF signal via the antenna and resolve it to data. And there are some requisition for end-user as below, 圃 The module is limited to OEM installation ONLY; 圃 The OEM integrators is responsible for ensuring that end-user has no manual instructions to remove or install module; 圃 The module is limited to installation in mobile or fixed application 圃 The separate approval is required for all other operating configurations, including portable configuration with respect to Part 2.1093 and different antenna configurations; 圃 The host manufacturer is responsible for ensuring that after the module is installed and operational the host continues to be compliant with the Part 15B unintentional radiator requirements
1.2 Block diagram 1.3 Interface and pin definition No. Pin name Type description 1 to 8 NC / No use 9 DC I Debug clock 10 DD O Debug data 11 SLEEP_OUT/P3_0 O Wakeup out 12 VDD Power Power in 13 GND Power ground 14 Reset RSTN Reset in 15 Wake/P0_3 I Wake up input 16 UART_RXD0 I Uart in, baud rate is115200 17 UART_TXD0 O Uart out, baud rate is115200 18 nCS1/CTSn1/P1_2 I/O Reserved 19 CLK1/RTSn1/P1_3 I/O Reserved 20 MOSI1/TXD1/P1_1 I/O Reserved 21 MISO1/RXD1/P1_0 I/O Reserved 22 CD O Module detect pin
23 RF Connector RF Connect to externalantenna 1.4 Operation specification ABSOLUTE MAXIMUM RATINGS Over operating room temperature range (unless otherwise noted) Item VA L UE UNIT Supply voltage range -0.3 to 3.9 V Voltage range to any of digital pins -0.3 to VDD + 0.3, <3.9 V Storage temperature range -40 to +85 ℃ RECOMMENDED OPERATING CONDITIONS Over operating room temperature range (unless otherwise noted) Item MIN NOM MAX UNIT Supply voltagerange 2.4 3.6 V Operational temperature range -20 +70 ℃ 1.5 Wireless specifications Protocol：Bluetooth low energy 4.0 Modulation mode：GFSK Operating frequency：2402 ~ 2480MHz(40 channels) Channel spacing：2MHz Wireless baud rate(data rate)： 1Mbps Output power (transfer power)： ≤2.5mW Data security ： 128bit AES 1.6 Mechanical and package description Dimension is 9.6mm*13.9mm*2.3mm, and package type is SMT.
  
Thisdeviceanditsantennamustnotbelocatedoroperatinginconjunctionwithanyotherantennaandtransmitter.Thisdevicecomplieswithpart15oftheFCCrules.Operationissubjecttothefollowingtwoconditions:(1)thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesiredoperation.Changesormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliancecouldvoidtheuser’sauthoritytooperatetheequipment.NOTE:ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuanttopart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidentialinstallation.Thisequipmentgeneratesusesandcanradiateradiofrequencyenergyand,ifnotinstalledandusedinaccordancewiththeinstructions,maycauseharmfulinterferencetoradiocommunications.However,thereisnoguaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoescauseharmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturningtheequipmentoffandon,theuserisencouragedtotrytocorrecttheinterferencebyoneormoreofthefollowingmeasures:‐Reorientorrelocatethereceivingantenna.‐Increasetheseparationbetweentheequipmentandreceiver.‐Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.‐Consultthedealeroranexperiencedradio/TVtechnicianforhelpimportantannouncementLABELOFTHEENDPRODUCT:Thefinalendproductmustbelabeledinavisibleareawiththefollowing"ContainsFCCID:ZLZTDBTSE"andContainsIC:9726A‐TDBTSE.TheFCCpart15.19statementbelowhastoalsobeavailableonthelabel:ThisdevicecomplieswithPart15ofFCCrules.Operationissubjecttothefollowingtwoconditions:(1)thisdevicemaynotcauseharmfulinterferenceand(2)thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesiredoperation.AusermanualwiththeendproductmustclearlyindicatetheoperatingrequirementsandconditionsthatmustbeobservedtoensurecompliancewithcurrentFCCRFexposureguidelines.TheendproductwithanembeddedPanlinkIIModulemayalsoneedtopasstheFCCPart15unintentionalemissiontestingrequirementsandbeproperlyauthorizedperFCCPart15.TocomplywithFCCregulationslimitingbothmaximumRFoutputpowerandhumanexposuretoRFradiation,themaximumantennagainincludingcablelossingeneralexposureconditionmustnotexceed3.5dBi.ThemodularusedRP‐SMAantennaconnectorandtested3antennas,AntennaAntennaTypeMaximumAntennaGainAntenna1FPC2dBiAntenna2Dipole3.5dBiAntenna3FPC1dBiIfendusersuseothersantennasexceptstated,end‐usersneedtestradiatedemission,RFexposurerefertoFCCC2PCrules.
‐English:ThisdevicecomplieswithIndustryCanadalicence‐exemptRSSstandard(s).Operationissubjecttothefollowingtwoconditions:(1)Thisdevicemaynotcauseinterference,and(2)Thisdevicemustacceptanyinterference,includinginterferencethatmaycauseundesiredoperationofthedevice.ThedigitalapparatuscomplieswithCanadianCANICES‐3(B)/NMB‐3(B).‐ French:LeprésentappareilestconformeauxCNRd'IndustrieCanadaapplicablesauxappareilsradioexemptsdelicence.L'exploitationestautoriséeauxdeuxconditionssuivantes:(1)l'appareilnedoitpasproduiredebrouillage,et(2)l'utilisateurdel'appareildoitacceptertoutbrouillageradioélectriquesubi,mêmesilebrouillageestsusceptibled'encompromettrelefonctionnement.ThedevicehasbeenevaluatedtomeetgeneralRFexposurerequirement.Thedevicecanbeusedinportableexposureconditionwithoutrestriction

User Manual

Navigation menu