Namsung XDMAR6720BT Bluetooth Module User Manual

Namsung Corporation. Bluetooth Module Users Manual

Users Manual

XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com USER’S MANUAL XDMAR6720BT (Bluetooth Module) Namsung Corporation. 13F Crown Plaza, 197-22, Guro-dong, Guro-gu, Seoul, Korea (152-050)
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com Specifications XDMAR6720BT Frequency Range 2 402 ~ 2 480 MHz Modulation Method FHSS (Frequency Hopping Spread Spectrum) Antenna Chips Antenna The Number of Channel 79 Channels Input Voltage DC 3.3V, 50 mAh Operating Temperature Range 0 ~ +40 °C Modulation Type 8-DPSK Communication Mode Duplex
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com `
XDMAR6720BT © 2011 All rights reserved Printed in Korea http://www.namsung.com FCC RF INTERFERENCE STATEMENT FCCID : GJWXDMAR6720BT NOTE : The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. In cases where the manual is provided only in a form other than paper, such as on a computer disk or over the Internet, the information required by this section may be included in the manual in that alternative form, provided the user can reasonably be expected to have the capability to access information in that form. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures. - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio, TV technical for help. - Only shielded interface cable should be used. Finally, any changes or modifications to the equipment by the user not expressly approved by the grantee or manufacturer could void the users authority to operate such equipment

Navigation menu