Motorola Mobility T56CP1 In-Cabin Bluetooth Module User Manual Exh D1 ICBM antenna install instrsl
Motorola Mobility LLC In-Cabin Bluetooth Module Exh D1 ICBM antenna install instrsl
Exhibit D Users Manual per 2 1033 b3
MOTOROLA INC FCC ID: IHDT56CP1
IN-CABIN BLUETOOTH MODULE INSTALLATION INSTRUCTIONS
[Model# SYN9592A and cable length variants]
1. GENERAL:
The In-Cabin Bluetooth Module facilitates a wireless Bluetooth interface between
an in-vehicle control unit and other Bluetooth-enabled devices (such as a laptop PC, a
handset, etc.).
2. ANTENNA AND MODULE INSTALLATION:
The module utilizes an internal, pc board mounted, chip antenna. The unit is
designed for installation within the passenger compartment of an automobile, usually in
the center console area. The device should be mounted with a plastic bracket to minimize
shadowing of the internal antenna. Due to the low power at which the unit transmits
(0.0025 W max.), placement from an SAR perspective is not critical.
All module installations are performed by the vehicle manufacturer. No end-user
installation is involved. Any unauthorized changes or modifications not expressly
approved by Motorola could void the user’s authority to operate this equipment.
3. I/O CONNECTION:
A cable mounted 20-pin female automotive connector is utilized to provide power
and vehicle bus communications. This connector will only mate with a corresponding
connector in the vehicle’s prewire.
4. SPECIFICATIONS:
?? Frequency range: 2402 MHz – 2480 MHz
?? Operating current: 1.5A nominal
?? Operating voltage: 13.2V nominal
?? Operating temp. range: -30?C to +70?C
?? Storage temp. range: -40?C to +85?C
?? Output power: 0.0025 W max
MOTOROLA INC FCC ID: IHDT56CP1
IN-CABIN BLUETOOTH MODULE USER MANUAL
[Model# SYN9592A and cable length variants]
1. GENERAL:
The In-Cabin Bluetooth Module facilitates a wireless Bluetooth interface between
an in-vehicle control unit and other Bluetooth-enabled devices (such as a laptop PC, a
handset, etc.).
2. ANTENNA AND MODULE INSTALLATION:
The module utilizes an internal, pc board mounted, chip antenna. The unit is
designed for installation within the passenger compartment of an automobile, usually in
the center console area. The device should be mounted with a plastic bracket to minimize
shadowing of the internal antenna. Due to the low power at which the unit transmits
(0.0025 W max.), placement from an SAR perspective is not critical.
All module installations are performed by the vehicle manufacturer. No end-user
installation is involved. Any unauthorized changes or modifications not expressly
approved by Motorola could void the user’s authority to operate this equipment.
3. I/O CONNECTION:
A cable mounted 20-pin female automotive connector is utilized to provide power
and vehicle bus communications. This connector will only mate with a corresponding
connector in the vehicle’s prewire.
4. SPECIFICATIONS:
?? Frequency range: 2402 MHz – 2480 MHz
?? Operating current: 1.5A nominal
?? Operating voltage: 13.2V nominal
?? Operating temp. range: -30?C to +70?C
?? Storage temp. range: -40?C to +85?C
?? Output power: 0.0025 W max