Motorola Solutions 89FT5805 Integrated Data Only Transceiver User Manual FCC Certification Report for the

Motorola Solutions, Inc. Integrated Data Only Transceiver FCC Certification Report for the

Exhibit 8 User Guide Instruction Manual

Applicant: Motorola Inc. FCC ID:AZ489FT5805 Exhibit 8Exhibit 8. Instruction Manual1.) Quick Reference Card HDT 500 Series2.) Safety Information - Handheld Data Terminal, HDT FamilySafe and Efficient Operation of Motorola Two Way Radio Products
Front Panel The HDT 500 Keys are assigned to operate according to the specific usage of the device. However, the items shown below refer to basic operations available in all HDT 500 configurations. Setting the Office Dock Local Computer Control A Large Office configuration enables a cascade connection of up to 31 Office Dock units (155 HDT 500 devices) to one RS-485 port in the host computer. For connections, see figure below. Remote Computer Control A Small Office configuration enables a cascade connection of up to 3 Office Dock units (15 HDT 500 devices) to the host computer. A Line Modem is used for communication with remote located host computer. For connections, see figure below. and Motorola are registered trademarks of Motorola Inc. © Motorola Inc., 2000 68P02 960C11-A @6802960C11@ To Third Office Dock UnitJ2 J1 To 90-240VAC Power Outlet Line Modem (28.8 or 33.6kb/s) J1RS-232 cables To Phone Line J2To more Office Dock Units J3J4Host computer RS-485 cables J3J4RS-485 to RS-232 ConverterNavigation Keys Screen Light (When pressed with Shift key, contrast level increases cyclically). IMPORTANT: To save battery power, use Screen Light only when needed. Barcode ScannerKeys (for left-hand and right-hand users)Screen Indication Light (Operation is defined by configuration) Space Key Space Key (Operation is defined by configuration)
Battery Charge LED (see figure below) • No light - Not in use • Red light - Battery charging (6-9 hours for full capacity) • Green light - Battery fully charged Important Note Battery is considered damaged when charging takes more than 8 hours. Contact service to replace battery. Data Communication With Host (see figure above) Communication between the HDT 500 and the host computer can be established when the HDT 500 rests in the Office Dock. When data flows from the HDT 500 to the host computer, the Data Out yellow LED lights. When data flows from the host computer to the HDT 500, the Data In yellow LED lights. HDT 500 Series Hand-held Data Terminal with Wide Area Network Radio Modem And LASER Barcode Scanner Quick Reference Card Switching On Press the Power On/Off button for more than 2 seconds. The Power Indication Light will illuminate, indicating that the battery is O.K. and the device is operative. Switching Off Press the Power On/Off button for more than 2 seconds and release. The Power Indication Light will turn off. HDT 500 HolsterOffice Dock Power On/Off Button Keypad ScreenBuzzer Battery Pack(Do not remove)Indication Light Laser Scanner Infrared communication Aperture (Keep clean using soft, damp cloth) CAUTION LASER LIGHT - DO NOT STARE INTO BEAM (Keep LASER window clean using soft, damp cloth) !C a u t i o n
68P02960C25-O Please retain for future use Safe and Efficient Operationof Motorola Two Way Radio Products RF OPERATIONAL CHARACTERISTICS Your radio contains a transmitter which transmits using very short bursts of data;a receiver which receives radio frequency (RF); and an internal antenna. EXPOSURE TO RADIO FREQUENCY ENERGY Your Motorola radio product is designed to comply with the following national and international standards and guidelines regarding exposure of human be-ings to radio frequency electromagnetic energy: • United States Federal Communications Commission, Code of Federal Regulations; 47 CFR part 2 sub-part J • American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers (IEEE) C 95. 1-1992• Institute of Electrical and Electronic Engineers (IEEE), C95.1-1999 Edition • National Council on Radiation Protection and Measurements (NCRP) of the United States, Report 86, 1986 • International Commission on Non-Ionizing Radiation Protection (ICNIRP (1998)• National Radiological Protection Board of the United Kingdom, (1995)• Ministry of Health (Canada) Safety Code 6. Limits of Human Exposure to Radiofrequency Electromagnetic Fields in the Frequency Range from 3 kHz to 300 GHz, 1999• Australian Communications Authority Radiocommunications (Electro-magnetic Radiation - Human Exposure) Standard 1999 (applicable to wireless phones only). To assure optimal radio product performance and to make sure human expo-sure to radio frequency electromagnetic energy is within the guidelines set forth in the above standards, always adhere to the following procedures: PORTABLE RADIO PRODUCT OPERATION & EME EXPOSURE BODY-WORN OPERATION To maintain compliance with FCC RF exposure