Motorola Solutions 89FT5805 Integrated Data Only Transceiver User Manual FCC Certification Report for the

Download:
Mirror Download [FCC.gov]
Document ID	129480
Application ID	driR6XQGy+/LgndLTI6osA==
Document Description	Exhibit 8 User Guide Instruction Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	68.85kB (860595 bits)
Date Submitted	2000-12-19 00:00:00
Date Available	2001-03-01 00:00:00
Creation Date	2000-10-29 07:47:33
Producing Software	Acrobat Distiller 4.0 for Windows
Document Lastmod	2000-12-18 06:02:41
Document Title	FCC Certification Report for the
Document Creator	Microsoft Word 8.0
Document Author:	Compaq

Applicant: Motorola Inc.
FCC ID:AZ489FT5805
Exhibit 8. Instruction Manual
1.) Quick Reference Card HDT 500 Series
2.) Safety Information - Handheld Data Terminal, HDT Family
Safe and Efficient Operation of Motorola Two Way Radio Products
Exhibit 8
Front Panel
Setting the Office Dock
The HDT 500 Keys are assigned to operate according
to the specific usage of the device. However, the
items shown below refer to basic operations available
in all HDT 500 configurations.
Indication Light
(Operation is defined
by configuration)
Local Computer Control
A Large Office configuration enables a cascade
connection of up to 31 Office Dock units (155
HDT 500 devices) to one RS-485 port in the host
computer. For connections, see figure below.
Remote Computer Control
A Small Office configuration enables a cascade
connection of up to 3 Office Dock units (15 HDT 500
devices) to the host computer. A Line Modem is used
for communication with remote located host
computer. For connections, see figure below.
To 90-240VAC
Power Outlet
J1
J2
Screen
Navigation Keys
Screen Light
(When pressed with
Shift key, contrast
level increases
cyclically).
J4
J3
J2
IMPORTANT: To
save battery power,
use Screen Light
only when needed.
J1
To
Phone
Line
RS-232
cables
Line Modem
Barcode Scanner
Keys (for left-hand
RS-485
cables
(28.8 or 33.6kb/s)
J4
J3
To Third Office Dock Unit
and right-hand users)
and Motorola are registered trademarks of Motorola Inc.
Space Key
© Motorola Inc., 2000
Host computer
Space Key
(Operation is
defined by
configuration)
To more Office Dock Units
RS-485 to RS-232 Converter
68P02 960C11-A
@6802960C11@
Battery Charge LED
HDT 500 Series
(see figure below)
Hand-held Data Terminal
• No light - Not in use
with Wide Area Network Radio Modem
And LASER Barcode Scanner
• Red light - Battery charging (6-9 hours for full
capacity)
Quick Reference Card
• Green light - Battery fully charged
Important Note
Keypad
Battery is considered damaged when charging takes
more than 8 hours. Contact service to replace battery.
Screen
Indication Light
Buzzer
Office Dock
Infrared
communication
Aperture
HDT 500 Holster
Battery Pack
(Do not remove)
(Keep clean using
soft, damp cloth)
Power On/Off
Button
Laser Scanner
CAUTION
LASER LIGHT DO NOT STARE INTO BEAM
Caution
(Keep LASER window clean using soft, damp cloth)
Switching On
Data Communication With Host
(see figure above)
Communication between the HDT 500 and the host
computer can be established when the HDT 500 rests
in the Office Dock. When data flows from the
HDT 500 to the host computer, the Data Out yellow
LED lights.
When data flows from the host computer to the
HDT 500, the Data In yellow LED lights.
Press the Power On/Off button for more than 2
seconds. The Power Indication Light will illuminate,
indicating that the battery is O.K. and the device is
operative.
Switching Off
Press the Power On/Off button for more than 2
seconds and release. The Power Indication Light will
turn off.
HANDHELD DATA
TERMINAL
HDT Family
Safe and Efficient Operation
of Motorola Two Way Radio Products
RF OPERATIONAL CHARACTERISTICS
Your radio contains a transmitter which transmits using very short bursts of
data;a receiver which receives radio frequency (RF); and an internal antenna.
EXPOSURE TO RADIO FREQUENCY ENERGY
Your Motorola radio product is designed to comply with the following national
and international standards and guidelines regarding exposure of human beings to radio frequency electromagnetic energy:
•
•
•
•
•
•
•
•
United States Federal Communications Commission,
Code of Federal Regulations; 47 CFR part 2 sub-part J
American National Standards Institute (ANSI) / Institute of Electrical and
Electronic Engineers (IEEE) C 95. 1-1992
Institute of Electrical and Electronic Engineers (IEEE),
C95.1-1999 Edition
National Council on Radiation Protection and Measurements (NCRP) of
the United States,
Report 86, 1986
International Commission on Non-Ionizing Radiation Protection (ICNIRP
(1998)
National Radiological Protection Board of the United Kingdom, (1995)
Ministry of Health (Canada) Safety Code 6. Limits of Human Exposure to
Radiofrequency Electromagnetic Fields in the Frequency Range from 3
kHz to 300 GHz, 1999
Australian Communications Authority Radiocommunications (Electromagnetic Radiation - Human Exposure) Standard 1999 (applicable to
wireless phones only).
To assure optimal radio product performance and to make sure human exposure to radio frequency electromagnetic energy is within the guidelines set
forth in the above standards, always adhere to the following procedures:
PORTABLE RADIO PRODUCT OPERATION & EME EXPOSURE
BODY-WORN OPERATION
To maintain compliance with FCC RF exposure guidelines, if you wear a radio
