Motorola Mobility T5CA1 Portable Cellular Transceiver (AMPS/TDMA) User Manual FCC IDENTIFICATION NAMEPLATE INFORMATION

Motorola Mobility LLC Portable Cellular Transceiver (AMPS/TDMA) FCC IDENTIFICATION NAMEPLATE INFORMATION

Contents

Supplemental Reponse to TC1325 Exhibit 8 Preliminary Users Manual Draft

APPLICANT: MOTOROLA, INC FCC ID: IHDT5CA1EXHIBIT 8AINSTRUCTION MANUALIn response to correspondence reference number 220903.IHD, a partial preliminary draft copy of theUsers Manual follows:In response to the language on page 13, please refer to appendix 1: which was included in Motorola’sresponse to FCC questions on IHDT56CF1.Reference:Correspondence Reference Number: 4795731 Confirmation Number: TC544922Date of Original Email: 07/26/2002
APPLICANT: MOTOROLA, INC FCC ID: IHDT5CA1EXHIBIT 8AAppendix 1(Response to Question 2)Dear Martin,You have asked us to adopt the following sample language from Supplement C:“The use of belt-clips, holsters and similar accessories should not contain metallic components in itsassembly. The use of accessories that do not satisfy these requirements may not comply with FCC RFexposure requirements, and should be avoided.”FCC and Motorola share a common goal: to assure that consumers receive clear information about theuse of body-worn accessories and SAR. It is important that consumers understand that Motorola takesthe appropriate steps to test accessories for compliance with SAR limits. Second, customers must bewarned not to use accessories that may be untested and non-compliance. However, in warningcustomers we do not want to mislead them into believing that Motorola’s after-market accessories are notcompliant. As you know, we test both after-market accessories as well as those that accompany theproduct.Our basic concern is that customers might interpret your recommended language as applying toMotorola’s products that are tested for compliance. If we determine that a metal spring is needed forreliability in a holster that is tested and complies with FCC’s SAR guidelines, we do not want to beprecluded by this language from providing a more reliable product to the customer. Therefore, we believethe language we use in our manual serves our customers better:“Use of non-Motorola-approved accessories may exceed FCC/Health Canada RF Exposureguidelines. If you do not use one of the Motorola-supplied or approved body-worn accessories,and are not using the phone held in the normal use position, ensure the phone and its antenna areat least one inch (2.5cm) from your body when transmitting."We believe this language accomplishes the following objectives:1. It warns against using non-approved (and therefore untested) accessories;2. It advises customers what to do if they choose to use a non-approved accessory.We, therefore, respectively renew our submission of our standard language - which previouslyhas been accepted by the FCC. If you continue to have concerns, we would request a meetingnext Friday (August 30) to discuss the issue in person.
11PRELIMINARYSafety and General InformationIMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION. READ THIS INFORMATION BEFORE USING YOUR PHONE.The information provided in this document supersedes the general safety information contained in user guides published prior to July 2000. For information regarding radio use in a hazardous atmosphere please refer to the Factory Mutual (FM) Approval Manual Supplement or Instruction Card, which is included with radio models that offer this capability.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.RF Operational CharacteristicsYour phone contains a transmitter and a receiver. When it is ON, it receives and transmits radio frequency (RF) energy. The phone operates in the frequency range of 824 MHz to 849 MHz in analog and digital mode.When you communicate with your phone, the system handling your call controls the power levels at which your phone transmits. The output power level typically may vary over a range from 0.00 watts to 0.35 watts in analog mode and 0.00 watts to 0.56 watts in digital mode.Exposure To Radio Frequency EnergyYour Motorola phone is designed to comply with the following national and international standards and guidelines regarding exposure of human beings to radio frequency electromagnetic energy:
12PRELIMINARY•United States Federal Communications Commission, Code of Regulations; 47 CFR part 2 sub-part J•American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers (IEEE) C95. 1-1992•Institute of Electrical and Electronic Engineers (IEEE) C95.1-1999 Edition•National Council on Radiation Protection and Measurements (NCRP) of the United States, Report 86, 1986•International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998•Ministry of Health (Canada) Safety Code 6. Limits of Human Exposure to Radiofrequency Electromagnetic Fields in the Frequency Range from 3 kHz to 300 GHz, 1999•Australian Communications Authority Radiocommunications (Electromagnetic Radiation-Human Exposure) Standard 1999To assure optimal phone performance and make sure human exposure to radio frequency electromagnetic energy is within the guidelines set forth in the above standards, always adhere to the following procedures:Portable Phone Operation and EME ExposureAntenna CareUse only the supplied or an approved replacement antenna. Unauthorized antennas, modifications, or attachments could damage the phone and may violate FCC regulations.Do NOT hold the antenna when the phone is in use. Holding the antenna affects call quality and may cause the phone to operate at a higher power level than needed.Phone OperationWhen placing or receiving a phone call, hold your phone as you would a wireline telephone. Speak directly into the microphone.
13PRELIMINARYBody-Worn OperationTo maintain compliance with FCC/Health Canada RF exposure guidelines, if you wear a phone on your body when transmitting, always place the phone in a Motorola-supplied or approved clip, holder, holster, case, or body harness for this product. Use of non-Motorola-approved accessories may exceed FCC/Health Canada RF exposure guidelines. If you do not use one of the Motorola-supplied or approved body-worn accessories, and are not using the phone held in the normal use position, ensure the phone and its antenna are at least one inch (2.5 centimeters) from your body when transmitting.Data OperationWhen using any data feature of the phone, with or without an accessory cable, position the phone and its antenna at least one inch (2.5 centimeters) from your body.Approved AccessoriesFor a list of approved Motorola accessories, visit our website at www.mot.com.Electromagnetic Interference/CompatibilityNote: Nearly every electronic device is susceptible to electromagnetic interference (EMI) if inadequately shielded, designed, or otherwise configured for electromagnetic compatibility.FacilitiesTo avoid electromagnetic interference and/or compatibility conflicts, turn off your phone in any facility where posted notices instruct you to do so. Hospitals or health care facilities may be using equipment that is sensitive to external RF energy.AircraftWhen instructed to do so, turn off your phone when on board an aircraft. Any use of a phone must be in accordance with applicable regulations per airline crew instructions.

Navigation menu