New Bright Co GF61600RR TOY Receiver User Manual
New Bright Industrial Co Ltd TOY Receiver
User Manual.pdf
BRIGHT Model I Modéle: GF61600RR mill-Ia III/affirm” Snlullght This vehicle is equipped with an Internal Lithium-Ion battery that is recharged via USB. ONIOFF Switch must be In the OFF position prior to charging L Locate the Charging Cord Compartment Cover on the underside of vehicle. 2‘ Use a screwdriver to remove the small screw keeping the cover in place. 3. Remove USB cable from the Storage Compartment (Use care when extending cord as it is attached to inside internal battery). Cord can be plugged into any computer or USB outlet brick (not includedlr 4‘ Insert the USB connector into a computer or other USB power sources 5, while charging, the Charging Status Light under the vehicle will be on. Once fully charged the light will turn off. Charging is completed in approximately 15—2 hours [when charging from a computer). 6. After charging is complete store the the USB cord in the (harging Cord Compartment. Replace the Comparment cover and screw securely back into place. NOTE: This equipmem has been tested and iound to comply with the limits tor a Class B digital device, pursuant to Part is at the FCC Rules. These limits are designed to provide reasonable protection against harmtul Interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and. it not installed and used in accordance with the instructions. may cause harmful intederence to radio communications However. there Is" no guarantee that interference will not occur In a particular installation. It this equipment does cause harmiul interlerence to radio or television reception. which can be determined by turning the equipment oil and on, the user Is encouraged to try to correct the interterence by one or more of the following measures: -- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ' -— Consult the dealer or an experienced radlofi'V technician tor help. ' FCC CAUTION: Changes or modification not ‘ 0 expreuly wowed by the i A party responsible for ’ ~ compliance could void the m user‘s authority to operate the equipment. , m BRIGHT roe mo: RSS Statement This device complies with Industry Canada licence-exempt R55 standard(s), Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference. including interference that may cause undesired operation of the device. Le present appureil est conforms aux CNR d'Industrie Canada applicables aux appareils radio exempts d2 licence. L‘exploitation est autor-isée aux deux conditions suivantes : (1) I'appareil he doit pas produire de brouillage, et‘ (2) l'utilisateur de l'appareil doit accepter dout brouillage radioélectrique subi, mérne si la brcuillage est susceptible d‘en compromettre le functionnentent. .l PROPER USE Precautions and Care RUN INTO HARD OBJECTS CAUTlON! Do not recharge Battery Pack if it is hot or warm to the touch.A|low Battery Pack to cool before recharging. Recharging a hot or warm Battery Pack will shorten the life of the Pack. Do hot recharge a Battery Pack if it appears to be damaged or leaking. Always unplug Adapter and Balance Charger when not in use. ' Always remove Battery Pack from Battery Housing when not in use. Do not. dispose batteries in fire. Leakage, explosion and personal injury may occur. Dispose of Lithium Ion Battery Pack properly. Do not attempt to disassemble Adapter, Balance Charger or Battery Pack. Do "st use Adapter or Balance Charger for any use other than instructed in this booklet. (Fl, an adult should charge Batteries, e l t cmos or tricks with this vehicle. Do r‘ct attei. [.tieshowreesiwon 90% of all difficulties experienced with radio controlled vehicles are due to either weak batteries or batteries that have been installed incorrectly When batteries become weak, the vehicle may not necessarily stop complewy but may exhibit slow response, slow speed or erratic behavior. Problem -Vehicle does not move or moves slowly. Make certain there are lresh alkaline batteries in the transmitter and that they have been installed in the correct position. ~Are the (+) and (—) markings on the alkaline batteries in the same position as the (+) and l-) markings in the Transmitter Battery Compartment? . Has the Battery Pack been installed in the vehicle? . Has the rechargeable Battery Pack been fully charged? Are the (+) and H markings on the Battery Pack in the same position as the (+) and (—) markings in the Battery Compartment? ‘Are the metal contact tabs touching. rusty or dirty in the transmitter? - Make certain that the vehicle ON/OFF switch is in the “ON‘ position. Problem - Vehicle moves by itself or exhibits reduced range from the transmitter. ~ Make certain there is no outside radio interlerence in your area.The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interlerence will occur. )0 not recharge Battery Pack if it is hot or warm to the touch. Allow Battery Pack to cool before recharging. Recharging a hot or warm Battery Pack will shorten the life of the Pack. Do not recharge a Battery Pack it it appears to be damaged or leaking. Always unplug Charger when not in use. Always remove Battery Pack from Battery Compartment when not in use. Do not dispose batteries in tire. Leakage, explosion and personal injury may occur. Dispose of Rechargeable Battery Pack properly )0 not attempt to disassemble Battery Pack or Charger. Do not use Battery Charger for any use other titan instructed in this booklet. Only an adult should charge Batteries. 30 not attempt jumps or tricks with this vehicle.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Creator : Canon iR-ADV C5035 PDF Create Date : 2017:10:10 12:26:02+08:00 Page Count : 4 XMP Toolkit : Adobe XMP Core Creator Tool : Canon iR-ADV C5035 PDF Producer : Adobe PSL 1.1e for Canon Format : application/pdf Document ID : uuid:e44bdc59-0000-001e-8f33-0f6300000000EXIF Metadata provided by EXIF.tools