NEC of America CUL7580 Cellular/ PCS GSM and Cellular WCDMA Tablet with WLAN, Bluetooth and RFID User Manual RF Warning Page

Download:
Mirror Download [FCC.gov]
Document ID	1634988
Application ID	jQwmX0sQYhUFmNY/X8qPNg==
Document Description	Users Manual RF Warning Page
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	73.77kB (922086 bits)
Date Submitted	2012-02-10 00:00:00
Date Available	2012-08-08 00:00:00
Creation Date	2017-11-01 23:46:00
Producing Software	GPL Ghostscript 9.18
Document Lastmod	2017-11-01 23:46:00
Document Title	Users Manual RF Warning Page

Radio Frequency (RF) Signals
THIS DEVICE MEETS THE US.
GOVERNMENT'S REQUIREMENTS FOR
EXPOSURE TO RADIO WAVES.
Your device is a radio transmitter and receiver.
Your device is designed and manufactured not to
exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal
Communications Commission of the US.
Government. These limits are part of
comprehensive guidelines and establish permitted
levels of RF energy for the general population. The
guidelines are based on standards that were
developed by independent scientific organizations
through periodic and thorough evaluation of
scientific studies.
The exposure standard for device employs a
unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by
the FCC is 1.6 W/kg.* Tests for SAR are
conducted using standard operating positions
accepted by the FCC with the device
transmitting at its highest certified power
level in all tested frequency bands. Although
the SAR is determined at the highest certified
power level, the actual SAR level of the device
while operating can be well below the
maximum value. This is because the device is
designed to operate at multiple power levels
so as to use only the power required to reach
the network. In general, the closer you are to a
wireless base station antenna, the lower the
output.
Before a device is available for sale to the
public, it must be tested and certified to the
FCC that it does not exceed the limit
established by the US. government—adopted
requirement for safe exposure. The tests are
performed in position and locations (for
example, at the ear and placed on the body)
as required by FCC for each model. The
highest SAR value for this device as reported
to the FCC when held-to ear is 0.04 W/kg, and
when placed on the body, is 0.92 W/kg.
The FCC has granted an Equipment Authorization
for this model phone with all reported SAR levels
evaluated as in compliance with the FCC RF
exposure guidelines. SAR information on this
model phone is on file with the FCC and can be
found under the Display Grant section at
https://guIIfoss2.fcc.gov/oetcf/eas/reports/
GenericSearch.cfm after search on FCC ID A98-
CUL7580.
This device has been tested for RF Exposure
and meets the FCC RF exposure guidelines.
* In the United States and Canada, the SAR
limit for wireless mobile phones used by the
public is l 6 watts/kg (W/kg) averaged over
one gram of tissue. The standard incorporates
a substantial margin of safety to give
additional protection for the public and to
account for any variations in measurements.
FCC Regulations
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
This device has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This device generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation; if this device does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
-Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/
TV technician for help.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract, Print high-res
Author                          : 
Create Date                     : 2012:02:03 15:40:52Z
Modify Date                     : 2012:02:10 15:05:44-05:00
Subject                         : 
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Format                          : application/pdf
Creator                         : 
Description                     : 
Title                           : 
Creator Tool                    : 
Metadata Date                   : 2012:02:10 15:05:44-05:00
Keywords                        : 
Producer                        : YSS IMGtoPDF V2.1
Document ID                     : uuid:6736dbeb-44d0-473f-b5f2-2e4c7105fc32
Instance ID                     : uuid:b57acc80-d679-470a-889d-7945ea4a1f07
Page Count                      : 2

EXIF Metadata provided by EXIF.tools