Ngai Lik Electronics TIB699 Tower Speaker With Bluetooth & PLL FM Stereo Radio User Manual

Download:
Mirror Download [FCC.gov]
Document ID	1721674
Application ID	llP+M2+NRnu8N874zwNzDw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	15.64kB (195479 bits)
Date Submitted	2012-06-13 00:00:00
Date Available	2012-06-13 00:00:00
Creation Date	2012-06-05 09:26:49
Producing Software	Acrobat Distiller 10.0.1 (Windows)
Document Lastmod	2012-06-13 15:03:05
Document Title	Microsoft Word - TIB699CR instruction manual for UL.doc
Document Creator	PScript5.dll Version 5.2.2
Document Author:	a

WARNING
INSTRUCTION MANUAL
TOWER SPEAKER WITH BLUETOOTH
& PLL FM STEREO RADIO
MODEL: TIB699CR
- CAUTION: USE OF ANY CONTROLS, ADJUSTMENTS, OR PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
- CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR
EQUIVALENT TYPE.
- TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR
OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
- WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
- WARNING: THE BATTERIES SHALL NOT BE EXPOSED TO EXCESSIVE HEAT SUCH AS SUNSHINE, FIRE OR THE LIKE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with arrowhead
symbol, within an equilateral
triangle, is intended to alert the user
to the presence of uninsulated
"dangerous voltage" within the
product's enclosure that may be of
sufficient magnitude to constitute
a risk of electric shock to persons.
WARNING: TO REDUCE THE
RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR
BACK).
NO
USERSERVICEABLE PARTS INSIDE.
REFER SERVICING TO
QUALIFIED
SERVICE
PERSONNEL.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important
operating
and
maintenance
(servicing)
instructions in the literature
accompanying the appliance.
IMPORTANT SAFETY INSTRUCTIONS
1)
2)
3)
4)
5)
6)
7)
8)
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that
produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider
than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are
provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.
10) Protect the power cord from being walked on or pinch particularly at plugs, convenience receptacles, and the point where
they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart
is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
S3125A
Please read following instructions prior to operating your unit.
Manufacturer of this unit follows a principle of continuous improvement and has no
responsibility for any changes that are made to the unit nor any liability for these changes.
Thanks for your choice of our products.
13) Unplug this apparatus during lightening storms or when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
15) This appliance shall not be exposed to dripping or splashing water and that no object filled with liquid such as vases shall be
placed on the apparatus.
16) CAUTION: Visible and Invisible Laser Radiation when open and interlock defeated.
DO NOT STARE INTO BEAM.
17) Rating label is located at the back of enclosure.
18) "CAUTION" mark is also located at the back of enclosure.
MAIN UNIT
1. BLUETOOTH INDICATOR
2. POWER BUTTON
3. VOLUME- BUTTON
REMOTE CONTROL
1. SOURCE BUTTON
2. MUTE BUTTON
3. MEM BUTTON
4. CH- BUTTON
5. NUMERIC BUTTONS
6. BASS +/- BUTTONS
7. TREBLE +/- BUTTONS
8. STANDBY BUTTON
9. PAIR/PLAY/PAUSE BUTTON
10. MO/ST BUTTON
11. CH+ BUTTON
12. CLOCK BUTTON
13. SLEEP BUTTON
14. TUNING/SKIP/SEARCH UP/DOWN
BUTTONS
15. VOL +/- BUTTONS
10
11
4. VOLUME+ BUTTON
5. FM TUNING/SKIP/SEARCH
DOWN BUTTON
6. FM TUNING/SKIP/SEARCH UP
3 4 5 6
12
13
BUTTON
10
7. PAIR/PLAY/PAUSE BUTTON
8. SOURCE BUTTON
9. LCD DISPLAY
10. REMOTE SENSOR
14
15
11. AUDIO IN JACKS
12. LINE IN JACK
13. RESET BUTTON
11
14. AC CORD
POWER SUPPLY
Plug AC plug into the outlet socket on the unit for connecting the main power.
SLEEP TIMER SETTING
You can set the sleep timer at power on modes as following instructions:
Press SLEEP button on the remote control repeatedly to cycle through the sleep time
options:
12
13
90 ➨ 80 ➨ 70 ➨ 60 ➨ 50 ➨ 40 ➨ 30 ➨ 20 ➨ 10 ➨ OFF
After the sleep time setting, you can play the unit freely. Once the sleep time is expired, the
unit will be switched off.
During playback, press SLEEP button once to check the remaining sleep time.
HOW TO SET TIME
At the standby mode, press and hold CLOCK button on the remote until Hour flashes on the
screen with "CLK" shows on the screen; use TUNING UP/DOWN button on the remote to
adjust the hour and confirm your adjustment by pressing CLOCK button on the remote;
Minute starts blinking on the screen, press TUNING UP/DOWN button on the remote to set
the minute accordingly, press CLOCK button on the remote again to confirm your setting.
Note: The time only could be set on standby mode.
BLUETOOTH OPERATING
This unit can receive stereo audio signal from a BLUETOOTH stereo audio source device.
1. Power on the unit, switch to BLUETOOTH mode by pressing SOURCE repeatedly.
2. LED indicator rapid blinking while it is pairing.
3. Pair and connect to F-3088 on the BLUETOOTH audio source device. If prompted for
passcode, enter “0000”.
14
4. Pairing successful (LED indicator blue), ready to stream music.
5. During playback, press TUNING UP/DOWN button to skip to the next or previous track.
Press and hold TUNING UP/DOWN button to search through the current track forward or
