MobiWireS HOTAH MobiWire Hotah User Manual Sanjeev

Download:
Mirror Download [FCC.gov]
Document ID	4120918
Application ID	QP0QQGO7KBSr4EO9P5ZzAw==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	36.05kB (450598 bits)
Date Submitted	2018-12-28 00:00:00
Date Available	2019-01-02 00:00:00
Creation Date	2018-12-24 18:58:48
Document Lastmod	2018-12-24 18:58:48
Document Title	Sanjeev
Document Creator	WPS 文字
Document Author:	daishengsheng

User Manual
Mobile Phone
Model：
Model：MobiWire Hotah
Know your phone
SIM/SD card installation
1. Refer to the following picture for remove the card slot.
slot.
2. Put the SIM / SD card into the card slot,then
slot,then Insert card
slot.
slot.
Charging the phone
You can charge your device using a charger or by connecting
it to the computer using a USB cable (comes with the
phone).
Use only original charger and cables. Other chargers or
cables may damage the device or your device. This will
invalidate your phone warranty.
Operating Frequency Band (RF)：
GSM850：824.0-849.0MHz(TX), 869.0-894.0MHz(RX)
EGSM900:880.0–915.0MHz(TX),
925.0–960.0MHz(RX)
DCS 1800: 1710.0–1785.0MHz (TX), 1805.0–1880.0 MHz (RX)
PCS 1900:1850.0-1910.0MHz(TX), 1930.0-1990.0MHz(RX)
WCDMA Band1: 1920-1980MHz (TX), 2110-2170MHz (RX)
WCDMA Band2 :1850-1910MHz(TX), 1930-1990MHz(RX)
WCDMA Band5:824 -849.0MHz(TX), 869-894.0MHz(RX)
WCDMA Band8: 880-915MHz (TX), 925-960MHz (RX)
LTE BAND1: 1920-1980MHz (TX), 2110-2170MHz (RX)
LTE BAND2: 1850-1910MHz(TX), 1930-1990MHz(RX)
LTE BAND3: 1710.0–1785.0MHz (TX), 1805.0–1880.0 MHz (RX)
LTE BAND7:2500-2570MHz(TX),2620-2690MHz(RX)
LTE BAND20:832-862MHz(TX),791-821MHz(RX)
Bluetooth: 2402-2480MHz (TX/RX)
WIFI: 2412-2462MHz (TX/RX)
5250 to 5350MHz (TX/RX)
5470 to 5725MHz (TX/RX)
GPS:1575.42MHz
FM：87.5MHz-108.5MHz
Modulation mode：
GMSK (GSM850/GSM900/DCS/PCS) 8PSK（EDGE）
WCDMA Uplink ： BPSK/QPSK/16QAM ；
WCDMA Downlink ：
BPSK/QPSK /16QAM/64QAM
LTE Uplink: BPSK/QPSK/16QAM;
LTE Downlink ：
BPSK/QPSK
/16QAM/64QAM
GFSK/π/4-DQPSK/ 8-DPSK (Bluetooth)
BPSK/QPSK/16QAM/64QAM/DSSS/OFDM/ CCK (WIFI b/g/n/a)
BPSK/QPSK (GPS)
Max Output Power：
Item
GSM850/GSM900
DCS/PCS
WCDMA
B1/B2/B5/B8
LTE
B1/B2/B3/B7/B20
bluetooth
Wi-Fi 2.4G
Wi-Fi 5G
Max Output Power(dBm)
32.5 ± 0.5
30.5 ± 0.5
22± 1
21± 2
6± 1.5
15± 2
13± 2
CAUTION：
1. Use careful with the earphone maybe excessive sound pressure from
earphones and headphones can cause hearing loss.
2.This device battery is not removable, please do not disassemble the
device.
3. The product shall only be connected to a USB interface of version
USB3.1 Type-C.
4. Adapter shall be installed near the equipment and shall be easily
accessible.
5. Operating temperature：-20~40℃
Charging temperature：Charging 0~40℃；Discharging -20~40℃
6. Charger1: A88-3771-5V2A
Charger2: A70-502000
Charger3: A824-5V2A
7. The device complies with RF specifications when the device used at
5mm from your body.
8. To prevent possible hearing damage, do not listen at high volume
levels for long periods.
9. Earphone and USB cable are shielded.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC ID: QPN-HOTAH
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
---Reorient or relocate the receiving antenna.
---Increase the separation between the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
---Consult the dealer or an experienced radio/TV technician for help.
Body-worn Operation
This device was tested for typical body-worn operations. To comply With RF
exposure requirements, a minimum separation distance of 1.0cm must be
maintained between the user’s body and the handset, including the
antenna.
Third-party belt-clips, holsters, and similar including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that
do not meet these requirements may not comply with RF exposure
requirements and should be avoided.
Specific Absorption Rate (SAR) information:
This wireless phone meets the government's requirements for exposure to
radio waves. The guidelines are based on standards that were developed
by independent scientific organizations through periodic and thorough
evaluation of scientific studies. The standards include a substantial safety
margin designed to assure the safety of all persons regardless of age or
health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is
1.6 W/kg averaged over one gram of tissue. Device types MobiWire Hotah
has also been tested against this SAR limit. The highest SAR value reported
under this standard during product certification for use at the ear is
0.500W/kg and when properly worn on the body is 0.679W/kg. This device
was tested for typical body-worn operations with the back of the handset
kept 1cm from the body. To maintain compliance with FCC RF exposure
requirements, use accessories that maintain a 1cm separation distance
between the user's body and the back of the handset. The use of belt clips,
holsters and similar accessories should not contain metallic components in
its assembly. The use of accessories that do not satisfy these requirements
may not comply with FCC RF exposure requirements, and should be
avoided.
e-label
First step: Power on your phone
Second step: Go to Settings -> System
->About Phone
Then you can see:
Model: MobiWire Hotah
IMEI: 35236110XXXXXXX
FCC ID: QPN-HOTAH
10
e-Label
11

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Page Count                      : 11
Author                          : daishengsheng
Comments                        : 
Company                         : 
Create Date                     : 2018:12:24 18:58:48+10:58
Creator                         : WPS 文字
Modify Date                     : 2018:12:24 18:58:48+10:58
Producer                        : 
Source Modified                 : D:20181224185848+10'58'
Subject                         : 
Title                           : Sanjeev
Trapped                         : false

EXIF Metadata provided by EXIF.tools