Motorola Symbol Ds6707 Users Manual Digital Imager Scanner Product Reference Guide (72E 83978 06 Rev A)

2015-01-23

• Symbol DS6707 Product Reference Guide
  • Patents
  • Revision History
• Table of Contents
• About This Guide
  • Introduction
  • Configurations
  • Chapter Descriptions
  • Notational Conventions
  • Related Documents
  • Service Information
• Getting Started
  • Introduction
  • Supported Interfaces
  • Unpacking
  • Setting Up the Digital Imager Scanner
    • Installing the Interface Cable
    • Removing the Interface Cable
    • Connecting Power (if required)
    • Configuring the Digital Imager Scanner
  • Mounting the Digital Imager Scanner
    • Desk Mount
    • Wall Mount
• Scanning
  • Introduction
  • Beeper Definitions
  • LED Definitions
  • Scanning in Hand-Held Mode
    • Scanning with the Digital Imager Scanner
    • Aiming
  • Scanning in Presentation Mode
  • Decode Zones
    • Symbol DS6707-SR Standard Range Digital Imager Scanner - 1D Bar Codes
    • Symbol DS6707-SR Standard Range Digital Imager Scanner - 2D Bar Codes
    • Symbol DS6707-DC Document Capture Digital Imager Scanner - 1D Bar Codes
    • Symbol DS6707-DC Document Capture Digital Imager Scanner - 2D Bar Codes
    • Symbol DS6707-DP Direct Part Mark Digital Imager Scanner - 1D and PDF417 Bar Codes
    • Symbol DS6707-DP Direct Part Mark Digital Imager Scanner - 2D Bar Codes
    • Symbol DS6707-HD High Density Digital Imager Scanner - 1D and PDF417 Bar Codes
    • Symbol DS6707-HD High Density Digital Imager Scanner - 2D Bar Codes
• Maintenance & Technical Specifications
  • Introduction
  • Maintenance
  • Troubleshooting
  • Technical Specifications
  • Digital Imager Scanner Signal Descriptions
• User Preferences & Miscellaneous Digital Imager Scanner Options
  • Introduction
  • Scanning Sequence Examples
  • Errors While Scanning
  • User Preferences and Miscellaneous Options - Parameter Defaults
  • User Preferences
    • Set Default Parameter
    • Parameter Scanning
    • Beeper Tone
    • Beeper Volume
    • Power Mode
    • Time Delay to Low Power Mode
    • Trigger Mode
    • Picklist Mode
    • Decode Session Timeout
    • Timeout Between Decodes, Same Symbol
    • Decoding Illumination
    • DP Illumination
    • Decode Aiming Pattern
    • Fuzzy 1D Processing
    • Decode Mirror Images (Data Matrix Only)
  • Miscellaneous Scanner Parameters
    • Transmit Code ID Character
    • Prefix/Suffix Values
    • Scan Data Transmission Format
    • FN1 Substitution Values
    • Transmit “No Read” Message
• Imaging Preferences
  • Introduction
  • Scanning Sequence Examples
  • Errors While Scanning
  • Imaging Preferences Parameter Defaults
  • Imaging Preferences
    • Operational Modes
    • Low Light Enhancement
    • Presentation Mode Field of View
    • Image Capture Autoexposure
    • Image Capture Illumination
    • Illumination Bank Control
    • Fixed Exposure
    • Fixed Gain
    • Gain/Exposure Priority for Snapshot Mode
    • Snapshot Mode Timeout
    • Snapshot Aiming Pattern
    • Image Cropping
    • Crop to Pixel Addresses
    • Image Size (Number of Pixels)
    • Image Brightness (Target White)
    • JPEG Image Options
    • JPEG Target File Size
    • JPEG Quality and Size Value
    • Image Enhancement
