MobiWireS HOTAH MobiWire Hotah User Manual Sanjeev
MobiWire SAS MobiWire Hotah Sanjeev
Users Manual
1
User
User Manual
Manual
Mobile
Mobile Phone
Phone
Model
Model：
：MobiWire
MobiWire Hotah
Hotah
.
.
2
Know your phone
3
SIM/SD card installation
1.
1. Refer
Refer to
to the
the following
following picture
picture for
for r
remove
emove the
the card
card slot
slot.
.
2.
2. Put
Put the
the SIM
SIM /
/SD
SD card
card into
into the
the card
card slot
slot,then
,then Insert
Insert card
card
slot
slot.
.
4
Charging the phone
You
You can
can charge
charge your
your device
device using
using a
acharger
charger or
or by
by connecting
connecting
it
it to
to the
the computer
computer using
using a
aUSB
USB cable
cable (comes
(comes with
with the
the
phone).
phone).
Use
Use only
only original
original charger
charger and
and cables.
cables. Other
Other chargers
chargers or
or
cables
cables may
may damage
damage the
the device
device or
or your
your device.
device. This
This will
will
invalidate
invalidate your
your phone
phone warranty.
warranty.
5
Operating Frequency Band (RF)：
GSM850：824.0-849.0MHz(TX), 869.0-894.0MHz(RX)
EGSM900:880.0–915.0MHz(TX), 925.0–960.0MHz(RX)
DCS 1800: 1710.0–1785.0MHz (TX), 1805.0–1880.0 MHz (RX)
PCS 1900:1850.0-1910.0MHz(TX), 1930.0-1990.0MHz(RX)
WCDMA Band1: 1920-1980MHz (TX), 2110-2170MHz (RX)
WCDMA Band2 :1850-1910MHz(TX), 1930-1990MHz(RX)
WCDMA Band5:824 -849.0MHz(TX), 869-894.0MHz(RX)
WCDMA Band8: 880-915MHz (TX), 925-960MHz (RX)
LTE BAND1: 1920-1980MHz (TX), 2110-2170MHz (RX)
LTE BAND2: 1850-1910MHz(TX), 1930-1990MHz(RX)
LTE BAND3: 1710.0–1785.0MHz (TX), 1805.0–1880.0 MHz (RX)
LTE BAND7:2500-2570MHz(TX),2620-2690MHz(RX)
LTE BAND20:832-862MHz(TX),791-821MHz(RX)
Bluetooth: 2402-2480MHz (TX/RX)
WIFI: 2412-2462MHz (TX/RX)
5250 to 5350MHz (TX/RX)
5470 to 5725MHz (TX/RX)
GPS:1575.42MHz
FM：87.5MHz-108.5MHz
Modulation mode：
GMSK (GSM850/GSM900/DCS/PCS) 8PSK（EDGE）
WCDMA Uplink ：BPSK/QPSK/16QAM ；WCDMA Downlink ：
BPSK/QPSK /16QAM/64QAM
LTE Uplink: BPSK/QPSK/16QAM; LTE Downlink ：BPSK/QPSK
/16QAM/64QAM
GFSK/π/4-DQPSK/ 8-DPSK (Bluetooth)
BPSK/QPSK/16QAM/64QAM/DSSS/OFDM/ CCK (WIFI b/g/n/a)
BPSK/QPSK (GPS)
6
Max Output Power：
Item
Max Output Power(dBm)
GSM850/GSM900
32.5 ± 0.5
DCS/PCS
30.5 ± 0.5
WCDMA
B1/B2/B5/B8
22± 1
LTE
B1/B2/B3/B7/B20
21± 2
bluetooth
6± 1.5
Wi-Fi 2.4G
15± 2
Wi-Fi 5G
13± 2
7
CAUTION：
1. Use careful with the earphone maybe excessive sound pressure from
earphones and headphones can cause hearing loss.
2.This device battery is not removable, please do not disassemble the
device.
3. The product shall only be connected to a USB interface of version
USB3.1 Type-C.
4. Adapter shall be installed near the equipment and shall be easily
accessible.
5. Operating temperature：-20~40℃
Charging temperature：Charging 0~40℃；Discharging -20~40℃
6. Charger1: A88-3771-5V2A
Charger2: A70-502000
Charger3: A824-5V2A
7. The device complies with RF specifications when the device used at
5mm from your body.
8. To prevent possible hearing damage, do not listen at high volume
levels for long periods.
9. Earphone and USB cable are shielded.
8
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC ID: QPN-HOTAH
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
---Reorient or relocate the receiving antenna.
---Increase the separation between the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
---Consult the dealer or an experienced radio/TV technician for help.
Body-worn Operation
This device was tested for typical body-worn operations. To comply With RF
exposure requirements, a minimum separation distance of 1.0cm must be
maintained between the user’s body and the handset, including the
antenna.
Third-party belt-clips, holsters, and similar including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that
do not meet these requirements may not comply with RF exposure
requirements and should be avoided.
9
Specific Absorption Rate (SAR) information:
This wireless phone meets the government's requirements for exposure to
radio waves. The guidelines are based on standards that were developed
by independent scientific organizations through periodic and thorough
evaluation of scientific studies. The standards include a substantial safety
margin designed to assure the safety of all persons regardless of age or
health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is
1.6 W/kg averaged over one gram of tissue. Device types MobiWire Hotah
has also been tested against this SAR limit. The highest SAR value reported
under this standard during product certification for use at the ear is
0.500W/kg and when properly worn on the body is 0.679W/kg. This device
was tested for typical body-worn operations with the back of the handset
kept 1cm from the body. To maintain compliance with FCC RF exposure
requirements, use accessories that maintain a 1cm separation distance
between the user's body and the back of the handset. The use of belt clips,
holsters and similar accessories should not contain metallic components in
its assembly. The use of accessories that do not satisfy these requirements
may not comply with FCC RF exposure requirements, and should be
avoided.
10
e-label
First step: Power on your phone
Second step: Go to Settings -> System
->About Phone
Then you can see:
Model: MobiWire Hotah
IMEI: 35236110XXXXXXX
FCC ID: QPN-HOTAH
11
e-Label