product on your body when transmitting, always place the radio product in a
Motorola supplied or approved clip, holder, holster, case, or body harness.
Use of non-Motorola-approved accessories may exceed FCC RF exposure
guidelines. If you do not use a body-worn accessory, and are not using the
radio product held in the normal use position, ensure the radio product is at
least one inch (2.5 cms) from your body when transmitting.
APPROVED ACCESSORIES
For a list of approved Motorola accessories, please refer to the Quick Reference Card.
ELECTROMAGNETIC INTERFERENCE / COMPATIBILITY
NOTE: Nearly every electronic device is susceptible to electromagnetic interference (EMI) if inadequately shielded, designed or otherwise configured for
electromagnetic compatibility
FACILITIES
To avoid electromagnetic interference and/or compatibility conflicts, turn off
your radio product in any facility where posted notices instruct you to do so.
Hospitals or health care facilities may be using equipment that is sensitive to
external RF energy.
AIRCRAFT
When instructed to do so, turn off your radio product when on board an aircraft. Any use of a radio product must be in accordance with airline regulations or airline crew instructions.
68P02960C25-O
Please retain for future use
MEDICAL DEVICES
Pacemakers
The Health Industry Manufacturers Association recommends that a minimum
separation of 6 inches (15 centimeters) be maintained between a handheld
wireless radio product and a pacemaker.These recommendations are consistent with the independent research by, and recommendations of, Wireless
Technology Research.
Persons with pacemakers should:
1.
2.
3.
4.
ALWAYS keep the radio product more than six inches (15 centimeters)
from their pacemaker when the radio product is turned ON.
Not to carry the radio product in the breast pocket.
Use the radio product away from the pacemaker to minimize the potential for interference.
Turn the radio product OFF immediately if you have any reason to suspect that interference is taking place.
Hearing Aids
Some digital wireless radio products may interfere with some hearing aids. In
the event of such interferences you may want to consult your hearing aid
manufacturer to discuss alternatives.
Other Medical Devices
If you use any other personal medical device, consult the manufacturer of
your device to determine if it is adequately shielded from RF energy.Your
physician may be able to assist you in obtaining this information.
Safety and General
WARNING
When using your radio product while driving, please:
1.
2.
3.
Give full attention to driving and to the road.
Use hands-free operation, if available.
Pull off the road and park before making or answering a call if driving
conditions so require.
FOR VEHICLES WITH AIR BAG
Do not place a radio product in the area over an air bag or in the air bag
deployment area. Air bags inflate with great force. If a portable radio product
is placed in the air bag deployment area and the air bag inflates, the radio
product may be propelled with great force and cause serious injury to occupants of the vehicle.
POTENTIALLY EXPLOSIVE ATMOSPHERES
Turn off your two way radio product prior to entering any area with a potentially explosive atmosphere, unless it is a radio product type especially qualified for use in such areas as “Intrinsically Safe” (for example, Factory Mutual,
CSA, or UL Approved). Do not remove, install, or charge batteries in such
areas. Sparks in a potentially explosive atmosphere can cause an explosion
or fire resulting in bodily injury or even death.
NOTE: The areas with potentially explosive atmospheres referred to above include fueling
areas such as; below decks on boats, fuel or chemical transfer or storage facilities, areas
where the air contains chemicals or particles such as grain, dust, or metal powders;and
any other area where you would normally be advised to turn off your vehicle engine. Areas
with potentially explosive atmospheres are often but not always posted.
BLASTING CAPS AND AREAS
To avoid possible interference with blasting operations, turn off your radio
product when you are near electrical blasting caps, in a "blasting area", or in
areas posted: "turn off two-way radio." Obey all signs and instructions.
Use While Driving
Check the laws and regulations on the use of radio products in the area
where you drive. Always obey them.
OPERATIONAL WARNINGS
OPERATIONAL CAUTIONS
BATTERIES
Caution
All batteries can cause property damage and/or bodily injury such as burns if
a conductive material such as jewelry, keys, or beaded chains touch exposed
terminals. The conductive material may complete an electrical circuit (short
circuit) and become quite hot. Exercise care in handling any charged battery,
particularly when placing it inside a pocket, purse, or other container with
metal objects.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Producer                        : Acrobat Distiller 4.0 for Windows
Creator                         : Microsoft Word 8.0
Modify Date                     : 2000:12:18 06:02:41-08:00
Author                          : Compaq
Title                           : FCC Certification Report for the
Create Date                     : 2000:10:29 07:47:33
Page Count                      : 5
Page Mode                       : UseNone

EXIF Metadata provided by EXIF.tools