Murata LB1MW Communication Module User Manual LBWA1ZZ1CA Installation Manual

Murata Manufacturing Co., Ltd. Communication Module LBWA1ZZ1CA Installation Manual

05 (Short-Term Confidential) User Manual_FCC

1Copyright © Murata Manufacturing Co., Ltd. All rights reserved. 12 September 20171MW User Manual for FCC*If it is difficult to describe this statement on the host product due to the size, please describe in the User's manual.or Contains Transmitter Module FCC ID:VPYLB1MW Contains FCC ID: VPYLB1MWThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Since this module is not sold to general end users directly, there is no user manual of module.For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification (installation procedure). ●The following information must be indicated on the host device of this module. FCC ID:VPYLB1MW
2Copyright © Murata Manufacturing Co., Ltd. All rights reserved. 12 September 20171MW User Manual for FCCThis transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.Compliance with FCC requirement 15.407(c)Data transmission is always initiated by software, which is the passed down through the MAC, through the digitaland analog baseband, and finally to the RF chip. Several special packets are initiated by the MAC. These are theonly ways the digital baseband portion will turn on the RF transmitter, which it then turns off at the end of thepacket. Therefore, the transmitter will be on only while one of the aforementioned packets is being transmitted. Inother words, this device automatically discontinue transmission in case of either absence of information to transmitor operational failure.Frequency Tolerance: ±20 ppm●The following statements must be described on the user manual of the host device of this module;FCC CAUTIONChanges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
3Copyright © Murata Manufacturing Co., Ltd. All rights reserved. 12 September 20171MW User Manual for FCCThis equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body.●When installing it in a mobile equipment. Please describe the following warning to the manual.
4Copyright © Murata Manufacturing Co., Ltd. All rights reserved. 12 September 20171MW User Manual for FCCNote) Portable equipment : Equipment for which the spaces between human body and antenna are used within 20cm. Mobile equipment : Equipment used at position in which the spaces between human body and antenna exceeded 20cm. ●When installing it in a portable equipment. Please describe the following warning to the manual.It is necessary to take a SAR test with your set mounting this module (except to use only Bluetooth V4.2(BDR/EDR/LE)).Class II permissive change application is necessary using the SAR report. Please contact Murata.The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure of low-level RF that does not produce heating effects causes no known adverse health effects. Many studies of low-level RF exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not been confirmed by additional research. 1MW has been tested and found to comply with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF)Exposure Guidelines.

Navigation menu