NYNE MULTIMEDIA NYNEEDGE Bluetooth speaker User Manual NYNE Edge Safety Guide 2

NYNE MULTIMEDIA INC. Bluetooth speaker NYNE Edge Safety Guide 2

Manual

Do not use the device if any abnormality occurs. If any smoke or odor becomes apparent, contact your dealer immediately. Do not try to repair the device yourself. Avoid using dropped or damaged appliances. If the device is dropped and the housing is damaged, the internal components may not function normally. Stop use and contact your dealer for shock. To reduce the risk of electric shock, do not touch any connector with wet hands.Never remove the housing of the device.Never lubricate any part of the device.Never place the device on top of any other electrical equipment. This equipment is a Class II or double insulated electrical appliance. It has been designed in such a way that it does not require a safety connection to electrical earth.NoticeModificationdevice, without prior authorization from the manufacturer, may void your warranty and authority to operate the device.FCC compliance statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.This Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.Radiation Exposure Statement:This equipment complies with FCC radiation exposure requirement. The device can be used in portable exposure condition without RF striction CE statementThis product complies with the radio interference requirements of the European Community.Recycling PackagingObserve the local regulations for how to dispose of the packaging materials.ImportantSafety within an equilateral triangle is intended to alert the user to the presence of un-isolated, dangerous voltage within the inside of the to constitute a risk of electric shock to persons.Warning: To reduce the risk of electric shock, do not remove cover (or back) as there are no user-serviceable parts inside. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and servicing instructions in the literature accompanying the device.WARNING: Where the mains plug/appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.WARNING: The battery (battery or batteries or battery pack) the like.Read these instructions before operation.Keep these instructions for future reference.Follow all instructions for installation, use and maintenance of the device.This device complies with the IPX5 waterproof standard.Before using the device in the rain or moisty conditions or rinsing the device with fresh water, always securely close the protective cover at the back of the device.Never open the protective cover when the device is still wet after use. Always clean with a soft dry cloth and let it dry in a well-ventilated place away from direct sunlight.and dry cloth.To ensure compatibility, only use accessories recommended by the manufacturer.When the device is suddenly moved from cold to warm surroundings, condensation may form in the housing of the device. Before use, leave the device in the warm environment until the moisture evaporates.Keep the device away from heat sources, such as a radiator, placed on the apparatus.device, the lens may get very hot after some time. This is not a malfunction.Never block any ventilation openings. Install in accordance with the manufacturer’s instructions.• Do not expose the device to sand or dust, or cover it with items, such as newspapers, table cloths, or curtains. • Do not operate the device in an enclosed cabinet. Leave ventilation.Do not attempt to repair or service the device yourself. Opening or removing the cabinet may expose you to electric shock, and other hazards. If repair is required, contact your dealer and refer EN WEEE NOTICEThe Directive on Waste Electrical and Electronic Equipment (WEEE), which entered into force as European law on 13th February 2003, resulted in a major change in the treatment of electrical equipment at end - of - life.WEEE, and in addition, to promote the reuse, recycling and other forms of recovery of such wastes so as to reduce disposal.The WEEE logo on the product or on its box indicating collection for electrical and electronic equipment consists of the crossed -out wheeled bin, as shown below. This product must not be disposed of or dumped with your other household waste. You are liable to dispose of all your electronic or electrical waste equipment for recycling of such hazardous waste. Isolated collection and proper recovery of your electronic and electrical waste equipment at the time of disposal will allow us to help conserving natural resources. Moreover, proper recycling of the electronic and electrical waste equipment will ensure safety of human health and environment. For more information about electronic and electrical waste equipment disposal, recovery, and collection points, please contact your local city center, household waste disposal service, shop from where you purchased the equipment, or manufacturer of the equipment.ROHS COMPLIANCEThis product is in compliance with Directive 2011/65/EU of the European Parliament and of the Council of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and electronic equipment.FOR PRODUCTS THAT INCLUDE BATTERIESEU Batteries Directive 2006/66/ECA new battery directive 2006/66/EC on Battery and Accumulator replacing directive entered into force on the 26th September 2008. The directive applies to all types of batteries and accumulators (AA, AAA, button cells, lead acid, rechargeable packs) including those incorporated into appliances except for military, medical and power tool applications.The directive sets out rules for collection, treatment, recycling and disposal of batteries, and aims to prohibit certain hazardous substances and to improve environmental performance of batteries and all operators in the supply chain.Instructions for Users on Removal, Recycling and Disposal of Used BatteriesTo remove the batteries from your equipment or remote control, reverse the procedure described in the owner’s manual for inserting batteries.For products with a built-in battery that lasts for the lifetime of the product, removal may not be possible for the user. In this case, recycling or recovery centers handle the dismantling of the product and the removal of the battery. If, for any reason, it becomes necessary to replace such a battery, this procedure must be performed by authorized service centers. In the European Union and other locations, it is illegal to dispose of any battery with household trash. All batteries must be disposed of in an environmentally sound manner. Contact your local waste-ly sound collection, recycling and disposal of used batteries.WARNING: Danger of explosion if battery is incorrectly replaced. short external contacts, expose to temperature above 60°C batteries. The symbol indicating ‘separate collection’ for all batteries and accumulators shall be the crossedout wheeled bin shown below:In case of batteries, accumulators and button cells containing more than 0.0005 % mercury, more than 0.002 % cadmium or more than 0.004 % lead, shall be marked with the chemical symbol for the metal concerned: Hg, Cd or Pb respectively. Please Refer to the below symbol:Copyright EdgeSafety GuideSikkerhedsvejledningPortable Bluetooth SpeakerBærbar højttaler med BluetoothAltavoz Bluetooth portátilKannettava Bluetooth-kaiutinwithout notice.All registered and unregistered trademarks are property of their respective owners.Nyne Multimedia Inc.All rights reserved. SG-Edge-04-07-2015-V. 1.0nyne.comENENDADAFIES

Navigation menu