guidelines, if you wear a radio product on your body when transmitting, always place the radio product in a Motorola supplied or approved clip, holder, holster, case, or body harness. Use of non-Motorola-approved accessories may exceed FCC RF exposure guidelines. If you do not use a body-worn accessory, and are not using the radio product held in the normal use position, ensure the radio product is at least one inch (2.5 cms) from your body when transmitting .APPROVED ACCESSORIES For a list of approved Motorola accessories, please refer to the Quick Refer-ence Card . ELECTROMAGNETIC INTERFERENCE / COMPATIBILITY NOTE : Nearly every electronic device is susceptible to electromagnetic inter-ference (EMI) if inadequately shielded, designed or otherwise configured for electromagnetic compatibility FACILITIES To avoid electromagnetic interference and/or compatibility conflicts, turn off your radio product in any facility where posted notices instruct you to do so. Hospitals or health care facilities may be using equipment that is sensitive to external RF energy .AIRCRAFT When instructed to do so, turn off your radio product when on board an air-craft. Any use of a radio product must be in accordance with airline regula-tions or airline crew instructions.HANDHELD DATATERMINALHDT Family
MEDICAL DEVICESPacemakers The Health Industry Manufacturers Association recommends that a minimum separation of 6 inches (15 centimeters) be maintained between a handheld wireless radio product and a pacemaker.These recommendations are con-sistent with the independent research by, and recommendations of, Wireless Technology Research. Persons with pacemakers should: 1. ALWAYS keep the radio product more than six inches (15 centimeters) from their pacemaker when the radio product is turned ON . 2. Not to carry the radio product in the breast pocket.3. Use the radio product away from the pacemaker to minimize the poten-tial for interference.4. Turn the radio product OFF immediately if you have any reason to sus-pect that interference is taking place. Hearing Aids Some digital wireless radio products may interfere with some hearing aids. In the event of such interferences you may want to consult your hearing aid manufacturer to discuss alternatives. Other Medical Devices If you use any other personal medical device, consult the manufacturer of your device to determine if it is adequately shielded from RF energy.Your physician may be able to assist you in obtaining this information. Safety and General Use While Driving Check the laws and regulations on the use of radio products in the area where you drive. Always obey them.When using your radio product while driving, please: 1. Give full attention to driving and to the road.2. Use hands-free operation, if available.3. Pull off the road and park before making or answering a call if driving conditions so require. OPERATIONAL WARNINGSFOR VEHICLES WITH AIR BAG Do not place a radio prod uct in the area over an air bag or in the air bag deployment area. Air bags inflate with great force. If a portable radio product is placed in the air bag deployment area and the air bag inflates, the radio product may be propelled with great force and cause serious injury to occu-pants of the vehicle. POTENTIALLY EXPLOSIVE ATMOSPHERES Turn off your two way radio product prior to entering any area with a poten-tially explosive atmosphere, unless it is a radio product type especially qual-ified for use in such areas as “Intrinsically Safe” (for example, Factory Mutual, CSA, or UL Approved). Do not remove, install, or charge batteries in such areas. Sparks in a potentially explosive atmosphere can cause an explosion or fire resulting in bodily injury or even death. NOTE: The areas with potentially explosive atmospheres referred to above include fueling areas such as; below decks on boats, fuel or chemical transfer or storage facilities, areas where the air contains chemicals or particles such as grain, dust, or metal powders;and any other area where you would normally be advised to turn off your vehicle engine. Areas with potentially explosive atmospheres are often but not always posted. BLASTING CAPS AND AREAS To avoid possible interference with blasting operations, turn off your radio product when you are near electrical blasting caps, in a "blasting area", or in areas posted: "turn off two-way radio." Obey all signs and instructions.All batteries can cause property damage and/or bodily injury such as burns if a conductive material such as jewelry, keys, or beaded chains touch exposed terminals. The conductive material may complete an electrical circuit (short circuit) and become quite hot. Exercise care in handling any charged battery, particularly when placing it inside a pocket, purse, or other container with metal objects.!C a u t i o nOPERATIONAL CAUTIONSBATTERIES !W A R N I N G!

Navigation menu