Nextivity orporated Q34-251266NU Provider-Specific Consumer Signal Booster User Manual
Nextivity Incorporated Provider-Specific Consumer Signal Booster
Contents
- 1. User Manual
- 2. User Manual II
User Manual
PRODUCT INFORMATION
Cel-Fi® QUATRA Networked Smart Booster
If you need help, visit: http://www.celhelp.com
Safety Precautions
• Use Cel-Fi indoors. It should not be
used outdoors.
• These products are designed to
be used with a direct plug-in power
supply unit that shipped with the
Network Unit.. When installing the
equipment, all the requirements of
the manufacturer and the referenced
standards must be met.
• There are no user serviceable parts
inside.
• CAUTION: Changes or modications
to this product not expressly approved
by Nextivity may void your right to
operate the equipment.
Warranty
Nextivity Inc provides a limited warranty for its
products. For details, please refer to http://cel-.
com/warranty.
Limitation of Liability
In no event shall Nextivity, nor its directors,
employees, agents, suppliers or End Users,
be liable under contract, tort, strict liability,
negligence or any other legal or equitable
theory with respect to the Products or any other
subject matter of this Agreement (i) for any lost
prots, cost of procurement of substitute goods
or services, or special, indirect, incidental,
punitive, or consequential damages of any kind
whatsoever or (ii) for any direct damages in
excess of (in the aggregate) the fees actually
received by Nextivity from End User with respect
to the Products actually purchased and paid for.
See cel.com for list of patents covering this
product.
Trademark
Cel-Fi, IntelliBoost, and Nextivity logo are
trademarks of Nextivity, Inc.
FCC Statement (Applicable in the USA only)
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS
DEVICE with your wireless provider and have
your provider’s consent. Most wireless providers
consent to the use of signal boosters. Some
providers may not consent to the use of this
device on their network. If you are unsure, contact
your provider.
You MUST operate this device with approved
antennas and cables as specied by the
manufacturer.
Antennas MUST be installed at least 20 cm (8
inches) from any person.
You MUST cease operating this device
immediately if requested by the FCC or a licensed
wireless service provider.
WARNING. E911 location information may not
be provided or may be inaccurate for calls served
by using this device.
When used with any mobile device utilizing the
1710-1755 MHz band, the FCC limits booster
equipment placement to a maximum of 10
meters above ground level. Installation of this
equipment which does not comply with federal
requirements may subject the owner to FCC
enforcement action.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
If you need help, visit: http://www.celhelp.com
Safety Precautions
• Use Cel-Fi indoors. It should not be
used outdoors.
• These products are designed to
be used with a direct plug-in power
supply unit that shipped with the
Network Unit.. When installing the
equipment, all the requirements of
the manufacturer and the referenced
standards must be met.
• There are no user serviceable parts
inside.
• CAUTION: Changes or modications
to this product not expressly approved
by Nextivity may void your right to
operate the equipment.
Warranty
Nextivity Inc provides a limited warranty for its
products. For details, please refer to http://cel-.
com/warranty.
Limitation of Liability
In no event shall Nextivity, nor its directors,
employees, agents, suppliers or End Users,
be liable under contract, tort, strict liability,
negligence or any other legal or equitable
theory with respect to the Products or any other
subject matter of this Agreement (i) for any lost
prots, cost of procurement of substitute goods
or services, or special, indirect, incidental,
punitive, or consequential damages of any kind
whatsoever or (ii) for any direct damages in
excess of (in the aggregate) the fees actually
received by Nextivity from End User with respect
to the Products actually purchased and paid for.
See cel.com for list of patents covering this
product.
Trademark
Cel-Fi, IntelliBoost, and Nextivity logo are
trademarks of Nextivity, Inc.
FCC Statement (Applicable in the USA only)
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS
DEVICE with your wireless provider and have
your provider’s consent. Most wireless providers
consent to the use of signal boosters. Some
providers may not consent to the use of this
device on their network. If you are unsure, contact
your provider.
You MUST operate this device with approved
antennas and cables as specied by the
manufacturer.
Antennas MUST be installed at least 20 cm (8
inches) from any person.
You MUST cease operating this device
immediately if requested by the FCC or a licensed
wireless service provider.
WARNING. E911 location information may not
be provided or may be inaccurate for calls served
by using this device.
