Mitsubishi Electric R-9000RS RS-232C Interface Board User Manual R 900RS E

Mitsubishi Electric Corp RS-232C Interface Board R 900RS E

Install RS232C Interface Board

INSTALL RS-232C INTERFACE BOARDACCESSORIES : screw x 3 , Installation manualNOTE :• Voltage is supplied to some parts even when the POWER switchis turned off. To prevent electric shocks, be sure to turn off theVCR and unplug the power cord when installing the RS-232Cinterface PCB.• Read the warnings stamped or labeled in various locations onthe VCR and its parts.1. Remove the two screws securingthe cover plate.( Need not remove the top cover.)2. To remove the cover plate, slide it tothe left side and then pull it towardsyou.
3. Remove the cable from the coverplate.4. Connect the cable terminal on theVCR(PCB) to the connector REon the RS-232C PCB.5. Insert the RS-232C PCB into therear of VCR, as shown.
6. Slide the RS-232C PCB in thedirection of the arrow.7. On the rear of VCR, tighten thethree screws that secure the RS-232C PCB in place.
For US onlyNOTE:FCC ID:BGBR-9000RSThis device complies with part 15 of the FCC Rules. Operation is subjectto the following two conditions:(1) This device may not cause harmful interference, and (2) this devicemust accept any interference received including interference that maycuase undesired operation.NOTE:This equipment has been tested and found to comply with the limita for aClass B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses, and can radiate radiofrequency energy and, if not installed and used in accordance with the in-structions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television re-ception, which can be determined by turning the equipment off and on, theuse is encouraged to try to correct the interference by one or more of thefollowing measures:- Raorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment to an outlet on a circuit different from that towhich the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.Changes or modifications not expressly approved by the party responsiblefor compliance could void the user’s authority to operate the equipment.For CANADA only INFORMATIONTHIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003. INFORMATIONCET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LANORME NMB-003 DU CANADA.

Navigation menu