Motion Metrics CARV CARV User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3681891
Application ID	fXQIpKm18g0sbSYNEW9KYg==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	40.8kB (510019 bits)
Date Submitted	2017-12-18 00:00:00
Date Available	2018-06-15 00:00:00
Creation Date	2017-11-09 13:44:34
Producing Software	Microsoft® Word 2010
Document Lastmod	2017-11-09 13:44:34
Document Title	Users Manual
Document Creator	Microsoft® Word 2010
Document Author:	boxuanhon

CARV Quick Start Guide
Digital Ski Coach
Included components



2 x Sensing Inserts
2 x Trackers
2 x USB Charging Cables
Overview
Overview of components
1. Tracker data and charging socket
2. Light indicator
3. Sensing insert
4. Sensing insert data cable connector
Installation instructions:
1. Remove the boot liner
2. Position CARV Sensing Insert inside the
boot shell
3. Replace the boot liner, being careful not
to move the Sensing Insert out of
alignment
4. Clip the CARV Tracker onto the back of
your boot
5. Insert the connector from the Sensing
Insert into the socket on the Tracker
6. Download and follow setup procedure
on the CARV app
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:




Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
FCC ID: xxxx-xxxxx
RED statement
This device was tested for typical body‐worn operations. To comply with RF exposure
requirements, a minimum separation distance of 0cm must be maintained between the user’s body
and the handset, including the antenna. Third‐party belt‐clips, holsters, and similar accessories
used by this device should not contain any metallic components. Body‐worn accessories that do
not meet these requirements may not comply with RF exposure requirements and should be
avoided. Use only the supplied or an approved antenna.
This device is in compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU. All essential radio test suites have been carried out.
1. CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS
2. The device complies with RF specifications when the device used at 5cm from your body.
Manufacturer Information
Motion Metrics Limited
Address: 8th Floor Huaqiang Electronic World Building 2, No.1007 Huaqiang Rd., Futian District,
Shenzhen, Guangdong 518028, China
Email: team@motionmetrics.co

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 3
Language                        : en-GB
Tagged PDF                      : Yes
Author                          : boxuanhon
Creator                         : Microsoft® Word 2010
Create Date                     : 2017:11:09 13:44:34+08:00
Modify Date                     : 2017:11:09 13:44:34+08:00
Producer                        : Microsoft® Word 2010

EXIF Metadata provided by EXIF.tools