Mobile Aspects IRISPRINT10 RFID Printer Module User Manual Product Requirements
Mobile Aspects Inc RFID Printer Module Product Requirements
User manual - Installation Instructions
3700 S. Water St Ste 310
Pittsburgh PA 15203
USA
iRISPrint 1.0 Internal Installation
Instructions
Rev 0
Mobile Aspects, 2017
Page 2
FCC Statement
WARNING! This module is to be installed only in Mobile Aspects end products by Mobile Aspects personnel, and shall not be
offered to 3rd party OEM integrators or the general public.
Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
The RF Module is labeled with its own FCC ID Number. If the FCC ID is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a label referring to
the enclosed module. This exterior label can use wording such as the following:
Contains Transmitter Module FCC ID: R4FIRISPRINT10
or
Contains FCC ID: R4FIRISPRINT10
Mobile Aspects, 2017
Page 3
Table of Contents
1. INTRODUCTION............................................................................................................................................................................ 4
1.1 PURPOSE OF THE DOCUMENT ...................................................................................................................................................... 4
2. INSTALLATION INSTRUCTIONS .............................................................................................................................................. 4
2.1 PRINTER MAIN CONTROLLER ..................................................................................................................................................... 4
2.2 PRINTER ANTENNA ..................................................................................................................................................................... 5
2.3 CONSOLE TO PRINTER CONNECTION ........................................................................................................................................... 6
Mobile Aspects, 2017
Page 4
1. Introduction
1.1 Purpose of the document
The purpose of this internal document is to provide work instructions on how to install the printer main
controller and printer antenna inside a console and printer.
2. Installation Instructions
2.1 Printer Main Controller
Printer main
controller
location inside the
console
1) With a hex driver, install
the printer main controller
using 6-32 button head
screws.
2) Connect the ribbon ribbon
cable from the printer
controller to the
motherboard.
3) Connect the 4-pin ATX
cable from the power
supply to the printer
controller.
Motherboard
Printer Controller
Power
Supply
Ribbon Cable
Mobile Aspects, 2017
Page 5
2.2 Printer Antenna
1) Install printer at
this location inside
the printer.
1) Attach the
antenna cable at
this this location in
the back of the
printer.
Mobile Aspects, 2017
Page 6
2.3 Console to Printer Connection
Connect the printer to the console as show below.
SMA Coaxial Cable
RS232 Null Modem Cable