    • Image File Format Selector
    • Bits Per Pixel
    • Signature Capture
    • Signature Capture File Format Selector
    • Signature Capture Bits Per Pixel
    • Signature Capture Width
    • Signature Capture Height
    • Signature Capture JPEG Quality
    • Video View Finder
    • Target Video Frame Size
    • Video View Finder Image Size
• SSI Interface
  • Introduction
  • Connecting Using Simple Serial Interface
  • Simple Serial Interface Default Parameters
  • SSI Host Parameters
    • Baud Rate
    • Parity
    • Check Parity
    • Software Handshaking
    • Host RTS Line State
    • Decode Data Packet Format
    • Stop Bit Select
    • Host Serial Response Time-out
    • Host Character Time-out
    • Multipacket Option
    • Interpacket Delay
  • Event Reporting
    • Decode Event
    • Boot Up Event
    • Parameter Event
• USB Interface
  • Introduction
  • Connecting a USB Interface
  • USB Parameter Defaults
  • USB Host Parameters
    • USB Device Type
    • Symbol Native API (SNAPI) Status Handshaking
    • USB Country Keyboard Types (Country Codes)
    • USB Keystroke Delay
    • USB CAPS Lock Override
    • USB Ignore Unknown Characters
    • Emulate Keypad
    • Emulate Keypad with Leading Zero
    • USB Keyboard FN 1 Substitution
    • Function Key Mapping
    • Simulated Caps Lock
    • Convert Case
  • ASCII Character Set for USB
• RS-232 Interface
  • Introduction
  • Connecting an RS-232 Interface
  • RS-232 Parameter Defaults
  • RS-232 Host Parameters
    • RS-232 Host Types
    • Baud Rate
    • Parity
    • Stop Bit Select
    • Data Bits
    • Check Receive Errors
    • Hardware Handshaking
    • Software Handshaking
    • Host Serial Response Time-out
    • RTS Line State
    • Beep on <BEL>
    • Intercharacter Delay
    • Nixdorf Beep/LED Options
    • Ignore Unknown Characters
  • ASCII Character Set for RS-232
• 123Scan
  • Introduction
  • 123Scan Parameter
• Symbologies
  • Introduction
  • Scanning Sequence Examples
  • Errors While Scanning
  • Symbology Parameter Defaults
  • UPC/EAN
    • Enable/Disable UPC-A
    • Enable/Disable UPC-E
    • Enable/Disable UPC-E1
    • Enable/Disable EAN-8/JAN-8
    • Enable/Disable EAN-13/JAN-13
    • Enable/Disable Bookland EAN
    • Decode UPC/EAN/JAN Supplementals
    • User-Programmable Supplementals
    • UPC/EAN/JAN Supplemental Redundancy
    • Transmit UPC-A Check Digit
    • Transmit UPC-E Check Digit
    • Transmit UPC-E1 Check Digit
    • UPC-E1 Preamble
    • Convert UPC-E1 to UPC-A
    • UCC Coupon Extended Code
    • ISSN EAN
  • Code 128
    • Enable/Disable Code 128
    • Set Lengths for Code 128
    • Enable/Disable GS1-128 (formerly UCC/EAN-128)
    • Enable/Disable ISBT 128
    • ISBT Concatenation
    • Check ISBT Table
    • ISBT Concatenation Redundancy
  • Code 39
    • Enable/Disable Code 39
    • Enable/Disable Trioptic Code 39
    • Convert Code 39 to Code 32
    • Code 32 Prefix
    • Set Lengths for Code 39
    • Code 39 Check Digit Verification
    • Transmit Code 39 Check Digit
    • Code 39 Full ASCII Conversion
    • Code 39 Buffering (Scan & Store)
  • Code 93
    • Enable/Disable Code 93
    • Set Lengths for Code 93
  • Code 11
    • Code 11
    • Set Lengths for Code 11
    • Code 11 Check Digit Verification
