Niles Audio Sps 6 Users Manual DS00098A/SPS
SPS-6 to the manual 382ebd7c-36f8-e994-bdf3-537e851d7ba5
2015-02-02
: Niles-Audio Niles-Audio-Sps-6-Users-Manual-439359 niles-audio-sps-6-users-manual-439359 niles-audio pdf
Open the PDF directly: View PDF 
.
Page Count: 2
| Download | |
| Open PDF In Browser | View PDF |
N I L E S T E C H N I C A L SPS-6 D A T A S H E E T INTRODUCTION The SPS-6 enables you to connect up to six pairs of speakers to your stereo receiver or amplifier and play one pair, any combination of pairs or all pairs at once. Speaker Selection System SPECIFICATIONS Audio Power Handling 100 watts/channel continuous music power Mounting Table-top component Recessed areas for custom room labels Attractive low-profile design SPS-6 SPEAKER SELECTION SYSTEM PROTECTION Frequency Response +0 dB, -0 dB (flat) from 20 Hz to 20 kHz Wiring Requirements Individual runs of 2-conductor speaker wire. Connectors accommodate wire sizes 14-22 gauge. 16 gauge recommended 1 3 AMPLIFIER + 4 5 SPEAKER 6 + + - - SPEAKER 5 Protection switch safeguards your receiver or amplifier even with all 6 pairs of speakers playing SPEAKER 4 + + - - NILES 6 Connect up to six pairs of speakers Simple push-button operation Overall Dimensions 11-1/4" wide x 2" high x 6-3/4" deep Weight 2-1/4 lb. 2 SPEAKER 3 SPEAKER 2 + + - - SPEAKER 1 + NILES - Niles Audio Corporation, Inc. Miami, Florida USA L R L R L R L R L R L R L R H I G H Spring-loaded push connectors FEATURES & BENEFITS • Pre-printed Room Labels are included for easy identification of speaker ON/OFF buttons. • Isolated left and right channel ground returns make the SPS-6 compatible with all types of amplifiers. • May be used with 4, 6 or 8 ohm speaker systems. • Self-cleaning, silver-plated switch contacts assure years of trouble free use. • 100% tested, electronically and acoustically, for frequency response, distortion and power handling. • Protection circuit safeguards your receiver or amplifier. • Spring-loaded push terminal connectors accommodate up to 14 gauge wire or "pins", making the SPS-6 compatible with most high definition speaker cables. • Ten year parts and labor warranty. B L E N D I N G A N D A F I D E L I T Y R C H I T E C T U R E ® CONTINUED OTHER SIDE ➯ MODEL SPS-6 Speaker Selection System (continued) APPLICATION NOTES Connections Connections If your amplifier or receiver has "A" and "B" speaker pair outputs, connect the SPS-6 to the "A" points. Do not connect anything to "B". This will prevent the amplifier or receiver from driving an unusually low impedance load. Using the SPS-6 with Tube Type Amplifiers Virtually all tube amplifiers must have a load connected at all times. If the amplifier to be connected to the SPS-6 is a tube amplifier, be sure to always have at least one pair of speakers switched on at all times. An alternative is to permanently connect a 150 ohm, 5 watt resistor across the tube amplifier's output in parallel with the SPS-6. TUNER 94.9 Receiver 15 AMPLIFIER SPEAKER 6 + + + - - SPEAKER 5 SPEAKER 4 + + - - SPEAKER 3 SPEAKER 2 + + - - SPEAKER 1 + NILES - Niles Audio Corporation, Inc. Miami, Florida USA L R L R L R L R L - R L R L R Speaker Pairs Protecting a Tube Amplifier Impedance Matching Tube Amplifier You will need to activate the SPS-6's PROTECTION button whenever the overall system impedance might fall below 4 ohms. 150 150 150 ohm, 5 watt Resistors AMPLIFIER + SPEAKER 6 + + - - SPEAKER 5 SPEAKER 4 + + - - SPEAKER 3 SPEAKER 2 + + - - SPEAKER 1 + NILES - Niles Audio Corporation, Inc. Miami, Florida USA L R L R L R L R L R L R L R TOOLS REQUIRED When playing the following speakers: The Protection button should be: 1 or 2 pair of 8-ohm speakers OFF • 1/8" Standard Slotted Screwdriver 3 or more pairs of 8-ohm speakers ON 1 pair of 4-ohm speaker OFF • Wire Stripper 2, or more pairs of 4-ohm speakers ON Any combination of 4 and 8 ohm speakers ON CEDIA NILES AUDIO CORPORATION 12331 S.W. 130 STREET MIAMI, FLORIDA 33186 TEL: (305) 238-4373 FAX: (305) 238-0185 INTERNET: www.nilesaudio.com ©1999 Niles Audio Corporation. Niles, the Niles logo and Blending High Fidelity and Architecture are registered trademarks of Niles Audio Corporation. Printed in USA DS00098A CUSTOM ELECTRONIC DESIGN & INSTALLATION ASSOCIATION CHARTER MEMBER
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.2 Linearized : Yes Create Date : 1999:02:17 15:08:21 Producer : Acrobat Distiller 3.01 for Power Macintosh Author : TAG Creator : QuarkXPressª: LaserWriter 8 8.4 Title : DS00098A/SPS-6 Modify Date : 1999:03:08 15:27:32 Page Count : 2EXIF Metadata provided by EXIF.tools