NMB Technologies 2300 Keyboard User Manual nmb kbd manual
NMB Technologies Corp. Keyboard nmb kbd manual
Users Manual
Notice
Information in this manual is subject to change without notice.
NMB TECHNOLOGIES IS NOT LIABLE FOR TECHNICAL OR
EDITORIAL ERRORS OR OMISSIONS CONTAINED IN THIS
DOCUMENT; NOR FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES RESULTING FROM THE FURNISHING,
PERFORMANCE OR USE OF THIS MATERIAL.
NMB Technologies, Inc.
Computer Keyboard
User's Manual
To Install the Keyboard:
• Turn off computer before installing the keyboard.
• Find the keyboard receptacle on the rear panel of the
computer. Usually, an icon can be seen to identify the
keyboard connector as shown below.
• Connect keyboard plug on keyboard cable to the proper
receptacle on the computer.
• Note: Never attempt to force the plug into the receptacle if it
does not fit!
To Angle the Keyboard:
• Use the fold-out tilt legs, located at the back left and right
corners on the underside of the keyboard. Pull the tabs
outward to full open position. Do not use excessive force
when doing so.
Tilt leg Back of Keyboard
Tilt leg
Underside of Keyboard
Front of Keyboard
Keyboard
Tilt leg
Information to User:
The user that changes or performs modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operation the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on circuit different from that to which the
receiver is connected
Consult the dealer or an experienced radio/TV technician for help
9730 Independence Ave., Chatsworth, CA 91311 (818) 341-0820