Nolangroup S p A NCOM10 Bluetooth hands-free kit User Manual Statement
Nolangroup S.p.A. Bluetooth hands-free kit Statement
Contents
Statement
Firmware Version: 1.00
EN
USER INSTRUCTIONS AND SAFETY
Congratulations on your purchase of an N-Com product.
N-Com BX5 was made using the most advanced technologies and the best
materials. Long-running tests and thorough system development have allowed the
highest audio quality to be achieved.
For additional information about BX5, and to download high-definition instructions
as well as the latest
Firmware
version, visit the website www.n-com.it
REFERENCE STANDARDS
The products of the N-Com line are in compliance with standards as per the table
below:
BX5
The Bluetooth system complies with the main safety requirements
and other applicable provisions of Directive 99/5/CE, Directive
2009/65/EC, Directive 2011/65/CE, Directive 2012/19/EU
Battery
charger
Directive 2006/95, 2004/108, 2009/65/EC, 2011/65/CE, 2012/19/EU,
2009/125/CE
Battery Directive 2006/66/CE
The Declarations of Compliance can be downloaded from the website www.n-
com.it (Download section).
FccID: Y6MNCOM10 N21550
Bluetooth is a registered trademark property of Bluetooth SIG, Inc.
FOR USA AND CANADA MARKET ONLY: SPECIAL WARNING
This device complies with part 15 of the FCC and Industry Canada Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user’s authority to operate the
equipment.
This product has been tested and complies with the specifications for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used according to the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which is found by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment or devices
Connect the equipment to an outlet other than the receiver’s
Consult a dealer or an experienced radio/TV technician for assistance
This model meets the government’s requirements for exposure to radio waves. Your wireless device is a
radio transmitter and receiver. It is designed and manufactured not to exceed limits for exposure to
radio frequency (RF) energy set by the Federal Communications Commission (FCC) of the U.S.
Government and by the Canadian regulatory authorities.
The exposure standard for wireless mobile devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC and by the Canadian regulatory authorities is 1.6
W/kg.1 Tests for SAR are conducted using standard operating positions accepted by the FCC and by
Industry Canada with the device transmitting at its highest certified power level in all tested frequency
bands.
The highest SAR value for this model device when tested for use at the ear is 0.099 W/kg.
For Canada market only: This EUT is compliant with SAR for general population/uncontrolled exposure
limits in IC RSS-102 and had been tested in accordance with the measurement methods and
procedures specified in IEEE 1528.
FccID: Y6MNCOM10 21550
Bluetooth is a registered trademark property of Bluetooth SIG, Inc.