When used with any mobile device utilizing the
1710-1755 MHz band, the FCC limits booster
equipment placement to a maximum of 10
meters above ground level. Installation of this
equipment which does not comply with federal
requirements may subject the owner to FCC
enforcement action.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
STOP!!! Do not call your service provider
until you have read the User Manual.
STOP!!! Do not call your service provider
until you have read the User Manual.
PRODUCT INFORMATION
Cel-Fi® QUATRA Networked Smart Booster
Nextivity Inc Headquarters:
12230 World Trade Drive
Suite 250 San Diego, CA 92128, USA
http://www.nextivityinc.com
Bureau in Europe:
Whitehill Way, Swindon, UK SN5 6QR
Nextivity Inc Headquarters:
12230 World Trade Drive
Suite 250 San Diego, CA 92128, USA
http://www.nextivityinc.com
Bureau in Europe:
Whitehill Way, Swindon, UK SN5 6QR
PI_QUATRA-English_15-0629 PI_QUATRA-English_15-0629
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help
External Antenna (option):
Only use with approved Cel-Fi MIMO Panel
Antenna A52-X12-100.
Industry Canada (IC) Statement
The Manufacturer’s rated output power of this
equipment is for single carrier operation. For
situations when multiple carrier signals are
present, the rating would have to be reduced by
3.5 dB, especially where the output signal is re-
radiated and can cause interference to adjacent
band users. This power reduction is to be by
means of input power or gain reduction and not
by an attenuator at the output of the device.
La puissance de sortie nominale indiquée par
le fabricant pour cet appareil concerne son
fonctionnement avec porteuse unique. Pour
des appareils avec porteuses multiples, on doit
réduire la valeur nominale de 3,5 dB, surtout si
le signal de sortie est retransmis et qu’il peut
causer du brouillage aux utilisateurs de bandes
adjacentes. Une telle réduction doit porter sur la
puissance d’entrée ou sur le gain, et ne doit pas
se faire au moyen d’un atténuateur raccordé à la
sortie du dispositif.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Gain 100dB
Bandwidth 75Mhz
Input and Output
Impedances
50 ohm
Output
Power
Uplink 22dBm per band
Downlink 16dBm per band
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le
fonctionnement.
Compliance Contact
In the event of regulatory compliance issue,
please contact Nextivity Inc. directly. Contact
information is available at www.nextivityinc.com.
Patents
This product is covered by Nextivity, Inc., US
patents and patents pending. Please refer to
CEL-FI.com for details.
Copyright
Copyright © 2016 by Nextivity, Inc. All rights
reserved. Reproduction or media conversion by
any means is protected by copyright and may only
occur with prior written permission of Nextivity.
Designed by Nextivity in California.
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help
External Antenna (option):
Only use with approved Cel-Fi MIMO Panel
Antenna A52-X12-100.
Industry Canada (IC) Statement
The Manufacturer’s rated output power of this
equipment is for single carrier operation. For
situations when multiple carrier signals are
present, the rating would have to be reduced by
3.5 dB, especially where the output signal is re-
radiated and can cause interference to adjacent
band users. This power reduction is to be by
means of input power or gain reduction and not
by an attenuator at the output of the device.
La puissance de sortie nominale indiquée par
le fabricant pour cet appareil concerne son
fonctionnement avec porteuse unique. Pour
des appareils avec porteuses multiples, on doit
réduire la valeur nominale de 3,5 dB, surtout si
le signal de sortie est retransmis et qu’il peut
causer du brouillage aux utilisateurs de bandes
adjacentes. Une telle réduction doit porter sur la
puissance d’entrée ou sur le gain, et ne doit pas
se faire au moyen d’un atténuateur raccordé à la
sortie du dispositif.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Gain 100dB
Bandwidth 75Mhz
Input and Output
Impedances
50 ohm
Output
Power
Uplink 22dBm per band
Downlink 16dBm per band
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le
fonctionnement.
Compliance Contact
In the event of regulatory compliance issue,
please contact Nextivity Inc. directly. Contact
information is available at www.nextivityinc.com.
Patents
This product is covered by Nextivity, Inc., US
patents and patents pending. Please refer to
CEL-FI.com for details.
Copyright
Copyright © 2016 by Nextivity, Inc. All rights
reserved. Reproduction or media conversion by
any means is protected by copyright and may only
occur with prior written permission of Nextivity.
Designed by Nextivity in California.