Ningbo Polinata Electronics XS-500 Speaker Box User Manual Manual

Ningbo Polinata Electronics Co., Ltd. Speaker Box Manual

Manual

XS-1000MKⅡINSTRUCTION MANUAL
12000 W8115/230V~60/50Hz.
18192221POWERONOFFMP3 CONTROL DIGITAL DISPLAYMICINPUTAUXR LLINEINPUTLINEOUTPUTMP3 LEVELMIC LEVELBASS-12 +12POWERLINE LEVELVOLUMETREBLE-12 +12SPEA KE R OUT8ΩMIN MAXMIN MAXMIN MAXMIN MAXAC 115/230V 60/50HzUSBSDSCAN115V 23 0V1. LCD screen2. MP3 control MODE:USB/SD/BT/FM convertor :Play / Pause SCAN:Long press to auto search under FM radio :Repeat one / Repeat all / Random :PRE/NEXT under FM mode Long hold to search lower/ higher station manually :Short press to tune to saved station :Previous Song Long press for fast rewind :Next Song Long press for fast forward3.SD card input4.USB input5.MP3 input level control6.Mic input level control7.Line input level control8.Master Volume control9.Treble control for high frequencies10.Bass control for low frequencies11.XLR microphone input12.6.35mm microphone input13.3.5mm line input14.RCA phone (R+L) line inputs15.XLR line input16. 6.35mm line output17. Speaker out 8 Ohm18.Clip LED indicator19.Power LED indicator 20.115V/230V Switch21.Main power switch22.Fused IEC mains inlet23.LED Light Switch(ON/OFF)OFF ONLED23
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Navigation menu