Nedap N V NECKTAGCP NECK TAG CP ACT User Manual 5282039 QR Neck Nedapx

N. V. Nederlandsche Apparatenfabriek NEDAP NECK TAG CP ACT 5282039 QR Neck Nedapx

14r01_Manual CGDNECKTAGCP

N
The NECK TAG CP ACT is a label
that oa attacjhed to the cows neck and it determines the where the cow is
located in the stable also it also
monitors the behavior of individual cows 24/7 and
cow’s in heat.
A cow in heat shows more activity then being in a “normal” state of condition.
The main parts of the NECK TAG CP
ACT
and health detection are:
1. Cow positioning
together with the beacon VP4201
2. An acceleration sensor detecting
3. A
battery (active) assisted RFID (=Radio Frequency Identification) tag for individual cow activity
monitoring, operating on 433.3, 433.6
,
4. The 1
34.2 kHz inductive RFID tag (passive) is optional
The lo
cation of the cow in the stable is monitored every .10 seconds.
The motions of the cow are stored in the
memory of the RFID tag transmit
of this transmission is min. 5 minutes
and max
The antenna in the barn receives the activity information from the R
information is transported
by means of the
process controller and is e.
g. used for ovulation/heat detecting, automatic cattle feeding, separation of
animals, milk registration etc.
The Velos program determines the activity increase of an animal. If an animal is a lot more active than usual
it will get an heat
attention. The red light on the process unit will indicate this attention. The Velos program
displays o
verviews of animals with a clear increased
Figures below show how the NECK TAG
CP
NOTE:
The label can only monitor the behavior of the animals if placed on the cows neck in the right position.
Wrong Position of the label:
1. Back to front
Label attached backwards, the groove (and the arrow on the back of the label) is pointing towards
the cows
body instead of the cows head.
2. Check position
Turned sideways on the neck or twisted on the collar.
Doc. Part. No. 5282039
N
ECK TAG CP ACT
that oa attacjhed to the cows neck and it determines the where the cow is
monitors the behavior of individual cows 24/7 and
the system
will detect the
A cow in heat shows more activity then being in a “normal” state of condition.
ACT
for the purpose of cow positioning and activity me
a
together with the beacon VP4201
motions.
battery (active) assisted RFID (=Radio Frequency Identification) tag for individual cow activity
,
433.8, 434.0, 434.2 and 434.5 MHz.
34.2 kHz inductive RFID tag (passive) is optional
.
cation of the cow in the stable is monitored every .10 seconds.
memory of the RFID tag transmit
ting this data. The
rep
and max
. 15 minutes depending on the cow’s activity.
The antenna in the barn receives the activity information from the R
FID tag
of the individual animals and
by means of the
receiver VP4102 over CAN bus or Ethernet to the host computer
g. used for ovulation/heat detecting, automatic cattle feeding, separation of
The Velos program determines the activity increase of an animal. If an animal is a lot more active than usual
attention. The red light on the process unit will indicate this attention. The Velos program
verviews of animals with a clear increased
heat attention on the PC screen.
CP
ACT is attached to the cow’s neck
The label can only monitor the behavior of the animals if placed on the cows neck in the right position.
Label attached backwards, the groove (and the arrow on the back of the label) is pointing towards
body instead of the cows head.
Turned sideways on the neck or twisted on the collar.
Doc. Part. No. 5282039
that oa attacjhed to the cows neck and it determines the where the cow is
will detect the
a
ning heat –
battery (active) assisted RFID (=Radio Frequency Identification) tag for individual cow activity
rep
etition rate
of the individual animals and
the
receiver VP4102 over CAN bus or Ethernet to the host computer
g. used for ovulation/heat detecting, automatic cattle feeding, separation of
The Velos program determines the activity increase of an animal. If an animal is a lot more active than usual
attention. The red light on the process unit will indicate this attention. The Velos program
The label can only monitor the behavior of the animals if placed on the cows neck in the right position.
Label attached backwards, the groove (and the arrow on the back of the label) is pointing towards
Doc. Part. No. 5282039
Specification
Transmitter Information
Frequency : 433.3, 433.6, 433.8, 434.0, 434.2 and 433.5 MHz
Modulation : FSK modulated
DataRate : 100 kbit/s
Frequency deviation : 25 kHz
On time : 11msec
Repeat time : >10 seconds
Duty cycle : ≤ 1 %
Transmitted Power : EIRP < 1 mW
Power
Power : Battery powered 3.6 V
Antenna
Antenna : Integral, Ceramic Chip antenna
Environment
Operating Temperature : -10 to + 50 °C
Storage : -25 to + 70 °C
Relative humidity : 10 – 93% non condensing
Enclosure : IP class 67

Navigation menu