Ningbo Polinata Electronics M-5500 Speaker Box User Manual Manual

Ningbo Polinata Electronics Co., Ltd. Speaker Box Manual

Manual

M-5500INSTRUCTION MANUAL
14500 W82x152x15
1.MP3 level control2.MIC input level control3.Line input level control4.Volume control5.Treble control for high frequencies6.Bass control for low frequencies7.USB input8.LCD screen & Mp3 control9.MP3 ON/OFF10.XLR microphone input11.6.35mm microphone input12.RCA phone(R+L) line input13.XLR line input14.6.35mm line output15.XLR line output16.Clip LED indicator17.Power LED indicator18.Speaker out 8 Ohm19.Main power switch20.Fused IEC mains inlet21.SD card input22.MODE:USB/SD/BT/FM convertor :Play / Pause SCAN:Long press to auto search under FM radio :Repeat one / Repeat all / Random :PRE/NEXT under FM mode Long hold to search lower/ higher station manually :Short press to tune to saved station :Previous Song Long press for fast rewind :Next Song Long press for fast forward23.LED Light Switch(ON/OFF)24.115/230V SwitchMP3 L EVE LMIC L EVE LLIN E LEV ELVOL UMETRE BLEBAS SMP3 DIGI TAL DIS PLAY WITH REM OTE CONTR OL MICINPUT LIN EINPUTLIN EOUTSPEAKE R OUT8 ΩAC 115V/230V 60/50HzONOFFCLIP POWERUSBSD16 1718192021221591011121314MODE SCA N OFF ONLED115V 230V2423
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Navigation menu