Multitone Electronics PLC EKOFOB 2 way alarm and alerting device User Manual Layout 1

Multitone Electronics PLC 2 way alarm and alerting device Layout 1

Handy guide

Buttons(from top to bottom): Grey button: on/off and alarmcancelBlue button: assist alarmRed button: emergency alarm1.Turning on the deviceTo turn the fob on for the first time, place the device in thecharger and remove after the recommended 12 hours.The pager may take a few minutes to charge before turning on. Otherwise, to turn the device on press thegrey button for up to 3 seconds, the device will beep toacknowledge the actionTurning off the deviceTo turn the device off, press and hold the grey button forup to 3 seconds, the device will beep to acknowledge theactionCharging the batterylThe fob is fitted with a AAA Ni-Mh rechargeable battery lTo charge the battery, place the device in the charger,the LED will flash to acknowledge charging:1 flash every 3 seconds – charging2 flashes every 3 seconds – chargedDo NOT attempt to remove the battery. Opening the device will invalidate any warranty. Please give the device to your administrator for return to a MultitoneAgent for service. 2. 3.Emergency Alarm (red button): (if enabled)lSend Emergency Assist call (1 or 2 pushes asconfigured by supervisor)lWhen the Emergency Alert button pressed you will see the following:Alarm being sent: Slow flashAlarm delivered: 2 Fast flashes Alarm accepted: 3 Fast flashes (only when accepted by another user)lTo clear a raised alarm press the grey button (short press)4. Assist Alarm (blue button): (if enabled)l1 push raises assist alarm (alarm automatically cleared)lWhen pressed you will see the following:Alarm being sent: Slow flashAlarm delivered: 2 Fast flashes Wander Alarm: Upon entering a restricted zone, the fobactivates an alert.Man-Down Alarm: If unit is tilted more than 45 degreesfor longer than the configured trigger periodDead-Man Alarm: If a response is not entered to the periodic promptStatus IndicatorslTo check if the device is on the network press greybutton (short press)(LED : one flash = off network, two flashes = on network)lA low battery status alarm will be activated when the battery reaches less than 25% (audible and vibrate)lWhen the fob is out of range of the EkoTek network, an alarm will be activated to notify the user5. 6.Welcome to yourEkoTek Fob QuickGuideFurther instructions are available from the multitone support sitewww.multitone.comFor further information or troubleshooting, please refer to your system administrator.
EU Declaration of Conformity In Accordance With Article 6.3 of the EU Radio & Telecommunication Terminal Equipment R & TTE Directive 99/5/EC.As the manufacturer, we declare under our sole responsibility that the EKOFOB equipment conformsto all the applicable essential requirements of the EU Directive 99/5/EC, in accordance with the procedures of Annex II of the Directive and the following technical standards:-ETSI EN 300 328 (Directive article 3.2);ETSI EN 301 489-1; ETSI EN 301 489-3 (Directive article 3.1{b});EN 60950 (Directive article 3.1{a}).These equipments are designated as Class 1, Sub Class 21 (non-specific short range device) underthe terms of the Directive and TCAM (Telecommunication Conformity Assessment and Market Surveillance Committee) classification scheme. A full copy of the Declaration of Conformity may be obtained from www.multitone.com , or upon application to Multitone. FCC & Industry Canada Statement of ComplianceThis device complies with Part 15 of the FCC Rules and Industry Canada Standards RSS GEN &RSS210.Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference that may cause undesired operation.Unauthorised modification to this equipment will void the user's authority to continue to operate thedevice within the scope of the Industry Canada and FCC Part 15 Rules.WEEE Directive & Product Disposal At the end of its serviceable life, this product should not be treatedas household or general waste. It should be handed over to the applicable collection point for the recycling of electrical and electronic equipment, or returned to Multitone or their agent, for disposal.Literature No: EkoTek Fob/cc/issue 1 Product No.: FOB-9261-9167

Navigation menu