Netgear orporated 14100257 N300 Wireless Router User Manual statement

Notification of Compliance

Regulatory Compliance Information

This document includes user requirements for operating NETGEAR products in accordance with national laws

including usage of radio spectrum and operation of radio devices. Failure of the end-user to comply with the

applicable requirements may result in unlawful operation and adverse action against the end-user by the applicable

national regulatory authority.

The NETGEAR product firmware limits operation to only the channels allowed in a particular region or country.

data gateways.

 Fuses should only be installed by service personnel.

 NETGEAR recommends the use of 26 AWG or larger gauge phone line cords.

Europe – EU Declaration of Conformity

This section applies to products bearing the CE or CE! mark:

Products bearing the CE or CE! mark comply with the following EU directives:

 EMC Directive 2004/108/EC

 Low Voltage Directive 2006/95/EC

 Ecodesign Directive 2009/125/EC

http://support.netgear.com/app/answers/detail/a_id/11621/.

Caution for installing this equipment outdoors: (Valid in all EU member states, EFTA states, and Switzerland.) Be

aware that outdoor installations require special attention and will only be handled by trained and qualified installation

personnel. No one from the general public is permitted to install NETGEAR wireless products outdoors when

external antennas, power and grounding must be installed for use. Particular attention has to be given allowed

operational frequencies. Contact NETGEAR for instructions on how to contact an installer for outdoor operations if

this product requires the special considerations for outdoor installations. For detailed iformation concerning

installations in France, the user should contact the national spectrum authority in France (http://www.arcep.fr/ )

This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may

be limited to 10mW EIRP in the frequency range of 2454-2483.5 MHz. For detailed information the end-user should

contact the national spectrum authority in France.

Warning

NETGEAR Class A products that may be utilized in domestic/residential environments may cause radio interference

in which case the user may be required to take adequate measures.

FCC Requirements for Operation in the United States

Information in this section applies to products bearing the FCC mark (or statement):

FCC Guidelines for Human Exposure

The NETGEAR product complies with FCC radiation exposure limits set forth for an uncontrolled environment. The

equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.

The following statement applies to this product:

 C6300XB3

This product complies with FCC radiation exposure limits set forth for an uncontrolled environment. The device

should be installed and operated with minimum distance of 25 cm between the radiator and your body.

FCC Declaration of Conformity

We, NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole responsibility that this

product complies with Part 15 Subpart B of FCC CFR47 Rules. Operation is subject to the following two conditions:

 The device may not cause harmful interference, and

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following methods:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and the receiver.

 Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is

connected.

 Consult the dealer or an experienced radio/TV technician for help.

FCC RF Radiation Exposure and SAR Statements

The FCC has established detailed SAR requirements and NETGEAR products meet these requirements.

NETGEAR products comply with ANSI/IEEE C95.1-1999 and are tested in accordance with the measurement

methods and procedures specified in OET Bulletin 65 Supplement C.

NETGEAR products that are installed in USB ports demonstrate SAR compliance using a typical laptop computer

with a USB port. Other applications, such as handheld computers or similar devices, have not been verified and might

not compliance with related RF exposure rule and such use is prohibited.

NETGEAR products have been evaluated under FCC Bulletin OET 65C (01-01) and found to be compliant to the

requirements as set forth in CFR 47 Sections, 2.1093, and 15.247 (b) (4) addressing RF exposure from radio

frequency devices. NETGEAR products meet the applicable government requirements for exposure to radio

installed and operated keeping the product 20cm or more away from a person’s body. For devices that are battery

powered and may be operated closer than 20cm to you, refer to the NETGEAR website for exposure levels.

computer configurations where the USB connectors on the host computer are unable to provide or ensure the

necessary operating configurations intended for the device and its users or bystanders to satisfy RF exposure

compliance requirements.

FCC Caution

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate this equipment.

NETGEAR products comply with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)

NETGEAR products may not cause harmful interference, and (2) NETGEAR products must accept any interference

received, including interference that may cause undesired operation.

For products available in the USA market, only channel 1~11 can be operated. Selection of other channels is not

The device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or

transmitter except in accordance with FCC multi-transmitter product procedures.

The following statement applies to these products:

NETGEAR non-DFS products do not support operation in the 5600-5650MHz band. The firmware on the device

“This digital apparatus does not exceed the Class B limits for radio-noise emissions from digital apparatus

The following statements apply to this product:

 A6210

 C6300XB3

 HMNC100

 WAC120

 STS7000

The maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz to comply with

the EIRP (Equivalent Isotropically Raditaed Power) limit.

Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands

NETGEAR product is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102 and

had been tested in accordance with the measurement methods and procedures specified in IEEE 1528.

NOTE IMPORTANTE: Déclaration d'exposition aux radiations

Produits NETGEAR sont conformes aux limites IC d'exposition aux rayonnements définies pour un environnement

non contrôlé. Produits NETGEAR doivent être installés et utilisés avec distance minimum de 20cm entre le radiateur

et votre corps.

Produits NETGEAR sont conformes à la limite d'exposition aux RF portable Canada établies pour un environnement

non contrôlé et sont sans danger pour le fonctionnement prévu comme décrit dans le manuel. Poursuite de la

réduction de l'exposition aux RF peut être réalisé en gardant le produit autant que possible de votre corps ou par le

réglage du dispositif à une puissance de sortie inférieure si une telle fonction est disponible

Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre

antenne ou transmetteur.

La déclaration suivante s'applique à ces produits:

afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.

Sélection dynamique de fréquences (DFS) pour les dispositifs fonctionnant dans les bandes 5250-5350 MHz, 5470-

5600 MHz et 5650-5725 MHz :

Les instructions suivantes s'appliquent à ce produit:

 A6210

 C6300XB3

 HMNC100

 WAC120

 STS7000

 WAC120

NETGEAR est le respect de SAR pour la population générale / limites d'exposition incontrôlée de CNR-102 et a été

testé en conformité avec les méthodes et procédures de mesure spécifiées dans la norme IEEE 1528.

The table below shows the Recommended Minimum Distance between NETGEAR equipment and household

appliances to reduce interference (in feet and meters).

Japan Notices VCCI

This information in this section applies to products bearing the VCCI mark:

Class A ITE

この装置は、クラス A 情報技術装置です。この装置を家庭環境で使用すると電波妨害を引き起こすことがありま す

Class B ITE

この装置は、クラスB情報技術装置です。この装置は、家庭環境で使用することを目的としていますが、この装置