NYNE MULTIMEDIA NYNEEDGE Bluetooth speaker User Manual NYNE Edge Safety Guide 2
NYNE MULTIMEDIA INC. Bluetooth speaker NYNE Edge Safety Guide 2
Manual
Do not use the device if any abnormality occurs. If any smoke or
odor becomes apparent, contact your dealer immediately. Do
not try to repair the device yourself.
Avoid using dropped or damaged appliances. If the device is
dropped and the housing is damaged, the internal components
may not function normally. Stop use and contact your dealer for
shock.
To reduce the risk of electric shock, do not touch any connector
with wet hands.
Never remove the housing of the device.
Never lubricate any part of the device.
Never place the device on top of any other electrical equipment.
This equipment is a Class II or double insulated electrical
appliance. It has been designed in such a way that it
does not require a safety connection to electrical earth.
Notice
Modification
device, without prior authorization from the manufacturer, may
void your warranty and authority to operate the device.
FCC compliance statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause
undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure
requirement. The device can be used in portable exposure
condition without RF striction
CE statement
This product complies with the radio interference requirements of
the European Community.
Recycling
Packaging
Observe the local regulations for how to dispose of the
packaging materials.
Important
Safety
within an equilateral triangle is intended to
alert the user to the presence of un-isolated,
dangerous voltage within the inside of the
to constitute a risk of electric shock to persons.
Warning: To reduce the risk of electric shock, do not remove
cover (or back) as there are no user-serviceable parts inside.
The exclamation point within an equilateral
triangle is intended to alert the user to
the presence of important operating
and servicing instructions in the literature
accompanying the device.
WARNING: Where the mains plug/appliance coupler is used
as the disconnect device, the disconnect device shall remain
readily operable.
WARNING: The battery (battery or batteries or battery pack)
the like.
Read these instructions before operation.
Keep these instructions for future reference.
Follow all instructions for installation, use and maintenance of the
device.
This device complies with the IPX5 waterproof standard.
Before using the device in the rain or moisty conditions or rinsing
the device with fresh water, always securely close the protective
cover at the back of the device.
Never open the protective cover when the device is still wet
after use. Always clean with a soft dry cloth and let it dry in a
well-ventilated place away from direct sunlight.
and dry cloth.
To ensure compatibility, only use accessories recommended by
the manufacturer.
When the device is suddenly moved from cold to warm
surroundings, condensation may form in the housing of the
device. Before use, leave the device in the warm environment
until the moisture evaporates.
Keep the device away from heat sources, such as a radiator,
placed on the apparatus.
device, the lens may get very hot after some time. This is not a
malfunction.
Never block any ventilation openings. Install in accordance with
the manufacturer’s instructions.
• Do not expose the device to sand or dust, or cover it with
items, such as newspapers, table cloths, or curtains.
• Do not operate the device in an enclosed cabinet. Leave
ventilation.
Do not attempt to repair or service the device yourself. Opening
or removing the cabinet may expose you to electric shock, and
other hazards. If repair is required, contact your dealer and refer
EN WEEE NOTICE
The Directive on Waste Electrical and Electronic Equipment
(WEEE), which entered into force as European law on 13th
February 2003, resulted in a major change in the treatment of
electrical equipment at end - of - life.
WEEE, and in addition, to promote the reuse, recycling and other
forms of recovery of such wastes so as to reduce disposal.
The WEEE logo on the product or on its box indicating collection
for electrical and electronic equipment consists of the crossed
-out wheeled bin, as shown below.
This product must not be disposed of or dumped with
your other household waste. You are liable to dispose
of all your electronic or electrical waste equipment
for recycling of such hazardous waste. Isolated collection
and proper recovery of your electronic and electrical
waste equipment at the time of disposal will allow us to help
conserving natural resources. Moreover, proper recycling of
the electronic and electrical waste equipment will ensure
safety of human health and environment. For more information
about electronic and electrical waste equipment disposal,
recovery, and collection points, please contact your local city
center, household waste disposal service, shop from where you
purchased the equipment, or manufacturer of the equipment.
ROHS COMPLIANCE
This product is in compliance with Directive 2011/65/EU of the
European Parliament and of the Council of 8 June 2011 on the
restriction of the use of certain hazardous substances in electrical
and electronic equipment.
FOR PRODUCTS THAT INCLUDE BATTERIES
EU Batteries Directive 2006/66/EC
A new battery directive 2006/66/EC on Battery and Accumulator
replacing directive entered into force on the 26th September
2008. The directive applies to all types of batteries and
accumulators (AA, AAA, button cells, lead acid, rechargeable
packs) including those incorporated into appliances except for
military, medical and power tool applications.
The directive sets out rules for collection, treatment, recycling
and disposal of batteries, and aims to prohibit certain hazardous
substances and to improve environmental performance of
batteries and all operators in the supply chain.
Instructions for Users on Removal, Recycling and Disposal of Used Batteries
To remove the batteries from your equipment or remote control,
reverse the procedure described in the owner’s manual for
inserting batteries.
For products with a built-in battery that lasts for the lifetime of
the product, removal may not be possible for the user. In this
case, recycling or recovery centers handle the dismantling of
the product and the removal of the battery. If, for any reason, it
becomes necessary to replace such a battery, this procedure
must be performed by authorized service centers. In the European
Union and other locations, it is illegal to dispose of any battery
with household trash. All batteries must be disposed of in an
environmentally sound manner. Contact your local waste-
ly
sound collection, recycling and disposal of used batteries.
WARNING: Danger of explosion if battery is incorrectly replaced.
short external contacts, expose to temperature above 60°C
batteries.
The symbol indicating ‘separate collection’ for all batteries and
accumulators shall be the crossedout wheeled bin shown below:
In case of batteries, accumulators and button cells
containing more than 0.0005 % mercury, more than 0.002
% cadmium or more than 0.004 % lead, shall be marked
with the chemical symbol for the metal
concerned: Hg, Cd or Pb respectively.
Please Refer to the below symbol:
Copyright
Edge
Safety Guide
Sikkerhedsvejledning
Portable Bluetooth Speaker
Bærbar højttaler med Bluetooth
Altavoz Bluetooth portátil
Kannettava Bluetooth-kaiutin
without notice.
All registered and unregistered trademarks
are property of their respective owners.
Nyne Multimedia Inc.
All rights reserved.
SG-Edge-04-07-2015-V. 1.0
nyne.com
EN
EN
DA
DA
FI
ES