    • Transmit Code 11 Check Digits
  • Interleaved 2 of 5 (ITF)
    • Enable/Disable Interleaved 2 of 5
    • Set Lengths for Interleaved 2 of 5
    • I 2 of 5 Check Digit Verification
    • Transmit I 2 of 5 Check Digit
    • Convert I 2 of 5 to EAN-13
  • Discrete 2 of 5 (DTF)
    • Enable/Disable Discrete 2 of 5
    • Set Lengths for Discrete 2 of 5
  • Codabar (NW - 7)
    • Enable/Disable Codabar
    • Set Lengths for Codabar
    • CLSI Editing
    • NOTIS Editing
  • MSI
    • Enable/Disable MSI
    • Set Lengths for MSI
    • MSI Check Digits
    • Transmit MSI Check Digit(s)
    • MSI Check Digit Algorithm
  • Chinese 2 of 5
    • Enable/Disable Chinese 2 of 5
  • Matrix 2 of 5
    • Enable/Disable Matrix 2 of 5
    • Set Lengths for Matrix 2 of 5
    • Matrix 2 of 5 Redundancy
    • Matrix 2 of 5 Check Digit
    • Transmit Matrix 2 of 5 Check Digit
  • Inverse 1D
  • Postal Codes
    • US Postnet
    • US Planet
    • Transmit US Postal Check Digit
    • UK Postal
    • Transmit UK Postal Check Digit
    • Japan Postal
    • Australian Postal
    • Netherlands KIX Code
    • USPS 4CB/One Code/Intelligent Mail
    • UPU FICS Postal
  • GS1 DataBar
    • GS1 DataBar-14
    • GS1 DataBar Limited
    • GS1 DataBar Expanded
    • Convert GS1 DataBar to UPC/EAN
  • Composite
    • Composite CC-C
    • Composite CC-A/B
    • Composite TLC-39
    • UPC Composite Mode
    • Composite Beep Mode
    • GS1-128 Emulation Mode for UCC/EAN Composite Codes
  • 2D Symbologies
    • Enable/Disable PDF417
    • Enable/Disable MicroPDF417
    • Code 128 Emulation
    • Data Matrix
    • Data Matrix Inverse
    • Maxicode
    • QR Code
    • QR Inverse
    • MicroQR
    • Aztec
    • Aztec Inverse
  • Redundancy Level
    • Redundancy Level 1
    • Redundancy Level 2
    • Redundancy Level 3
    • Redundancy Level 4
  • Security Level
    • Intercharacter Gap Size
  • Report Version
  • Macro PDF Features
    • Flush Macro Buffer
    • Abort Macro PDF Entry
• Advanced Data Formatting
  • Introduction
  • Rules: Criteria Linked to Actions
  • Using ADF Bar Codes
  • ADF Bar Code Menu Example
    • Rule 1: The Code 128 Scanning Rule
    • Rule 2: The UPC Scanning Rule
    • Alternate Rule Sets
    • Rules Hierarchy (in Bar Codes)
    • Default Rules
  • ADF Bar Codes
  • Special Commands
    • Pause Duration
    • Begin New Rule
    • Save Rule
    • Erase
    • Quit Entering Rules
    • Disable Rule Set
  • Criteria
    • Code Types
    • Code Lengths
    • Message Containing A Specific Data String
  • Actions
    • Send Data
    • Setup Field(s)
    • Modify Data
    • Pad Data with Spaces
    • Pad Data with Zeros
    • Beeps
    • Send Keystroke (Control Characters and Keyboard Characters)
    • Send Right Control Key
    • Send Graphic User Interface (GUI) Characters
    • Turn On/Off Rule Sets
  • Alphanumeric Keyboard
• Standard Default Parameters
• Programming Reference
  • Symbol Code Identifiers
  • AIM Code Identifiers
• Sample Bar Codes
  • Code 39
  • UPC/EAN
    • UPC-A, 100%
    • EAN-13, 100%
  • Code 128
  • Interleaved 2 of 5
  • GS1 DataBar-14
  • PDF417
  • Data Matrix
  • Maxicode
  • QR Code
  • US Postnet
  • UK Postal
• Numeric Bar Codes
  • Numeric Bar Codes
  • Cancel
• ASCII Character Sets
• Index
• Tell Us What You Think...