Motion Metrics CARV CARV User Manual

Motion Metrics Limited CARV Users Manual

Users Manual

CARV Quick Start Guide Digital Ski Coach Included components  2 x Sensing Inserts  2 x Trackers  2 x USB Charging Cables Overview Overview of components 1. Tracker data and charging socket 2. Light indicator 3. Sensing insert 4. Sensing insert data cable connector Installation instructions: 1. Remove the boot liner 2. Position CARV Sensing Insert inside the boot shell 3. Replace the boot liner, being careful not to move the Sensing Insert out of alignment 4. Clip the CARV Tracker onto the back of your boot 5. Insert the connector from the Sensing Insert into the socket on the Tracker 6. Download and follow setup procedure on the CARV app
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. FCC ID: xxxx-xxxxx RED statement This device was tested for typical body‐worn operations. To comply with RF exposure requirements, a minimum separation distance of 0cm must be maintained between the user’s body and the handset, including the antenna. Third‐party belt‐clips, holsters, and similar accessories used by this device should not contain any metallic components. Body‐worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. This device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. All essential radio test suites have been carried out. 1. CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS 2. The device complies with RF specifications when the device used at 5cm from your body.
Manufacturer Information Motion Metrics Limited Address: 8th Floor Huaqiang Electronic World Building 2, No.1007 Huaqiang Rd., Futian District, Shenzhen, Guangdong 518028, China Email: team@motionmetrics.co

Navigation menu