backward.
Note:
 Pairing mode is canceled about 1.5 minutes.
 The above are generic steps to pair a BLUETOOTH device, for more specific instructions
on BLUETOOTH connectivity for your device, please consult your manufacturer’s
manual.
FM RADIO
TUNING THE FM RADIO
1. Power on the unit, switch to TUNER(RADIO) mode by pressing SOURCE repeatedly.
2. Press TUNING UP/DOWN button to fine tune radio station. Press and hold TUNING
UP/DOWN button to auto search radio station forward or backward respectively (When
an available station will be found, the unit will broadcast it immediately and the searching
will be stopped).
3. At radio mode, it is possible to access the frequency via numeric buttons on the remote
control. For example, press buttons 8, 9 and 8 to get to 89.8 MHz; If access a wrong
frequency, "ERROR" will display on the screen.
4. During radio playback, press MO/ST button on the remote to switch between FM
STEREO and FM MONO modes.
STORING YOUR FAVORITE RADIO STATION
1. During playback, press MEM button on the remote for storing the current station until
memory cell number "P01" flashes on the screen.
2. Use CH+ or CH- button on the remote to select the corresponding memory cell among
P01-P20 for storing the station.
3. Confirm your selection by pressing MEM button on the remote.
4. During radio playback, press CH+ or CH- button on the remote repeatedly to recall the
stored stations.
MUTE THE UNIT
During playback, press MUTE button to switch off the audio. Press the button again to
resume the audio.
CONNECTING WITH OTHER APPLIANCES
AUX IN
1. Connect the Audio jacks on the unit to audio source, for example, DVD player with an
RCA cable.
2. Press the POWER button on the unit or STANDBY button on the remote to turn the unit
on.
3. Press the SOURCE button repeatedly to switch to AUX mode.
4. Use the native controls on the connected audio device to begin playing music through the
connected the unit.
LINE IN
Follow steps to connect the unit to another audio device:
1. Connect the device into the player LINE IN jack with the LINE OUT cables.
2. Press POWER button on the unit or STANDBY button on the remote to turn the unit on.
3. Press SOURCE button repeatedly to switch the unit to Line In mode.
4. Power on the device and begin play.
VOLUME LEVEL/TREBLE/BASS ADJUSTMENT
Press VOLUME +/- button or TREBLE +/- button or BASS +/- button to adjust the volume
output level or treble effect or bass effect.
RESET BUTTON
When using the unit, you will come across some problems that the unit doesn't work or halt
accidentally; you can use a needle or a small, slender implement to poke the RESET button
in the rear of the player, the unit will turn off automatically and then please reboot the unit,
the unit will recover the normal mode.
FCC Warnings
TROUBLE SHOOTING
Symptom
Radio sound distorted.
No radio sound.
Possible Cause
1. The station is not tuned in.
2. There is a poor signal in
the area.
1. The unit is not in tuner
mode.
2. The volume has been
muted or is on the minimum
setting.
Solution
1. Fine tune the station.
2. Reposition the unit.
1. Press SOURCE button
repeatedly until switching to
tuner.
2. Adjust the volume level or
press MUTE button to resume
audio.
IMPORTANT SAFETY INSTRUCTIONS
 The apparatus shall not be exposed to dripping or splashing and that no objects filled with
liquids, such as vases, shall be placed on the apparatus.
 When the mains plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable. To be completely disconnected the
power input, the mains plug of the apparatus or the appliance coupler shall be
disconnected from the mains completely.
 No naked flame sources, such as lighted candles, should be placed on the apparatus.
 Minimum distances 2.0cm around the apparatus for sufficient ventilation. The ventilation
should not be impeded by covering the ventilation openings with items, such as
newspapers, table-cloths, curtains, etc.
 The use of apparatus is in tropical and/or moderate climates.
 Attention should be drawn to the environmental aspects of battery disposal.
 CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.
 Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
 The marking plate is located at the back of the apparatus.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
 Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC RF radiation exposure limits set forth an uncontrolled
environment.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Extract
XMP Toolkit                     : 3.1-702
Producer                        : Acrobat Distiller 10.0.1 (Windows)
Creator Tool                    : PScript5.dll Version 5.2.2
Modify Date                     : 2012:06:13 15:03:05+08:00
Create Date                     : 2012:06:05 09:26:49+08:00
Metadata Date                   : 2012:06:13 15:03:05+08:00
Format                          : application/pdf
Title                           : Microsoft Word - TIB699CR instruction manual for UL.doc
Creator                         : a
Document ID                     : uuid:d903b40a-ec48-4383-8e0f-8fe13e0c97b8
Instance ID                     : uuid:7ae29bb8-2c10-4e07-8c31-0a455f1ba17d
Page Count                      : 4
Author                          : a

EXIF Metadata provided by EXIF.tools